AS 2303:2018, tree stock for landscape use: what the criteria are
AS 2303:2018 is the Australian standard for judging nursery tree stock before it leaves the nursery. Its tests cover above-ground form, a size index for root-to-shoot balance, and the root ball.
Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The standard itself is sold by Standards Australia and its text is not reproduced here.
Where the standard came from
Hort Innovation's project NY15001, delivered by Western Sydney University, measured root-to-shoot balance in landscape trees. It covered more than 13,800 trees from 23 nurseries across Australia. The trees varied in size index far more than the earlier standard, AS 2303:2015, allowed for. Hort Innovation notes that buyers may therefore have been rejecting trees that were fit for purpose.
The findings went into a submission to revise AS 2303:2015, which Standards Australia accepted. AS 2303:2018 was released in December 2018. An industry engagement program followed, with a national roadshow and grower guidelines.
What the standard is for
Standards Australia's case study describes AS 2303:2018, Tree stock for landscape use, as setting out the preferred requirements for trees used in landscapes. Its stated purpose is to simplify the choice of tree stock and to describe the preferred above-ground and below-ground characteristics of good stock.
The case study stresses that faults present at planting can have a large effect on a tree's life span and the resources needed to establish it. The standard covers only the quality of the stock, not the wider landscaping process. Standards Australia gives two benefits. Faults are meant to be caught at dispatch, which lowers later maintenance costs, and a tree that establishes without fault is likely to mean less wastage.
The testing process
Western Sydney University's card, "Testing process for the AS 2303:2018 standard", sets out the steps. The tree stock is placed on a firm surface with its container left on, and any stakes or supports are removed. The card calls itself a broad guide drawn from the standard and points to the standard for the full measurements.
| Stage | What is assessed |
|---|---|
| 1. Above ground | Tree height, calliper, crown density, cover and form, stem dimensions and trunk position. Also the health of the stock, absence of injuries, active pests and diseases, adequate formative pruning and compatible graft unions. |
| 2. Balance and root ball | The size index, which is stem height in metres multiplied by calliper in millimetres. The value must fall between the 25th and 75th percentile for the container size. The root ball diameter, depth and the height of the root crown are also assessed, along with absence of suckering rootstock and active pests or diseases. |
| 3. Below ground | A root ball that is fully occupied, roots growing in the correct direction, and no girdled, kinked or circling roots. |
| 4. Bare-rooted stock | Root ball diameter measurements, with roots growing in the correct direction and free of J-roots, woody circling roots, kinked roots and girdled roots. |
Size index by container volume
The card lists the 2018 size index percentiles for each nominal container volume. The research behind the standard widened the preferred range of sizes. The card prints more container sizes than shown here, and also 5th and 95th percentile columns.
| Nominal container volume | 25th percentile | 50th percentile | 75th percentile |
|---|---|---|---|
| 18 L | 17 | 25 | 36 |
| 25 L | 23 | 33 | 47 |
| 50 L | 42 | 59 | 82 |
| 100 L | 77 | 107 | 142 |
| 200 L | 142 | 193 | 247 |
| 500 L | 318 | 420 | 512 |
| 1000 L | 585 | 756 | 891 |
Western Sydney University also offers the TreeStocker app, which checks whether the size index of a given tree falls in the specified range.
Sources
- Hort Innovation, Evaluation of nursery tree stock balance parameters (NY15001), final report published December 11, 2018, read October 15, 2026
- Standards Australia, Agriculture, Forestry and Fishing: Growing the Right Way, case study on AS 2303:2018, read October 15, 2026
- Western Sydney University, Hawkesbury Institute for the Environment, Testing process for the AS 2303:2018 standard (tree stock standard summary card), read October 15, 2026