ArbNation Join free

Climbing with a crane: what OSHA, HSE and the industry code say about attachment during a hoist

OSHA's rule on hoisting personnel never mentions tree work and names an attachment point for each setting it covers. The UK industry code asks for a suitable and safe system of attachment of the climbing system to the crane hook.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

The named codes and training bodies are described here as published. It is not training and does not teach the work.

OSHA 29 CFR 1926.1431

Section 1926.1431, Hoisting personnel, is part of OSHA's construction standard for cranes and derricks. It applies when one or more employees are hoisted. Its text does not mention trees or tree work. The section opens with a general bar on using equipment to hoist employees. The exception covers cases where conventional means, such as an aerial lift or a work platform, would be more hazardous or are not possible.

The standard is built around a personnel platform. For each setting it covers, it names where a person's fall protection attaches.

Where 1926.1431 places the attachment of fall protection, by setting
SettingParagraphAttachment named
Personnel platform(k)(10)A structural member within the platform
Drill shaft, boatswain's chair(o)(3)(iv)Full body harness attached independent of the crane or derrick
Pile driving, boatswain's chair(p)(4)(iii)Full body harness independently attached to the lower load block or overhaul ball
Storage tank, shaft and chimney work, boatswain's chair(s)(3)(iii)Independent of the crane or derrick; to the lower load block or overhaul ball when no adequate structure exists

Where equipment hoists a person with no platform, paragraph (d)(3) caps the total load, including hook, load line, rigging and other equipment, at 50 percent of the rated capacity for the radius and configuration. The standard also requires locking hooks, a trial lift before each shift and a pre-lift meeting with the employees to be hoisted. It bars hoisting personnel within 20 feet of a power line of up to 350 kV, except for work under subpart V.

The industry code

The Industry Code of Practice for Arboriculture: Tree Work at Height (ICoP), edition 1 of February 2015, covers cranes in section 2.8.4. Lifting people for tree work with a crane should only be carried out where it is not practicable to access the tree by any other means, and after a risk assessment.

Section 2.8.4.2 lists eight points to take into account:

  • Thorough examination of the crane and equipment at specified intervals.
  • Use of a carrier where reasonably practicable.
  • A safe system of work minimising the risk of collisions.
  • A suitable and safe system of attachment of the climbing system to the crane hook, with the other lifting accessories in mind.
  • Stowage of climbing equipment during the lift.
  • Proximity to hazards during the lift.
  • Communication between the arborist and the crane operator.
  • Planning for emergencies and rescue.

The code does not name a single connection method. The Arboricultural Association (AA) Safety Guide 4, Use of Mobile Cranes in Tree Work, dated December 2020, gives a checklist on accessing the crown. It asks whether the safe working load has been derated by 50 percent if the crane lifts personnel, and whether aerial rescue has been planned and practised.

HSE on climbing and lifting people

HSE states that the Work at Height Regulations 2005 do not ban climbing work. Climbing with a rope and harness can only be done under three conditions. A risk assessment shows the work can be done safely that way. A safer option such as a MEWP is not justified. The user and enough available people are trained for the task, including rescue.

HSE's climbing page also says that, in the tree, the system should where possible be securely attached to two anchor points that bear load, each strong enough for the climber, the work equipment and any foreseeable loading. Work positioning systems should only be used with a suitable backup for preventing or arresting a fall. For rope access, it says at least two separately anchored lines are needed, a working line and a safety line, with the user connected to both through a suitable harness.

HSE's arboriculture page treats a crane as lifting equipment. It says the risk of a person falling should be eliminated where possible and otherwise reduced. Climbers do not climb above anchor points when using work positioning. A karabiner with a 3-way action gate sits at the main attachment point between rope and harness. Lifting equipment used for lifting people needs thorough examination by a competent person.

What the documents leave open

None of these documents says where a climber ties in when a crane lifts a person into a tree. OSHA's rule names attachment points for platforms and chairs, the ICoP asks for a safe system of attachment to the hook, and HSE gives general anchor rules. Related reading: the guide to cranes in tree work, the guide to crane-assisted removal and the guide to fall distance and slack.

Sources