After wildfire: hazard trees in Victoria and the US, what the agencies publish
WorkSafe Victoria warns that fire-damaged trees can fall without warning and sets an exclusion area of at least one tree length around a suspect unmarked tree. The Victorian emergency services procedure uses two tree lengths. Oregon and the USFS publish their own post-fire tree guidance.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
The named codes and training bodies are described here as published. It is not training and does not teach the work. Several of the documents below were written for emergency crews or for one fire season. A fire-damaged tree is judged on site by the qualified people the documents name.
WorkSafe Victoria safety alert
WorkSafe Victoria issued the alert "Contractors working in the vicinity of fire-damaged trees" on 4 February 2020, during the 2019 to 2020 bushfire recovery. It states that trees may be unstable from heat and fire and can fall without warning. Fallen branches can be hooked up or tangled in other limbs and dislodged by wind, machinery or fire.
The alert lists controls for employers and self-employed people.
- No work where unsafe trees and branches are on or near the worksite. Felling or trimming of unsafe trees only by people with suitable skills and experience.
- Trees marked with a "K", an "X" or a yellow dot left to a suitably trained person, such as the state environment department or a trained arborist, before work starts. A "K" marks a killer tree likely to fall. An "X" or yellow dot marks a tree that does not look hazardous but may become so if it catches alight or is hit by wind or other disturbance.
- An exclusion zone in place before work where marked trees cannot be managed.
- Unmarked trees that look hazardous, such as burnt trees or trees with split trunks, assessed by a qualified or experienced person such as an arborist.
- A visible exclusion area of at least one tree length around a suspect unmarked tree, taped or flagged.
- Plant and vehicles kept more than one tree length from an unmarked fire-damaged tree, because movement or vibration can weaken it.
- Daily inspection of worksites, helmets worn, and working alone avoided or minimised.
The alert cites the Occupational Health and Safety Act 2004: employers provide a safe working environment and the information, instruction, training and supervision to work safely, so far as is reasonably practicable.
Victorian emergency services procedure
Joint Standard Operating Procedure J08.03, Tree Hazard, Fire, version 6.0, took effect on 1 November 2024. It applies to the CFA, DEECA (FFMVic), FRV and VICSES and to contractors on bushfire response and planned burning. It is due for review in November 2027. The procedure sets six steps from identifying tree hazard to completing operations. It names three types of tree.
- A clear and present danger tree is one expected to fall within the time frame of current operations and strike people in its impact zone.
- A hazardous tree may fall in part or whole but is not considered likely to during that operation.
- A potential clear and present danger tree may become one if it catches alight or is hit by wind. It is a circle tree if protection is assured and a slash tree if not.
Only appropriately qualified or agency-endorsed personnel carry out hazard tree assessment. Schedule 1 recognises a qualified tree faller or arborist with a wildfire awareness or incident safety unit that includes tree hazard awareness, or the agency's own assessor course. Marks are yellow spray paint on two sides of the tree, more than 30 cm tall: a circle, a circle with a slash, and a circle with a cross. A cross tree gets an exclusion zone.
Treatment follows a hierarchy: eliminate, substitute, isolate. Felling is the preferred way to eliminate, using machinery with safety guarding where possible. Hand falling is to be avoided unless both necessary and safe, and only by qualified or endorsed people. Exclusion zones are usually at least two tree lengths around a hazard tree, and larger or in rare cases smaller depending on slope and other site factors. The WorkSafe alert and the procedure therefore give different distances: one tree length for a suspect tree on a contractor's worksite, two tree lengths in the procedure.
Victorian fact sheet for landholders
The Victorian government fact sheet on hazardous trees after the 2019 to 2020 bushfires, dated May 2020, lists the traits of a hazardous tree. They are dead or decaying wood, suspected loose or broken branches, significant lean with a recent cause, longitudinal cracking, lifting roots or a disturbed root system, and other signs of serious weakness. The sheet puts hazardous trees on public land and public roads with the state environment department and road managers, and trees on a private property with the owner.
It also states that a planning permit is not required to remove native vegetation that presents an immediate risk of personal injury or property damage. The risk is immediate only when it can be managed solely by removal within a shorter time than a permit would take. The sheet adds that the exemption should not be relied on where other means exist.
Oregon and the US Forest Service
The Oregon Department of Forestry fact sheet of November 2025 separates two questions. Its mortality marking guides estimate which fire-injured trees will die, for salvage and sanitation work, and it says they should not be used in place of hazard tree marking guides. ODF notes that bark beetles and woodborers usually move first into fire-damaged trees and may keep attacking for two to four years.
The USFS Pacific Southwest Region lists hazard tree work within its Forest Health Protection program: guidance on identifying and assessing hazard trees in developed recreation areas and along National Forest roads, training and train-the-trainer sessions, and database support.
Sources
- WorkSafe Victoria, Contractors working in the vicinity of fire-damaged trees, safety alert of February 4, 2020, read October 16, 2026
- Emergency Management Victoria, Joint Standard Operating Procedure J08.03 Tree Hazard Fire, version 6.0, effective November 1, 2024, read October 16, 2026
- Victorian Government, Hazardous Trees fact sheet, bushfire recovery, May 2020, read October 16, 2026
- Oregon Department of Forestry, Forest Health Fact Sheet on post-fire tree mortality, November 2025, read October 16, 2026
- USDA Forest Service Pacific Southwest Region, Hazard Trees, read October 16, 2026