ArbNation Join free

Chainsaw trousers and chaps: what the rules say about washing, damage and replacement

No BC, HSE or New Zealand text gives a wash temperature or a wear-out date for chain saw leg protection. WorkSafeBC sets a shrink limit for cleaning, a manufacturer care sheet and removal from service when damage affects performance.

Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.

The facts on this page come from the codes and standards bodies named below. It is not training and does not teach the work. It carries no advice from makers. For the label codes and country standards, see the guide to chain saw clothing labels.

British Columbia: a rule for the device itself

WorkSafeBC's OHS Regulation, section 8.21, says leg protective devices must be worn by a worker operating a chain saw. The device must meet the general requirements in section 4 of the WorkSafeBC Standard in Schedule 8-A. It must also meet the cut-resistance performance of one of four standards: the WorkSafeBC standard, ASTM F 1414-04, ISO 11393-2 or BS EN 381-5:1995. The last two are applied at a Class 2 threshold chain speed of 24 metres per second.

Section 8.21(3) sets the label. It is permanently affixed, in lettering at least 6 mm high, and shows the maker's name or trademark, the two standards met and the year of manufacture unless it is marked elsewhere on the device.

Schedule 8-A names three types: pant type, apron type and chap type. Four of its general requirements bear on care and wear:

  • The device must not shrink more than 10% when cleaned in accordance with the manufacturer's instructions during its service life.
  • Edges where unravelling or fraying is likely must have effective measures against it. A heat seal on synthetic fibres must stay effective over the life of the product.
  • The manufacturer must provide instructions on the proper care, maintenance and repair of the device.
  • A device showing damage that will affect its performance must be removed from service.

The pad must be at least 711 mm (28 in) long, cover the front of both legs and extend at minimum from the crotch to within 75 mm (3 in) of the ankle.

Section 8.20, titled cleaning or replacement, is a different rule. It covers gloves, aprons and other equipment that protect the skin against a hazardous substance and are rendered ineffective by contamination. It is not a chain saw leg protection rule.

United Kingdom

HSE leaflet INDG317, Chainsaws at work, names leg protection to EN 381-5. It recommends all-round protection for arborists working in trees and for occasional users. Protective clothing complying with the appropriate standard should give a consistent level of resistance to chain saw cut-through. The leaflet adds that PPE is to be maintained and available at all times, and lists proper maintenance schedules for PPE among management controls for noise and vibration. No protective equipment can give 100% protection against cutting by a hand-held chain saw.

Other clothing worn with the PPE needs to be close fitting and non-snagging.

New Zealand

The Approved Code of Practice for Safety and Health in Arboriculture (November 2012) says everyone using a chain saw shall wear safety leg protection complying with AS/NZS 4453.3 1997 or a standard with the same or more stringent criteria. For clothing in general, the code says damaged or torn items shall be properly repaired or replaced.

The ISO standard

The SNV-Connect catalogue lists ISO 11393-2:2018, published October 1, 2018, as the second edition and the current one. The 1999 edition is listed as withdrawn. The catalogue describes the standard as covering performance requirements, test methods, design requirements, and identification and marking information for leg protectors that protect against cutting by hand-held chain saws.

Gaps in the documents

None of the BC, HSE or New Zealand texts says anything about oil on leg protection, and none sets a washing temperature or a replacement date. The care instructions that BC requires from the manufacturer are the only written source on cleaning.

Sources