Anchor slings, friction savers and cambium savers: what the codes and the ICoP say
Codes call what sits at the climber's anchor by several names: temporary anchor device, anchor sling, friction saver, cambium saver, false crotch. The sources are the UK industry code, SafeWork NSW, WorkSafe New Zealand and two BSI listings.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The words are defined in the glossary of climbing words. Slings used for rigging are covered in rigging slings and ropes. Only the climber's anchor side is covered here, and how to set up an anchor is not described.
The words each document uses
| Source | Its words |
|---|---|
| Industry Code of Practice for Arboriculture, Edition 2 (May 2020), clause 3.10.6.2 | Temporary anchor devices: components that give an artificial, temporary anchor point instead of the natural structure of the tree. The typical examples it names are tape slings and cambium or pulley savers. Artificial anchors: machinery and vehicles used as an effective anchor, for example a basal tie-off for single rope technique. |
| SafeWork NSW Tree works code, March 2026, clause 4.3 | Friction saver and anchor sling, in the text on junctions. |
| WorkSafe NZ arboriculture code, definitions and 3.2.5 | Friction saver, defined as meaning cambium saver. False crotch: a system that holds up an arborist line where there is no natural crotch. Micro pulley: a small lightweight pulley. |
| WorkSafe NZ arboriculture code, definition of cambium saver | A device used to protect the bark, cambium and climber's line from damage caused by friction. A cambium saver used as part of a climbing system must meet the minimum breaking strength of 22 kN. |
What each code requires
ICoP, 3.10.6.2
For temporary anchor devices the ICoP requires four things. The equipment is made to the standard for temporary anchors. The anchors are set up so they cannot slip up or down the stem. Any connector used is set up to prevent minor axis or cross-loading and inadvertent opening or release of the rope or system. The anchor has a minimum breaking strength of at least 18 kN. For artificial anchors it asks for enough mass to be an unquestionably reliable anchor, enough frictional resistance to the ground, no damage caused to the anchor by anchoring, and no movement of the anchor during use.
For slings and strops, clause 3.10.6.13 says three things. The mode of connection prevents unintentional or uncontrolled movement or inadvertent release. The safe working load is known when the sling is configured for use. The application does not conflict with the material: for example, high modulus fibres may give greater strength to weight but be less abrasion-resistant.
SafeWork NSW, 4.3
The code says anchor points are carefully assessed. For natural anchor points, junctions should be at a sufficient angle, or captive, so the climbing rope does not walk out toward the branch tip. A friction saver or anchor sling should be used against friction and rope walking. Where a branch junction is small or the anchor is of reduced strength, climbers should take the rope or lanyard round the upright stem or the bigger of two stems. Some stems are too small to use as anchor points. Where a tree has no suitable natural anchor, alternative access methods or artificial anchor points are used, with palms given as an example. The roping system and the climbing rope should not cross or overlap, because friction can cause rapid failure of the climbing rope through heat.
WorkSafe New Zealand
The definitions describe a false crotch used to support an arborist climbing line as incorporating rings or a pulley that will protect the system and the line from damage or failure. Each component of the system is rated to a minimum of 22 kN. Clause 3.2.5 says climbers are aware of how a friction hitch will perform in combination with other components, for example a micro-pulley or cambium saver.
Standards named
| Standard | What BSI lists |
|---|---|
| BS EN 795:2012 | Personal fall protection equipment: anchor devices. BSI lists its status as under review, published August 31, 2012. The scope is single-user anchor devices intended to be removable from the structure. BSI says it does not apply to anchor devices for more than one user at a time, to sport or recreational use, or to structural parts installed for another purpose such as beams. It replaced the 1996 edition, and the classes A, B, C became types. |
| BS EN 566:2017 | Mountaineering equipment: slings, safety requirements and test methods. BSI lists its status as under review, published March 31, 2017. BSI says it covers slings used for mountaineering including climbing, and that its text is based on the former UIAA standard J. |
Gaps in the sources
None of the documents lists ring-on-ring systems, adjustable slings or sizes of sling. No figure is set for friction saver rings beyond the 22 kN of the New Zealand false crotch definition and the 18 kN of the ICoP for a temporary anchor device. A 2007 paper in Arboriculture & Urban Forestry by Brian C. Kane tested 12 ropes on three ring materials and found surface roughness the best predictor of friction.
Credit: parts of this page are adapted from SafeWork NSW material under the licence CC BY 4.0 and from WorkSafe New Zealand material.
Sources
- Arboricultural Association, Industry Code of Practice for Arboriculture: Tree Work at Height, Edition 2, May 2020, read October 9, 2026
- WorkSafe New Zealand, Safety and health in arboriculture approved code of practice, read October 9, 2026
- SafeWork NSW, Tree works code of practice, March 2026, read October 9, 2026
- BSI Knowledge, BS EN 795:2012 anchor devices, read October 9, 2026
- BSI Knowledge, BS EN 566:2017 mountaineering slings, read October 9, 2026
- WorkSafe New Zealand, Safety and health in arboriculture approved code of practice, document download, read October 19, 2026
- Kane, Friction Coefficients for Arborist Ropes Passing Through Cambium Saver Rings, Arboriculture & Urban Forestry 33(1), January 2007, read October 19, 2026