ArbNation Join free

ANSI A300 Part 3, Supplemental Support Systems: what it covers

Part 3 covers installing and maintaining tree support systems: cabling, bracing and guying. The 2023 single-volume book carries it as Clause 7.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The full clause list is in the A300 clauses by title.

Scope and topics

The Tree Care Industry Association (TCIA) page for Part 3 states that Part 3 applies to installation and maintenance of tree support systems, including cabling, bracing and guying. It lists the subjects the part addresses.

  • Tools and equipment
  • Cabling objectives and types of cabling systems
  • Bracing objectives, dead-end bracing and through-bracing
  • Guying established trees and newly transplanted trees
  • Tree-to-ground and tree-to-tree guying
  • Propping trees and branches
  • Hardware sizing and selection tables

TCIA names four basic cabling methods: direct, triangular, box, and hub and spoke. TCIA also says supplemental support systems need periodic inspections by an arborist, with scheduling the tree owner's responsibility. It adds that these systems give additional support or limit movement and do not provide primary support to a tree.

Where Part 3 sits

The ISA store lists the ANSI A300 Tree Care Standards (2023) as ten parts in one volume, with Supplemental Support Systems as Clause 7. ISA also sells a Best Management Practices title, Tree Support Systems: Cabling, Bracing and Guying, listed as a Third Edition. TCIA's magazine traces the standards to National Park Service practices of the 1930s for pruning, fertilization, cabling and bracing, and lightning protection. By 2002 these had grown into the first four parts of A300, and in 2023 all ten parts were combined.

Purpose of the systems, from Purdue Extension

Purdue Extension bulletin FNR-550-W, Large Tree Cabling and Bracing, describes cabling, bracing, guying and props as ways to limit the movement of branches or leaders. It calls cables and brace rods supplemental structural supports intended to reduce the risk of failure of weak stems, branch unions and multiple leaders. Purdue stresses that not all risk can be mitigated and not all trees can be reinforced.

The bulletin separates the hardware. A cabling system uses flexible, extra-high-strength steel strand cables attached to bolts installed in the upper crown. Dynamic cabling uses a synthetic rope attached without invasive drilling. Braces are threaded rods installed through unions of weak branches and multiple stems. Purdue lists ground inspections annually for loose hardware, and an inspection by an arborist who ascends the tree usually every three years. It also asks whether the owner is prepared to have the system replaced after 7 to 10 years.

Sources