ArbNation Join free

Chainsaw safety features by standard: chain brake, throttle lock, catcher and guards

OSHA 1910.266 requires a chain brake and ANSI B175.1-1991 on newer logging saws, plus a throttle that stops the chain on release. HSE names the chain catcher and hand guards, and ISO 11681-1 sets safety requirements for forest-service saws.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. Regulators name saw design features, and the saw design standards have their own published scope.

Features by who names them

Chainsaw design features named by regulators
FeatureOSHA 1910.266 and NC LaborHSE INDG317
Chain brakeA chain saw placed into initial service after the rule's effective date has a chain brake and meets ANSI B175.1-1991. The tool inspection covers chain brakes and nose shielding devicesCombined chain brake and front hand guard shown on the saw; chain brake in the list of daily checks
Kickback deviceA saw placed in service before that date carries a protective device that minimises kickback. No kickback device is removed or disabledChain with low-kickback characteristics; a properly maintained brake and a low-kickback chain reduce kickback but cannot entirely prevent it
ThrottleA gasoline-powered saw has a continuous pressure throttle control that stops the chain when pressure is releasedThrottle trigger lockout; the throttle cannot be squeezed unless the lock-out is pressed
Chain catcherNot named in the pages openedShown on the saw and listed in daily checks
Hand guardsHandles and guards are checked as sound and in placeSide plate, front and rear hand guards; rear chain breakage guard
Anti-vibration mounts and on/off switchNot namedBoth shown on the saw and listed in daily checks

United States

OSHA's logging standard, 29 CFR 1910.266, covers chain saws in its section on hand and portable powered tools. A saw placed into initial service after the effective date has a chain brake and otherwise meets ANSI B175.1-1991, Safety Requirements for Gasoline-Powered Chain Saws. A saw in service before that date has a protective device that minimises kickback.

North Carolina Department of Labor repeats the rule on its chain saw safety page. Saws must have a chain brake and meet ANSI B175.1-1991. Compliance with the ANSI standard can be checked from the manufacturer's label and the Underwriters Laboratory label on the saw.

United Kingdom

HSE's leaflet Chainsaws at work (INDG317, published 01/13) labels the safety parts on a rear-handled saw. They are the combined chain brake and front hand guard, the throttle trigger lockout, the chain catcher, anti-vibration mounts, the rear chain breakage guard and a chain with low-kickback characteristics. Safety devices and guards are to be kept in working order. The daily check list covers the on/off switch, chain brake, chain catcher, silencer, guide bar, drive sprocket and chain links, hand guards, anti-vibration mounts and starting cord.

The design standard

ISO 11681-1 is the international standard for portable chain-saw safety requirements and testing, Part 1: chain-saws for forest service. Its scope is portable, combustion-engine, hand-held saws used for forest work by one operator, with the right hand on the rear handle and the left hand on the front handle. It covers significant hazards except kickback and balance for machines over 80 cm3 of engine displacement.

ISO 11681-1 editions in the catalogues
EditionStatus
ISO 11681-1:2011Withdrawn on March 20, 2022 (stage 95.99); revised by the 2022 edition
ISO 11681-1:2022 and EN ISO 11681-1:2022The EN ISO text is valid from June 1, 2022 in the Estonian catalogue. The scope adds design, construction, transporting and commissioning, and leaves out dismantling and scrapping

Sources