ArbNation Join free

Drones for line placement and tree work: FAA Part 107, UK Power Networks and one study

The FAA's Part 107 sets height, sight and over-people limits for small drones in the United States. UK Power Networks is testing cutting drones near power lines, and one 2023 paper used a drone to pull a line over a branch.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The text below describes what the named regulator, network operator and study publish. It is not training and does not teach the work. UK Power Networks is a network operator, not a regulator, and the study is peer reviewed research.

FAA Part 107 for small unmanned aircraft

14 CFR Part 107 sets the operating rules for small unmanned aircraft in the United States. None of the sections in the table mentions tree work, line placement or branch cutting.

SectionWhat it provides
107.12Only a person with a remote pilot certificate with a small UAS rating may manipulate the flight controls, or a person under the direct supervision of a remote pilot in command who can immediately take control. The remote pilot in command must hold the certificate, with one exception in 107.12(c) for foreign-registered aircraft
107.19A remote pilot in command is designated before or during the flight and is the final authority on the operation. That person must see to it that the aircraft will pose no undue hazard to other people, aircraft or property if control is lost for any reason
107.31The remote pilot in command, the visual observer if one is used, and the person at the controls must be able to see the aircraft throughout the flight with vision unaided other than by corrective lenses. That ability is exercised by the pilot and the person at the controls, or by a visual observer
107.39No operation over a human being unless that person is directly participating in the operation, is under a covered structure or in a stationary vehicle, or the operation meets one of the categories in subpart D
107.51Groundspeed up to 87 knots (100 miles per hour). Altitude up to 400 feet above ground level, unless the aircraft is within a 400-foot radius of a structure and no higher than 400 feet above the structure's uppermost limit. Flight visibility of at least 3 statute miles. At least 500 feet below and 2,000 feet horizontally from clouds
107.205Lists the rules a certificate of waiver may deviate from, including 107.31, 107.39 and 107.51

The rules on inspection flights are compared across countries in the guide to drone pilot rules for tree inspection.

UK Power Networks and the Aero Prune trial

UK Power Networks runs Aero Prune on its innovation site, with a start date of December 1, 2025 and an end date of September 30, 2026. The project asks whether drones fitted with cutting tools can safely trim trees near overhead power lines. Its stated aims are fewer outages, safer field staff and access to places heavy machinery cannot reach.

The project tests two designs. One is a commercially available drone with a specially selected cutting tool, built as a prototype and put through bench tests before controlled outdoor trials. The other is a new drone built for vegetation work near lines, developed with Acuity Robotics and so far modelled in CAD and simulation. The team is assessing flight stability, cutting precision and whether the drones can cut branches up to around three inches in diameter.

The project page calls this a new concept: drones are widely used for inspection, but tree-cutting drones for use near electricity networks do not exist. Its major learning is that safety rules, aviation requirements and tree-cutting standards must be weighed together. It also names battery life, pilot training and maintenance needs as practical considerations. Power-line clearance work itself is covered in the guide to utility line clearance.

A published study of drone line placement

Liu and five co-authors, from Northeast Forestry University, the University of Western Australia and the Heilongjiang Institute of Forestry Science, published a methods paper in Frontiers in Plant Science on October 16, 2023. It describes a mini-drone that pulls a traction line over a target branch. The line then pulls a retrieving rope fitted with a wire saw or chain saw across the branch to cut a canopy sample. The purpose is research sampling, not tree care.

The authors report the method as feasible for lower and middle canopy up to 30 metres tall, across most temperate broad-leaved and conifer species. They give 20 metres as the safe distance to keep the drone from going out of control, and they chose a drone with a 50 metre flight range. The procedure involves at least two operators, one flying the drone and one handling the finishing reel and guide tube that release the traction line.

The paper compares the method with pole pruners, tree climbers, hydraulic lifts, shooters, throw-line launchers and larger UAV systems. It says climbing carries safety issues and labour costs, and that larger UAV systems need professional set-up, skilled operation, working licences, large take-off areas, and that they make noise that can disturb birds and bees. The authors state that their mini-drone method needs no extra working permit, and their summary table notes that mini-drones are under air traffic control in some countries. The throw-line launchers the paper compares against are covered by the guide to throw-line throw weights.

Sources