Heat rules for outdoor workers in Australian Capital Territory
The ACT sets no temperature at which outdoor work stops. An approved code of practice on extreme temperatures, in force since November 14, 2025, sits under the Work Health and Safety Act 2011.
Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The national picture is on the Australia heat page, and other places are in the heat rules overview.
At a glance
| Item | Record |
|---|---|
| Instrument | Work Health and Safety (Managing the Risks Associated with Extreme Temperatures Code of Practice) Approval 2025, NI2025-607 |
| Made under | Work Health and Safety Act 2011, section 274, approved codes of practice |
| Notified | November 7, 2025 |
| In force | November 14, 2025 |
| Kind of rule | Approved code of practice with legal duties restated, no numeric heat limit |
What the approval does
The Minister for Skills, Training and Industrial Relations signed the approval on November 6, 2025. The instrument states that the code was developed by the process set out in section 274(2) of the Act. The Legislation Register lists the Act as in force. The code itself is dated November 2025 and carries a Creative Commons Attribution 4.0 licence. It is based on material from Safe Work Australia, WorkSafe ACT, SafeWork NSW and NSW Health.
The legal weight of the code
The code's foreword says an approved code gives practical guidance on meeting the standards the Act and the Work Health and Safety Regulation require. Codes are admissible in court. A court may treat a code as evidence of what is known about a hazard and may rely on it in deciding what is reasonably practicable. An inspector may refer to an approved code when issuing an improvement or prohibition notice. Compliance may also be reached by another method that gives an equivalent or higher standard.
The code uses "must", "requires" and "mandatory" for a legal requirement, and "should" for a recommended course. It applies to all workplaces covered by the Act where exposure to extreme temperatures may occur. It is written for a person conducting a business or undertaking.
The duties it restates
The code states that a person conducting a business or undertaking must manage the risks of working in extreme temperatures. Section 19 of the Act sets the primary duty of care for workers' health and safety, so far as is reasonably practicable. Regulation section 40 covers general workplace facilities, including that workers carrying out work in extremes of heat or cold can do so without risk to health and safety. The same person must consult workers and health and safety representatives when identifying hazards, assessing risks and choosing controls. Officers must exercise due diligence, and workers must take reasonable care of their own safety.
Outdoor heat in the risk assessment
Heat from extreme heat waves has the highest death rate of any natural disaster in Australia, the code's introduction records, and heat waves are usually forecast several days ahead. It sets no air temperature at which work must stop. Its risk-assessment section asks, for outdoor work, whether temperatures are expected to exceed 37 degrees Celsius, and to consider humidity. Radiant heat from the sun, hot machinery and humid air that makes cooling harder are named as risk factors.
The code works through the hierarchy of controls, with these outdoor examples:
- Substitution: planning strenuous work for the cooler part of the day, using machinery instead of manual lifting.
- Isolation and engineering: shade structures, shaded or air-conditioned break areas close to the work, mechanical aids.
- Administrative: lower work rates, easy access to cool drinking water and electrolyte solutions, frequent breaks and a buddy system.
The code calls administrative controls less effective than higher-order controls. It lists topics for worker training, including the temperature management plan for hot days, who monitors heat and humidity, signs of heat-related ill health and acclimatisation. Appendix E is an example template for a temperature management plan.
The three levels in Appendix A
Appendix A is a decision-making approach for heat stress in three levels.
- Level 1, identify, plan and control: a basic risk assessment that can use the Heat stress (basic) calculator, an online tool needing no direct measurement.
- Level 2, technical assessment: a closer look where heat stress is likely or Level 1 leaves a high risk.
- Level 3, limited or cease work: work should not continue unless physiological and environmental monitoring, including a quantitative risk assessment, is in place.
Where workers face severe heat that cannot be controlled, only emergency or public safety work should continue, with all reasonably practicable controls still in use. Appendix C, the first aid fact sheet, lists a body temperature above 39 degrees Celsius among the symptoms of heat stroke.
Sources
- ACT Legislation Register, Work Health and Safety (Managing the Risks Associated with Extreme Temperatures Code of Practice) Approval 2025, NI2025-607, read October 21, 2026
- ACT Legislation Register, NI2025-607 and the approved Managing the Risks Associated with Extreme Temperatures Code of Practice, November 2025 (PDF), read October 21, 2026
- ACT Legislation Register, Work Health and Safety Act 2011, A2011-35, read October 21, 2026