Electrical impedance tomography and the other decay detection methods
The ISA manual puts seven decay tests under advanced assessment, from increment boring to radar and X-ray. Makers, a journal study and a government planning file describe what each one measures and where it falls short.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
The named journals, agencies and makers are described here as published. It is not training and does not teach the work.
The ISA list of decay tests
The International Society of Arboriculture's Tree Risk Assessment Manual (Dunster and others, 2013) groups decay testing under Level 3, advanced assessment. An arborist's report on the NSW planning portal reproduces the list. It names increment boring, drilling with a small-diameter bit, resistance-recording drilling, single-path sonic or stress wave, sonic tomography, electrical impedance tomography, and radiation by radar, X-ray and gamma ray. The manual adds that listing a technique is not an endorsement of it.
At Level 2, the same report lists a visual inspection using binoculars, a mallet, probes or shovels.
What each method is described as measuring
| Method | What the source says it measures | Limit the source records |
|---|---|---|
| Increment boring | A maker's brochure: 5 mm (about 1/5 in) cores from trees and intact timber, taken by hand or with a portable drill | The brochure lists limited usability in deteriorated timber |
| Resistance drilling | Wang and Allison: relative resistance, as drilling torque, while a rotating needle with a 3 mm tip and 1.5 mm shaft is driven in at constant speed. Prolonged low resistance marks decay, cavities or cracks. A maker's brochure adds that profiles give information on the extension trends of internal stem decay | Wang and Allison: because it requires drilling into the tree, the test is considered minimally invasive |
| Single-path stress wave | Wang and Allison: transit time between two probes. Waves travel slower in decayed wood and around hollows | Velocity varies widely even in intact stems, and no standard reference velocity is available |
| Sonic tomography | A maker's page: shows the full extent of a defect graphically | Wang and Allison, citing a maker's manual: tomographs cannot tell decay from crack-induced acoustic shadows |
| Electrical impedance tomography | One maker lists acoustic and impedance tomography under seeing inside the trunk. Another lists resistance tomography among its measurement methods | Nicolotti and others, quoted by Wang and Allison: of electric, ultrasonic and georadar tomography on urban trees, ultrasonic proved the most effective |
Names for electrical methods
The ISA list says electrical impedance tomography. One maker's tree inspection page says resistance tomography. Another maker lists impedance tomography beside its acoustic tools. None of the opened pages defines the method.
Wang and Allison quote a 2003 study by Nicolotti and others that applied electric, ultrasonic and georadar tomography to urban trees. The methods had different degrees of success. Ultrasonic tomography was the most effective for finding internal decay and estimating the size and shape of the anomaly.
Methods tested together
Wang and Allison tested two century-old red oaks in Madison, Wisconsin, with visual inspection, a single-path stress wave timer, acoustic tomography and resistance microdrilling. The trees were then felled and a disk was taken at each test location.
- Visual inspection and the single-path timer found a general problem but without specificity.
- The tomograph showed the general location and size of the defect in each cross-section.
- Microdrilling was needed to pinpoint defects and to separate decay from cracks.
In tree No. 307 the disks showed heartwood decay at all three elevations tested, along with major internal cracks.
Sources
- Fakopp Enterprise, products index page, read October 16, 2026
- IML Electronic, Tree Inspection page, read October 16, 2026
- Rinntech, product brochure, April 22, 2022 edition, read October 16, 2026
- Wang and Allison, Decay Detection in Red Oak Trees Using a Combination of Visual Inspection, Acoustic Testing, and Resistance Microdrilling, Arboriculture & Urban Forestry 34(1), January 2008, read October 16, 2026
- Advanced Treescape Consulting arboricultural report, Appendix 4a, reproducing the ISA Tree Risk Assessment Manual levels of assessment, NSW planning portal, read October 16, 2026