Diesel exhaust fluid and engine derate rules: what 40 CFR parts 1036 and 1068 print
EPA's rule for new heavy-duty engines in 40 CFR 1036.111 sets a speed derate once diesel exhaust fluid runs low, falls short on quality or a catalyst is missing. Part 1068 treats running an SCR engine without urea as tampering.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The text is from the U.S. Environmental Protection Agency's rules in Title 40 of the Code of Federal Regulations: sections 1036.111 and 1036.125 for engine makers, and section 1068.101 for everyone. Diesel emission systems on work trucks are also covered in the guide to what the Clean Air Act and EPA say about removal.
At a glance
| Item | What the regulation prints |
|---|---|
| Why a derate | SCR engines depend on a constant supply of diesel exhaust fluid (DEF); the derate induces action |
| Start | Model year 2027, with earlier compliance allowed |
| Triggers | DEF at 2.5 percent of tank capacity, DEF quality failing, a missing catalyst, listed open-circuit faults |
| Speed cap, high-speed vehicle | 65 mph at the trigger, stepping down to 25 mph after 164 hours of non-idle operation |
| Tampering penalty | Up to US$4,454 per engine for most people; US$44,539 for a manufacturer or dealer |
The derate in section 1036.111
Section 1036.111, headed "Inducements related to SCR", opens with the reason: engines using selective catalytic reduction depend on a constant supply of DEF. Manufacturers must design engines to cut power output so operators act to keep the SCR system working. It applies equally to engines in heavy-duty vehicles of 14,000 pounds GVWR or less, and starts in model year 2027. Manufacturers may comply earlier.
Four conditions trigger the derate. DEF supply falls to 2.5 percent of tank capacity, or a level matching three hours of engine operation. DEF quality fails the maker's concentration specification. A signal shows a catalyst is missing. An open circuit appears in the DEF tank level sensor, DEF pump, DEF quality sensor, SCR wiring harness, NOx sensors, DEF dosing valve, tank heater, tank temperature sensor or aftertreatment control module.
The derate is a maximum drive speed that falls with hours of non-idle engine operation. It decreases vehicle speed by 1 mph for every five minutes of engine operation until it reaches the derate speed. The schedule depends on the average speed over the previous 30 hours of non-idle operation. Below 15 mph is a low-speed vehicle, 15 to under 25 mph is medium, and 25 mph or more is high. A vehicle that has not logged 30 hours counts as high-speed.
| Vehicle category | Steps, hours of non-idle operation and maximum mph |
|---|---|
| High-speed | 0 h, 65; 6 h, 60; 12 h, 55; 20 h, 50; 86 h, 45; 119 h, 40; 144 h, 35; 164 h, 25 |
| Medium-speed | 0 h, 55; 6 h, 50; 12 h, 45; 45 h, 40; 70 h, 35; 90 h, 25 |
| Low-speed | 0 h, 45; 5 h, 40; 10 h, 35; 30 h, 25 |
For DEF supply, the engine may reset the timer to three hours when it detects an empty tank. Motorcoaches may use another schedule that starts at 65 mph, drops to 50 mph after 80 hours and ends at 25 mph after 180 hours. A derate lifts when the engine confirms the trigger is resolved. The engine must let a generic scan tool clear triggering codes while the vehicle is not moving. A trigger that returns within 40 hours of engine operation restarts the derate at the same point in the schedule.
Maintenance and the owner's manual
Section 1036.125 accepts DEF replenishment as reasonably likely to happen if the engine meets the section 1036.111 specifications. The minimum scheduled replacement interval for DEF filters is 100,000 miles (3,000 hours) for light, medium and heavy heavy-duty engines, and the minimum cleaning interval is 50,000 miles (1,500 hours). The owner's manual has to carry a troubleshooting guide for SCR inducement warnings. It covers the derate schedule, including the fact that derates begin before the DEF tank is empty. It explains the trouble lights and the three kinds of SCR derate: DEF level, DEF quality and tampering. The manual also names a website for service bulletins and recalls.
The same section adds that disabling or improperly resetting a maintenance-needed signal without doing the maintenance violates the tampering prohibition in 42 U.S.C. 7522(a)(3).
Tampering in section 1068.101
Paragraph (b)(1) of section 1068.101 applies to everyone. It bars removing or rendering inoperative any device or element of design installed to comply with the regulations. It gives an example: operating an engine without a supply of appropriate quality urea, when the emission control system relies on urea to reduce NOx emissions. Wrong fuel or engine oil that disables the control system is another.
The civil penalty is up to US$44,539 per engine or piece of equipment for a manufacturer or dealer, and up to US$4,454 for anyone else. Paragraph (b)(2) bars knowingly making, selling or installing a component that bypasses or disables emission control, at up to US$4,454 per component. The prohibition does not apply where the engine needs repair and is restored when the repair is done, or where it is modified for a temporary emergency and restored as soon as possible. The section says its maximum penalty values apply as of August 1, 2016, and may be adjusted under 40 CFR part 19.
Sources
- U.S. Code of Federal Regulations, 40 CFR 1036.111 Inducements related to SCR, via eCFR, read October 19, 2026
- U.S. Code of Federal Regulations, 40 CFR 1036.125 Maintenance instructions and allowable maintenance, via eCFR, read October 19, 2026
- U.S. Code of Federal Regulations, 40 CFR 1068.101 What general actions does this regulation prohibit?, via eCFR, read October 19, 2026