ArbNation Join free

EN 12275, EN 12278 and EN 567: connector, pulley and rope clamp standards

EN 12275 covers mountaineering connectors, EN 12278 covers pulleys and EN 567 covers rope clamps. UIAA 126 builds on EN 567 for rope clamps and adds a no-slide requirement for self-belaying clamps.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. All three European standards sit under mountaineering equipment, and the catalogue pages name no tree work use. EVS lists EN 12275 and EN 567 under Regulation (EU) 2016/425 on personal protective equipment.

The register

StandardTitleEdition and status
EN 12275Mountaineering equipment. Connectors. Safety requirements and test methods2013. BSI Knowledge lists it as current, published April 30, 2013. EVS gives May 6, 2013 as the valid-from date, and the 1999 edition as the earlier one.
EN 12278Mountaineering equipment. Pulleys. Safety requirements and test methods2007. BSI Knowledge lists it as current, under review, published September 28, 2007.
EN 567Mountaineering equipment. Rope clamps. Safety requirements and test methods2013. EVS gives April 2, 2013 as the valid-from date, and the 2000 edition as the earlier one.

Scope in the publishers' words

BSI states that EN 12275 sets safety requirements and test methods for connectors used in mountaineering, climbing and related activities. Connectors are part of the safety system that protects the climber from a fall from height. EVS prints the same scope sentence.

BSI states that EN 12278 sets safety requirements and test methods for pulleys used in mountaineering, including climbing. Its page says the standard was prepared under a mandate given to CEN by the European Commission and the European Free Trade Association, to give a means of conforming to the New Approach Directive 89/686/EEC on personal protective equipment. BSI lists strength, design, marking and instructions for use among its subjects.

EVS states that EN 567 applies to rope clamps used with dynamic mountaineering ropes under EN 892, accessory cord under EN 564 and low stretch kernmantle ropes under EN 1891.

UIAA 126 for rope clamps

The UIAA published UIAA 126, third edition, in December 2025, as version 3.1. Its foreword says it bases the standard on EN 567:2013 and adds requirements of its own to those of EN 567.

The UIAA label goes only to rope clamps that meet all the requirements of EN 567:2013, with one exception: no EN number is required. For the award of the label, a rope clamp for self-belaying must not slide along the rope when loaded by hand in the normal loading direction. The UIAA notes that it does not reproduce the full requirements of the referenced standards, and that official copies are sold on the CEN website.

Where the standards are sold

EVS sells EN 12275 and EN 567 as a PDF or on paper. BSI Knowledge holds the catalogue pages for EN 12275 and EN 12278. The UIAA publishes UIAA 126 as a PDF on its site. Related pages on this site are the guide to climbing equipment specs by item and the guide to rigging blocks and pulleys.

Sources