ArbNation Join free

Drip, soaker hose and sprinkler irrigation around trees: what extension says

Missouri, Arizona and Oklahoma extension papers compare drip lines, soaker hoses and lawn sprinklers for trees. They give emitter flow rates and spacing, run times, and a probe test for too much or too little water.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The facts on this page come from extension papers at Missouri, Arizona and Oklahoma State. It is not training and does not teach the work. Staking and first-year watering get their own page.

Sprinklers and lawn watering

The University of Missouri Extension guide G6879 calls sprinkler irrigation wasteful and says it encourages foliar diseases. It is also not very effective at getting water past turf roots to the roots of woody plants. Drip irrigation uses much less water and puts it more effectively into the root zone. Lawn irrigation is usually frequent and short, and it keeps only the top 3 inches of soil moist. That is enough for turf and gives little to tree roots. A large mulched area under the tree, or a less competitive ground cover such as ivy, lets the tree use irrigation much better.

Missouri works one example. A 30-foot-diameter bed of 10 shrubs takes 438 gallons from a sprinkler to receive 1 inch of water. The same shrubs on one drip line with 20 emitters at 1 gallon per hour need about 25 gallons.

Methods side by side

The University of Arizona Cooperative Extension methods sheet, which credits the University of Minnesota, lists the pros and cons of each way of delivering water.

Irrigation methods for trees as listed by Arizona Extension
MethodProsCons
Drip (tape, tubing, emitters)Water goes directly to each plant's roots. No waste and no evaporation.Emitters can clog. Emitters need to be added as the tree grows so water reaches the whole root zone and the drip line.
Bubblers, shrubblers and sprayersReach multiple plants. Less clogging than drip.Some evaporation.
Soaker hoseNo runoff. Slow irrigation around the whole tree. Good for slopes.Can clog over time with minerals in the water.
BasinsThe amount of water applied is visible. They can reach the circumference of the tree.Berms erode over time and must be expanded as the tree grows.
Hand-wateringWater can be directed. It gives a chance to look over plants for insects and disease.Takes time.

Emitter placement and flow

The Arizona Backyard Gardener sheet on tree irrigation during drought says most of a tree's water-absorbing roots lie in the top 12 inches of soil. To encourage broad, shallow roots it puts irrigation at the dripline and slightly beyond. Young trees often get one or two emitters beside the trunk. The sheet says such systems rarely meet a tree's needs beyond two or three years after planting. When the system grows, the original emitters stay near the trunk, where roots are established, and more emitters are added outward toward the dripline.

Oklahoma State Extension fact sheet BAE-1511 works a peach tree with a 12-foot canopy and a use rate of 0.24 inch a day. That tree needs 18.8 gallons a day. One 1 gph emitter could supply it, but root development is better promoted by dividing the flow among three or four emitters near the canopy dripline, equally spaced around the tree. Four 2 gph emitters apply the 18.8 gallons in 2.4 hours. At a seven-day interval the run time is 16.5 hours.

Missouri's guide ties spacing to soil. On sandy soil emitters sit closer together than on clay to wet a solid band. On most clay loams, emitters of 0.4 to 0.6 gph work best. A 1 gph emitter in clay loam wets about 2 square feet, so it takes 1.24 hours to apply 1 inch to that area, and emitters about 18 inches apart wet a solid band. Wetting 25 to 50 percent of the root zone usually keeps ornamentals in good condition through drought.

Soaker hoses and run times

Missouri describes a 50-foot soaker hose split with a Y-adapter into two 25-foot runs. Laid inside the drip line and run for about one hour, it wets a band about 2 feet wide with about 200 gallons. Missouri puts that at about a 6-inch rain over 5 percent of a large tree's root zone. It suggests three or four such runs in different places during drought. Arizona says soaker hoses on slopes can give periodic irrigation near the dripline, and basins on level ground belong at or beyond the dripline.

For a new tree, Missouri gives 2 or 3 gallons every four or five days to keep a 24-inch root ball moist but not saturated. Arizona gives once a week in summer heat and every 6 to 8 weeks during fall and winter drought for planted trees.

Signs of too little or too much water

Missouri names a probe test for a new tree. If a metal rod cannot be pushed more than a few inches into the root ball, too little water is going on. If it slides easily all the way through, the tree is overwatered. An 18-inch hole drilled beside the ball with a soil auger shows standing water. Missouri also notes that a drip-watered plant can show a dry surface while the root zone holds ample moisture, which tempts longer watering. Arizona uses the same probe idea with a smooth steel rod or 12-inch screwdriver to judge whether the soil is wet to at least 12 inches. Oklahoma adds that improper design and component sizing can give poor uniformity of application. It also says drip irrigation needs careful water treatment to prevent emitter blockage, and that frequent inspection of the system is necessary.

Sources