ArbNation Join free

Firewood cutting safety on private land: what extension services and HSE publish

Extension services in New Hampshire and Arkansas print chainsaw safety lists for people who cut wood. HSE's leaflet covers saws used at work, including lone working and kickback.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The facts here come from two extension services and the HSE, on chainsaw use on private land. It is not training and does not teach the work.

Who the rules reach

The UNH Cooperative Extension chapter on staying safe working in the woods, part of Good Forestry in the Granite State, separates loggers from landowners. Loggers and others whose work is tree cutting take safety courses and are usually expected to conform to certain safety practices. Private landowners have no similar requirements but are encouraged to attend chainsaw and other safety classes or orientations and hands-on training. The chapter cites New Hampshire RSA 508:14, which limits landowner liability unless injury is intentionally caused or the conduct is willful, wanton or reckless. Among its recommended practices it lists advice from an insurer or lawyer on coverage.

HSE's leaflet Chainsaws at work (INDG317, revision 2) is written for employers, the self-employed and those who control the use of work equipment. It covers portable, hand-held, petrol-engine chainsaws used at work.

Injury figures

The University of Arkansas fact sheet Chain Saw Safety (FSA1009) quotes the Centers for Disease Control and Prevention: about 36,000 people a year are treated in hospital emergency departments for chainsaw injuries. One analysis it cites found that 70 percent of those injured had more than one year of experience. The sheet adds that OSHA reported 243 workers died in 2012 in tree-trimming and clearing, with four leading causes: struck-by incidents, caught-in incidents, falls from elevations and electrocution from overhead power lines. Injury risk rises after storms, when saws are widely used to clear fallen trees.

Protective equipment

Body partUNH Cooperative ExtensionUniversity of Arkansas
HeadHard hat when felling trees or checking an active logging job. A face visor with built-in hearing protection gives protection and convenienceHard hat against falling limbs or branches. The best helmets have a face guard
EyesEye protection when sawing, cutting brush, weed-whacking or splitting woodSafety glasses or goggles against flying chips, also during wood splitting
EarsHearing protection, because frequent high-decibel noise can cause premature hearing lossEar muffs or plugs. Noise from some gasoline-powered saws can exceed 100 decibels
HandsGood leather gloves, and chainsaw chaps and gloves for legs and hands when using a chainsawLightweight abrasion-resistant gloves
Legs and clothingChainsaw chapsFlexible, trim-fitting clothing free of ragged edges. Woodcutter's chaps are recommended for leg protection
FeetSturdy leather boots at a minimum, and steel-toed boots when chainsawingHeavy work boots or shoes with high tops and steel toes

The Arkansas sheet adds that protective equipment must be inspected before use on each work shift.

Working alone and staying reachable

The UNH chapter opens with a warning: if good safety practices are not followed, working in the woods alone with chainsaws and other equipment can result in swift and serious injury or death. Its practices include working with a partner at a safe distance, keeping a first-aid kit at hand, and telling someone the work location or leaving a note with a good description of it. It lists a well-charged cell phone with a reception check.

HSE's INDG317 says to avoid working alone with a chainsaw. Where that is not possible, it lists arrangements for raising the alarm. They are regular contact by radio or telephone, someone visiting the worksite, a whistle, an automatic signalling device that sends a signal at a preset time, and checks that the operator returns to base or home at an agreed time. It recommends that operators hold an emergency first-aid certificate, and that each carries a personal first-aid kit with a large wound dressing. The guide to working alone in tree work sets out each regulator's lone-working rules.

Fuel, starting and carrying

The Arkansas sheet puts fuel dispensing at least 20 feet from any source of ignition, with the saw shut off, cooled and in an open area. It has the saw started at least 10 feet from the fueling area, on the ground or another firm support, with the chain brake engaged. Drop starting is never recommended, and the sheet warns against starting the saw on the knee. It has the saw shut off or the brake engaged whenever the saw is carried more than 50 feet or across hazardous terrain.

OSHA's logging standard, 29 CFR 1910.266(e)(2), sets 10 feet for fueling away from an open flame or other ignition source, and 10 feet between the fueling area and where the saw is started. It prohibits drop starting. That standard applies to all logging operations as the section defines them.

Bystanders, kickback and cutting position

The Arkansas sheet keeps bystanders and coworkers at least two tree lengths (at least 150 feet) from anyone felling a tree, and at least 30 feet from anyone limbing or cutting a fallen tree. It has cutting done at waist level or below, with no cutting directly overhead. It also says to be prepared for kickback, with chain brakes, low-kickback chains and guide bars named as saws that reduce the danger.

The UNH chapter advises against working above the head with a chainsaw or from a ladder, stone wall or other object, because of falls and kickback. Extra caution applies when sawing in brush, which can cause kickback. The chapter calls dead, broken or hung branches widow makers.

HSE describes kickback as responsible for a significant proportion of chainsaw injuries, many of them to the face and upper body. A properly maintained chain brake and a low-kickback chain reduce the effect but cannot entirely prevent it. HSE lists ways of working that avoid kickback. They are the nose of the guide bar kept clear of branches, logs and stumps, no over-reaching, the saw kept below chest height, and the left thumb around the back of the front handle. The guide to kickback and chain brakes goes further into the brake.

Logs and firewood lengths

The Arkansas sheet names unexpected log roll and saw kickback as the greatest hazards in bucking. It lists chocking the trunk, working on the uphill side, and keeping a balanced footing. For firewood lengths it describes cuts made about three-fourths of the way through, so that several lengths stay together and the log stays rigid, then the log is rolled and the cuts finished. It also says sawing into the ground dulls the chain. For branches under tension it warns that even a seemingly small one, 2 inches in diameter for example, can be a hazard when released. It closes with splitting wood, where the same protective equipment is worn.

Sources