ArbNation Join free

Felling rules in Ireland: what the HSA code and the IFSG leaflets publish

Ireland's Health and Safety Authority publishes a forestry code of practice and a series of Irish Forestry Safety Guide leaflets on felling, windblow and cross cutting, adapted from the FISA guides in Great Britain.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The named codes and training bodies are described here as published. It is not training and does not teach the work.

The Code of Practice for forestry operations

The Health and Safety Authority (HSA) published its Code of Practice for Managing Safety and Health in Forestry Operations in December 2009, revised in 2023. It came into operation on December 1, 2009, under section 60 of the Safety, Health and Welfare at Work Act 2005. It gives practical guidance on the Act and the General Application Regulations 2007 to 2021 for forestry work.

Section 61 of the 2005 Act, which the code reprints, makes a code of practice admissible in evidence in proceedings for an offence. That holds where it appears to the court to give practical guidance on the requirement alleged to have been contravened. Failure to follow it, or compliance with it, is also admissible.

The code puts felling duties on the forestry works manager and on contractors. The manager specifies site safety rules, which will usually cover the risk zones around tree felling and systems of work for hung-up trees, hazardous terrain, overhead power lines or windblown trees. A contractor engaging chainsaw operators checks that they have relevant certificates of competence and knowledge of safe work practice for taking down hung-up trees. The contractor also checks for the right felling aids, the correct chainsaw protective equipment, a safety statement and written risk assessments.

The IFSG leaflets

On its forestry publications page, the Authority lists the Irish Forestry Safety Guide series. Titles include petrol driven chainsaws (301), felling and manual takedown (302), snedding (303), cross cutting and manual stacking (304), clearance of windblow (306) and felling of large trees (307). The four leaflets below, printed in October 2018, say they were modified for Irish use with the permission of the Forest Industry Safety Accord. Each also says it sets out evidence of good practice for one task, that deviation should come only after a full risk assessment by competent persons, and that health and safety obligations must be met at all times. Each states that all operators must have had appropriate training.

IFSG 302, basic felling

The leaflet covers basic felling and manual takedown in plantations, or of single trees in open spaces with at least two tree lengths of clear space in all directions and no need for pulling aids. It names a safe working distance of two tree lengths unless exceptional conditions and a full risk assessment dictate otherwise. A sink cut lets the tree fall on a hinge, and the hinge is parallel-sided and not less than 25 mm thick. Once a felling cut is started, the tree is not left standing. The leaflet lists a hand winch with cable, pulleys and strops among the aid tools, and states that a hung-up tree is not to be climbed or worked under, and that no second tree is felled across it.

IFSG 307, large trees

This leaflet covers felling and crown breakdown of large trees in plantations or single large trees. It requires the basic principles of IFSG 302 to be read with it. Aid tools listed are a sledgehammer, wedges and an appropriately rated winch. The felling cuts are proportional to the tree's diameter, size, species and potential for decay. During crown breakdown no one is within twice the tree height, and on steep slopes no one is directly below. The leaflet notes that wood from the crown can travel a considerable distance, that the operator must expect rolling or springback, and that supporting branches are retained, with the tree kept stable by a properly anchored winch if necessary.

IFSG 306, windblow

The leaflet opens with a warning that clearing windblow is very hazardous and each situation needs careful assessment. It prints "never work in windblow on your own", and no walking or working under unstable windblown trees or root plates. When felling or taking down standing, leaning or broken stems, no other person is closer than twice the length of the tree. When severing a stem, the initial cut goes into the compression wood. The final cut goes into the tension wood at least 25 mm from the first cut. The leaflet considers mechanised systems a safer alternative to manual harvesting of windblown areas.

IFSG 304, cross cutting

This leaflet covers bucking and manual stacking. The leaflet has the operator work on the uphill side of logs where timber might roll. It relieves tension with a first cut on the compression side. For a boring cut, it says not to start with the tip of the guide bar, to avoid kickback.

Sources