Hand-arm vibration limits for chainsaw users: Britain, the EU and New Zealand
Great Britain and the EU both set a daily hand-arm vibration action value of 2.5 m/s2 A(8) and a limit value of 5 m/s2 A(8). WorkSafe New Zealand uses the same two numbers in its guidance.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The values below are daily exposure figures, A(8), for the worker.
Action and limit values
| Jurisdiction | Action value | Limit value |
|---|---|---|
| Great Britain, 2005 Regulations, reg. 4(1) | 2.5 m/s2 A(8) | 5 m/s2 A(8) |
| European Union, Directive 2002/44/EC, Art. 3(1) | 2.5 m/s2 | 5 m/s2 |
| New Zealand, WorkSafe guidance | 2.5 m/s2 (8 hour average) | 5 m/s2 (8 hour average), a recommended maximum |
Great Britain
The Control of Vibration at Work Regulations 2005 came into force on 6 July 2005. Regulation 4 sets the daily exposure limit value for hand-arm vibration at 5 m/s2 A(8) and the daily exposure action value at 2.5 m/s2 A(8). For whole-body vibration the same regulation sets 1.15 and 0.5 m/s2 A(8).
HSE describes the action value as the level at which employers should introduce technical and organisational measures to reduce exposure, and the limit value as one that should not be exceeded. HSE's forestry and arboriculture page is blunter on the top figure: exposure above the limit value is prohibited. It puts chainsaws, brush-cutters and stump-grinders among the powered hand-held and hand-guided machines that give off hand-arm vibration.
HSE's regulations page records a transitional period for the hand-arm limit value that ran until 2010, for work where older tools and machinery could not keep exposures under it.
How daily exposure is worked out
Schedule 1 of the 2005 Regulations gives the method. A(8) is the vibration magnitude, in metres per second squared, normalised to a reference duration of eight hours (28,800 seconds). The magnitude comes from root-mean-square acceleration measured in three directions at the surface the hand touches, weighted as British Standard BS EN ISO 5349-1:2001 defines. Where both hands are exposed, the greater of the two magnitudes is used. When a day holds two or more operations with different magnitudes, a combined formula covers them. Part II adds an average over one week, A(8) week, taken across seven consecutive days.
European Union
Article 3 of Directive 2002/44/EC puts the daily hand-arm exposure limit value at 5 m/s2 and the daily exposure action value at 2.5 m/s2, both standardised to an eight-hour reference period. For whole-body vibration it gives 1.15 m/s2 and 0.5 m/s2, or vibration dose values of 21 and 9.1 m/s1.75 at the Member State's choice.
New Zealand
WorkSafe New Zealand's guide for businesses lists chainsaws first among hand-held and hand-guided tools linked to hand-arm vibration syndrome and carpal tunnel syndrome. It recommends a maximum daily exposure of 5 m/s2 as an 8 hour average and expects control measures once workers reach the action value of 2.5 m/s2. It also converts the figures to points: 100 points is the action value, and its worked example adds an angle grinder at 98 points to a power drill at 25 for a total of 123.
The guide names factors that change the dose: the condition of the tool, the vibration intensity, the time per day, the temperature, how hard the worker grips, and the worker's health history. It points to the maker's manual or specification for each tool's vibration figure.
Health effects
HSE names vibration white finger, where blood circulation is affected, plus damage to nerves and muscles in the hand and to wrist tendons, including carpal tunnel syndrome. Together these are called hand-arm vibration syndrome. The guide to hand-arm vibration syndrome in tree work covers the condition. HSE writes that makers must state a vibration emission value in each machine's instruction manual. The guide to saw noise and vibration values covers those declared figures.
Sources
- legislation.gov.uk, The Control of Vibration at Work Regulations 2005 (SI 2005/1093), regulation 4, read October 16, 2026
- legislation.gov.uk, The Control of Vibration at Work Regulations 2005, Schedule 1 Hand-Arm Vibration, read October 16, 2026
- legislation.gov.uk, Directive 2002/44/EC, Article 3 exposure limit values and action values, read October 16, 2026
- HSE, Control of Vibration at Work Regulations 2005, read October 16, 2026
- HSE, Hand arm vibration in forestry and arboriculture, read October 16, 2026
- WorkSafe New Zealand, Hand-arm vibration: information for businesses, read October 16, 2026