Climbing in wind, rain and cold: stop-work wording and thresholds by country
The New South Wales and New Zealand codes call for work to stop in strong wind and wet weather but print no wind speed. The only wind figure is 7 m/s, in the UK code's crane lifting list.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
The named codes and training bodies are described here as published. It is not training and does not teach the work.
Credits: SafeWork NSW text is adapted from the Tree works code of practice (March 2026), copyright State of New South Wales (SafeWork NSW), licensed under Creative Commons Attribution 4.0; changes were made, because the text is summarised and reworded. WorkSafe New Zealand material is summarised from its Approved Code of Practice for Safety and Health in Arboriculture (November 2012), with the source acknowledged.
Weather wording by code
| Country and source | Wording on weather | Figure given |
|---|---|---|
| Australia (New South Wales), SafeWork NSW Tree works code, 3.3 | Wind, wet conditions, cold, heat, solar UV and lightning are listed as weather hazards. In strong winds, lightning, extreme heat or torrential rain, work should stop and be rescheduled. | None |
| New Zealand, WorkSafe NZ Approved Code of Practice, 2.2 | Where an operation becomes dangerous because of high winds, wet weather, poor visibility or other adverse conditions, the employer or person in charge shall suspend operations while those conditions exist. | None |
| United Kingdom, ICoP Tree Work at Height, work at height planning | Planning of work at height should include avoiding weather conditions that may jeopardise the health and safety of operators. | None |
| United Kingdom, ICoP, 3.8.4 crane | Raising and lowering people by crane should not be carried out in winds above 7 m/s (25 km/h), in thunderstorms, in snow, sleet or ice, in fog, or in any other weather that could affect safety. | 7 m/s (25 km/h) |
| United Kingdom, ICoP, 3.8.3 platform | The planning list for a MEWP names wind above the platform's own wind limit, and wind acting badly on the tree at speeds below that limit. | The platform's limit, not stated |
| Canada (British Columbia), WorkSafeBC OHS Regulation, 26.7.2 | When weather creates a hazard for a worker in a forestry operation, additional precautions must be taken as necessary for the safe conduct of the work. | None |
| United Kingdom, HSE tree climbing page | No weather wording. | None |
The one wind figure
The ICoP gives the only wind figure among the sources opened. It sits in the list of conditions for lifting a climber by crane: winds above 7 m/s (25 km/h). The same list names thunderstorms, snow, sleet or ice, and fog.
The ICoP's platform list names wind above the MEWP's own wind speed limit. It also names wind acting adversely on the trees at speeds below that limit.
Codes with no figure
The NSW code and the New Zealand code set no wind speed, no rainfall and no temperature for climbing. The NSW code puts weather inside the risk assessment for the work, and names a local forecast and site information as the source of regular updates on conditions.
The New Zealand code puts the duty on the employer or person in charge. Its wording is a duty to suspend, and it applies while the conditions last. It also says that in emergency situations work should be the minimum needed to make the situation safe.
Wet and cold
The NSW code says wet conditions can change how plant and equipment perform. It lists a higher risk of equipment damage, electrical hazards and a less stable tree. For cold, it names hypothermia and frostbite from low temperatures. It sets no temperature.
The New Zealand code names wet weather and poor visibility next to high winds. The WorkSafeBC section is wider still: any weather that creates a hazard calls for additional precautions. That section is in the forestry operations part of Part 26, and the tree-climbing sections of Part 26 apply to a workplace other than a forestry operation.
Wind in the NSW code
The NSW code says strong winds can damage or weaken trees. It lists three more effects: poorer communication, destabilised plant or workers near the tree, and branches that sway or fall without warning. The code ties these to the decision to stop.
Sources
- SafeWork NSW, Tree works code of practice, commenced March 27, 2026, section 3.3, read October 19, 2026
- WorkSafe New Zealand, Approved Code of Practice for Safety and Health in Arboriculture, November 2012, section 2.2, read October 19, 2026
- Arboricultural Association, Industry Code of Practice for Arboriculture: Tree Work at Height (ICoP), second edition, May 2020, read October 19, 2026
- WorkSafeBC, OHS Regulation Part 26 Forestry operations and similar activities, sections 26.7.2 and 26.12.0.1, read October 19, 2026
- HSE, Tree climbing, read October 19, 2026