Canadian provincial OHS tree-work rules: Alberta Part 39 and Quebec Division XXVI.III compared
Alberta's Part 39 covers tree work where a worker depends on the tree for support and runs to five sections. Quebec's Division XXVI.III covers all arboriculture work in 19 sections, with a qualification certificate.
Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. Alberta and Quebec each have a tree-work part inside a general occupational health and safety rule.
Alberta: Part 39, Tree Care Operations
Alberta's Occupational Health and Safety Code (Alberta Regulation 191/2021, current as of March 31, 2025) lists Part 39, Tree Care Operations, as sections 792 to 796. Section 792 applies the Part to arboriculture activities that involve pruning, repairing, maintaining or removing trees or cutting brush, if a worker works at height and depends on the tree for support.
Section 793(1) requires an employer to develop and implement safe work practices and procedures that include five items:
- the assessment of hazards at the work site
- worker training, including hazard recognition
- the selection, limitation, operation and maintenance of equipment and personal protective equipment
- the use of work positioning systems and fall protection systems
- emergency rescue
Section 793(2) adds that the employer must involve affected workers, if reasonably practicable. Section 794 requires a worker to use a work positioning system when it is not reasonably practicable to meet the fall protection requirements of section 139.
Section 795(1) sets the harness standards for a harness used in a work positioning system and manufactured on or after March 31, 2023. It lists five: NFPA 1983 (2006 edition) as a Class II or III life safety harness, EN 813:1997 sit harnesses, CSA Z259.10-18 full body harnesses, ANSI/ASSE Z359.1-2007 and EN 361:2007 full body harnesses. Harnesses in use before April 30, 2004 are exempt. Section 796 exempts these activities from section 150.3.
The archived 2009 Explanation Guide to the Code uses "work at height" as Part 9 does: a worker may fall 3 metres or more, or a worker falling a lesser distance faces an unusual risk of injury. The guide says Part 39 applies where the worker depends on the tree for support, and that work from a work platform or similar equipment must meet Part 9. Other Code requirements reach tree work too: connecting components, life safety rope, overhead power lines, protective headwear and chain saw pants. On section 150.3, the guide explains that the Code limits sliding hitch knots such as the Prusik to competent rescue or emergency services personnel, and that tree care work is exempt because it relies on ropes and knots.
Alberta: power lines in Part 17
Section 225 of the Code applies before work is done or equipment is operated within 7 metres of an overhead power line. The employer must determine the voltage and set the safe limit of approach distance from Schedule 4, Table 1. Work inside that distance needs notice to the line operator and the operator's help in protecting workers. Section 227 exempts utility workers who work to CAN/ULC-S801-14.
| Operating voltage between conductors | Distance for persons and equipment |
|---|---|
| 0 to 750 volts, insulated or polyethylene covered | 300 millimetres |
| 0 to 750 volts, bare, uninsulated | 1.0 metre |
| Above 750 volts, insulated conductors | 1.0 metre |
| 750 volts to 40 kilovolts | 3.0 metres |
| 69 and 72 kilovolts | 3.5 metres |
| 138 and 144 kilovolts | 4.0 metres |
| 230 and 260 kilovolts | 5.0 metres |
| 500 kilovolts | 7.0 metres |
Quebec: Division XXVI.III, Arboriculture work
Quebec's Regulation respecting occupational health and safety carries Division XXVI.III, Arboriculture work, as sections 312.101 to 312.119, added by Order in Council 821-2023. The Division defines arboriculture work as manual work. It covers vegetation management on the rights of way of power distribution systems or telecommunications networks, pruning, non-forest trimming of trees, non-forest felling of predetermined trees, grubbing, non-forest chipping, tree and shrub surgery, and guying. The Division does not apply to nursery work or horticulture work.
Under section 312.103, an employer may not have a worker do arboriculture work unless the worker holds a certificate of qualification in arboriculture of the appropriate class, or a valid apprentice qualification. The requirement takes effect from 8 June 2026 under Order in Council 647-2025.
Section 312.104 requires a meeting on the work site before work starts, led by a person with a valid certificate who stays on site. Under section 312.105, the work area must be marked off with cones, tape or other means that keep the public out. Section 312.106 requires a tested rescue procedure for any worker at height.
The Division's personal protective equipment sections name standards by number.
| Section | Equipment and standards named |
|---|---|
| 312.108, every worker in the work area | A hard hat with a permanent chin strap to CSA Z94.1, ANSI/ISEA Z89.1 or EN 397. Eye protection to CSA Z94.3, ANSI/ISEA Z87.1 or EN 166. Footwear to CSA Z195 or EN ISO 20345. A Class 1 high-visibility garment to CSA Z96 without suspenders. Gloves adapted to the work. |
| 312.109, chain saw use | Footwear to CSA Z195 or ISO 17249. Pants to ISO 11393-2, or to category A, C or D of ASTM F3325. |
| 312.110, work near a power line | Electric-shock resistant footwear to CSA Z195. A hat to class E of ANSI/ISEA Z89.1, or CSA Z94.1. Fire-resistant upper body clothing to CAN/ULC S801. A Class 2 high-visibility garment to CSA Z96. Non-conducting eye protection to CSA Z94.3. |
| 312.111, stump grinder | A polycarbonate face shield to CSA Z94.3. |
| 312.112, full body harness | Required in a tree, on a portable ladder or in a basket. The harness must meet CSA Z259.10, ANSI/ASSP Z359.11 or NF EN 361. For work in a tree, a sit harness to NF EN 813 also qualifies. |
Sections 312.114 and 312.115 set out the tree anchorage point: the axil of a healthy division, or a constriction around a healthy main axis at least 10 cm across. The fork must be "U"-shaped and free of included bark, and the main axis near the anchor must approach vertical and be at least 10 cm in diameter. With the anchor around the trunk, the branch forming the division must be at least 5 cm across. With the anchor around a branch, that branch must be at least 10 cm across. The anchor must sit at a height that lets these features be checked from the ground, and it is installed to limit pendular movement and tested mechanically from the ground.
The earlier draft, published in the Gazette officielle du Quebec on 9 March 2022, described the fork as "V" shaped, and gave the angle between branch and trunk as 30 to 85 degrees. The draft notice put the economic impact on affected firms at CA$1.842 million in the first year and CA$1.342 million a year in the years after.
Quebec: work near a power line
The Division defines work near a power line as work during which a branch, log, tool, equipment, machine or person might come within 3 m of a line of more than 750 V but less than 125,000 V. Under section 312.116, no one may start such work without written authorization from the electrical power company that operates the line. Section 312.117 allows only people with the training the company requires to do the work. Section 312.118 requires equipment likely to be used within the approach distance to meet ASTM F711, and insulated aerial arms to meet CSA C225. Section 312.119 requires an inspection of an aerial basket device at least once a year, with a dated label.
Sources
- Alberta King's Printer, Occupational Health and Safety Code (Alberta Regulation 191/2021), current as of March 31, 2025, Parts 17, 18, 39 and Schedule 4, read October 15, 2026
- Government of Alberta, Occupational Health and Safety Code page, read October 15, 2026
- Government of Alberta, Open Government, Occupational Health and Safety Code 2009 Explanation Guide, Part 39 Tree Care Operations (archived), read October 15, 2026
- Gouvernement du Quebec, Legis Quebec, Regulation respecting occupational health and safety (S-2.1, r. 13), Division XXVI.III Arboriculture work, read October 15, 2026
- Gazette officielle du Quebec, draft Regulation amending the Regulation respecting occupational health and safety, 9 March 2022, read October 15, 2026