ArbNation Join free

Eyewash stations and eye injuries on site: OSHA 1910.151(c), OSHA letters and HSE first aid advice

OSHA 1910.151(c) calls for quick drenching or flushing facilities where eyes or body may meet injurious corrosive materials. OSHA treats ANSI Z358.1 as guidance, and the HSE gives 10 minutes of flushing for a chemical eye injury.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. It sets out the OSHA eyewash rule, two OSHA letters that explain how the rule meets the ANSI standard on eyewash equipment, and the first aid advice on eye injuries from the UK Health and Safety Executive.

The OSHA rule in 29 CFR 1910.151(c)

Paragraph (c) of 29 CFR 1910.151, Medical services and first aid, covers eyes or body that may be exposed to injurious corrosive materials. In that case, suitable facilities for quick drenching or flushing of the eyes and body shall be provided within the work area for immediate emergency use. The wording names no equipment type, flow rate or distance.

Paragraph (b) of the same section is separate. Where no infirmary, clinic or hospital is in near proximity, a person or persons shall be adequately trained to render first aid, and adequate first aid supplies shall be readily available.

Where tree care shops come in

OSHA's tree care industry page keeps a list headed Common Shop Hazards and Tree Care Considerations. One line states, "If corrosive chemicals are used, emergency eyewashes and showers are required," with a reference to 29 CFR 1910.151. That line names no particular chemical or type of equipment.

How OSHA treats ANSI Z358.1

An OSHA letter of April 18, 2002 says ANSI standards become mandatory OSHA standards only when, and if, OSHA adopts them. It says ANSI Z358.1 was not adopted. Z358.1 gives detailed information on installing and operating emergency eyewash and shower equipment, and OSHA has often referred employers to it as guidance. Because 1910.151(c) gives no instruction on installation and operation, assessing conditions such as water temperature is left to the employer.

On flow, OSHA has adopted no specific rates. The letter describes section 4.1 of ANSI Z358.1: emergency shower heads capable of delivering a minimum of 75.7 litres per minute (20 gpm) at a velocity low enough to be non-injurious. Enough fluid has to be available to supply that flow for a minimum of 15 minutes. A citation for unsuitable facilities is issued under 1910.151(c), not under the General Duty Clause.

A June 1, 2009 OSHA letter covers when the rule applies. When none of the materials in a work area is an injurious corrosive, as shown by the material safety data sheet for each product, an emergency eyewash or shower is not required under 1910.151(c). The letter's second question concerns a corrosive product packaged in sealed dispensing containers, and its reply is yes. It restates that hazardous materials in sealed containers that will not be opened need no eyewash or emergency shower.

HSE first aid advice on eye injuries

This section describes what the HSE publishes. It is not training and does not teach the work. The HSE leaflet Basic advice on first aid at work (INDG347, revised 2017) is not a rule. All eye injuries are potentially serious, in its words. For something in the eye, it describes washing out the eye with clean water or sterile fluid from a sealed container to remove loose material, and not trying to remove anything embedded.

If chemicals are involved, the leaflet says to flush the eye with water or sterile fluid for at least 10 minutes while gently holding the eyelids open. The casualty holds a pad over the injured eye and is sent to hospital. For chemical burns on skin, it gives 20 minutes of flooding with water. The leaflet calls itself basic advice and not a substitute for effective training.

Sources