ArbNation Join free

Fuelling a saw: distance, cool-down and ignition rules from OSHA, HSE and WorkSafe

OSHA sets 10 feet (3 m) from ignition sources for fuelling a chain saw. HSE recommends at least 4 m for fuel containers, and WorkSafe in Western Australia and New Zealand name a cool-down and a 3 m restart distance.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The named regulators and codes are described below as published. It is not training and does not teach the work.

Fuelling clauses by regulator

Fuelling statements in regulator documents
PublisherDistance and ignitionEngine state
OSHA, 29 CFR 1910.266 (US)Fuelled at least 10 feet (3 m) from open flame or other ignition source. Started at least 10 feet (3 m) from the fuelling areaEach portable powered tool is shut off during fueling
OSHA quick card 3269-04R, 2013 (US)Fuel dispensed at least 10 feet from ignition sources on construction activities. No smoking. Saw started 10 feet away with the chain brake engagedNever fuel a running or hot saw
HSE INDG317(rev2), 01/13 (UK)Fuel containers kept well away from fires and ignition sources, including the saw, during starting and use. At least 4 m recommendedNo cool-down figure
WorkSafe WA, updated April 1, 2025Clean area, no smoking, move at least three metres before starting. Fuel and tools stored 10 metres from the cuttingRefuel only after the motor has cooled
WorkSafe NZ, arboriculture code, section 3.1.5No smoking, sparks or open flame near the fuelling point. Open space, and three metres before restartingStop the motor, fill the oil tank first to let the saw cool

Where the distances differ

The United States, Western Australia and New Zealand rules all use about 3 m, but they measure different things. OSHA's 10 feet is the distance from an ignition source to the fuelling, and from the fuelling to where the saw is started. The WorkSafe pages put the 3 m between the fuelling area and the restart. HSE's 4 m is the distance between the fuel container and the saw during starting and use.

The University of Arkansas Cooperative Extension fact sheet FSA1009 prints a larger figure: fuel is dispensed at least 20 feet from any source of ignition. The sheet repeats the shut-off and cool-down points: the saw is shut off before fuelling, never fuelled while running or hot, and refuelled in an open area after it has cooled.

Containers and spills

The New Zealand code lists containers made of metal or other approved material so that contents cannot escape as liquid or vapour. Plastic ones need design verification by an approved Test Certifier. Containers for carrying fuel by foot carry a LAB number or Test Certifier approval, hold no more than five litres and are filled with a five percent air gap. WorkSafe Western Australia names containers that comply with AS/NZS 2906:2001.

HSE describes containers in good condition, labelled and fitted with securely fitting caps, with an auto-filler spout to reduce spillage from over-filling. It adds that filler caps are replaced immediately after fuelling and spilt petrol or oil is wiped up. The Western Australian page and the New Zealand code also have excess fuel wiped off. The OSHA quick card names approved containers and a funnel or flexible hose.

A fire-safety alert on portable petrol equipment

WorkSafe Victoria published a safety alert on August 15, 2024. It reports ten workers burned in separate incidents when fuel vapours ignited during refuelling of portable petrol equipment such as pressure washers, pumps and generators. A vehicle-mounted vacuum unit and a vehicle were also destroyed when petrol vapours ignited by static electricity. The alert is not specific to chain saws.

The alert's measures are no filling in low-lying areas where vapours collect, none inside a vehicle or trailer or on a surface that blocks static discharge, and fire extinguishers within reach. Equipment is left to cool, because petrol can ignite at 280 degrees Celsius. Firm ground, a well-ventilated area, earthing of vehicle-mounted equipment, and containers with the UN approval needed for portable fuel containers complete the list. Drink bottles and plastic five litre oil containers are listed as unsuitable for fuel.

Related pages

Mix ratios and the ethanol limits are on chain saw fuel mix and ethanol. Crew-truck rules for carrying fuel are on carrying saw fuel on a crew truck.

Sources