ArbNation Join free

Knee ascenders: which standards and codes cover them

No code, standard or journal paper opened for this guide uses the term knee ascender. What the codes say about mechanical ascenders in general is below, with the one published drop-test study.

Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.

The named codes, standards bodies and journals are described here as published. It is not training and does not teach the work.

The gap

The term knee ascender does not appear in any of five documents. They are the SafeWork NSW Tree works code of practice, the WorkSafe New Zealand arboriculture code and Part 41 of the Alberta Occupational Health and Safety Code. The other two are the British Standards Institution page for EN 12841 and the Arboriculture & Urban Forestry drop-test paper. The word "knee" turns up in the NSW code only in a line about starting a chainsaw held between the knees. In the New Zealand code it turns up only in a lifting note about bending the knees.

So there is no code wording on knee ascenders to report.

How the codes define an ascender

The codes define the general device. WorkSafe New Zealand calls an ascender a mechanical device that slides upwards on a rope and grips when pulled in the opposite direction. SafeWork NSW defines it as a knot or mechanical device used for ascending a rope and positioning the climber in the tree.

SafeWork NSW section 4.6

Section 4.6 of the NSW code, Mechanical ascenders, descenders and rope grabs, lists points to be considered when selecting, using and maintaining them.

  • They should be compatible with the rope specifications of the system, with special attention to the recommended rope diameters for each device.
  • They should be self-locking, or used with another device that is self-locking.
  • Faulty or defective equipment is removed from service until repaired and assessed as fit for use.
  • When mechanical ascenders are used, consideration should be given to a backup (secondary attachment) on the main climbing line in case the ascender fails mechanically.

The standard for rope adjustment devices

BS EN 12841:2024 is titled Personal fall protection equipment, Rope access systems, Rope adjustment devices. BSI lists it as current and under review, published March 31, 2024, and identical to EN 12841. Its descriptors include locking and locating devices, performance testing and instructions for use. The BSI page is a catalogue entry and does not print the clauses.

Alberta's Part 41 sets a rule for industrial rope access: an ascender made on or after July 1, 2009 is approved to CEN EN 567:1997, UIAA 126:2004 or NFPA 1983 (2006 edition). The rule is for rope access systems, and the code does not say it applies to tree work.

The published drop tests

Brian Kane tested toothed ascenders on four arborist climbing ropes in March and April 2010 and reported in Arboriculture & Urban Forestry, July 2011. The method followed the EN 12841:2006 test for Type B rope grabs, with changes, using an 86 kg mass.

Of 67 tests, the arrest distance met the standard's limit of 2 metres or less only 10 times. Impact loads averaged more than five kN, and adding a backup friction hitch raised them to more than six kN. Two tests with a 110 kg mass cut one rope completely through. The paper notes that makers set explicit limits on ascender use and that many are exceeded in tree climbing. It adds that a Type B rope grab on a working line goes with a safety line fitted with a Type A rope grab. The paper does not mention knee ascenders, so its findings are not about them.

Sources