ArbNation Join free

Ladder rules for tree work: OSHA 1910.23 and 1926.1053, WorkSafeBC Part 13 and HSE

OSHA's construction rule 1926.1053 sets a ladder angle of one-quarter of working length and a 3-foot extension at the landing. WorkSafeBC says about 75 degrees and about 1 metre. HSE says ladders are not banned.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The texts are OSHA's general industry ladder rule (29 CFR 1910.23), OSHA's construction ladder rule (29 CFR 1926.1053), Part 13 of the British Columbia Occupational Health and Safety Regulation, and an HSE page on ladders and stepladders. None of them is written for tree work alone.

OSHA 1926.1053: use of ladders

Paragraph 1926.1053(b) sets the rules for use. The table gives the ones that bear on a ladder set against a tree, a structure or a landing.

Item1926.1053(b)
Extension above a landing(b)(1): side rails extend at least 3 feet (0.9 m) above the upper landing surface. Where the length does not allow it, the ladder is secured at the top to a rigid support that will not deflect, with a grasping device such as a grabrail
Angle(b)(5)(i): for a non-self-supporting ladder, the horizontal distance from the top support to the foot is approximately one-quarter of the working length
Surface(b)(6) and (b)(7): stable and level surfaces unless the ladder is secured to prevent displacement. Slippery surfaces call for securing or slip-resistant feet, and the rule says the feet are not a substitute for care in placing, lashing or holding the ladder
Electrical equipment(b)(12): nonconductive siderails where the employee or the ladder could contact exposed energized electrical equipment
Three points of contact(b)(20) to (b)(22): the user faces the ladder, uses at least one hand to grasp it, and carries nothing that could cause a loss of balance and a fall
Load(b)(3): not loaded beyond the maximum intended load or the maker's rated capacity
Inspection and defects(b)(15) and (b)(16): a competent person inspects for visible defects periodically and after any occurrence that could affect safe use. Defective portable ladders are marked or tagged "Do Not Use" and withdrawn until repaired
Moving(b)(11): ladders are not moved, shifted or extended while occupied

The rule also says the top or top step of a stepladder is not used as a step, and single-rail ladders are not used.

OSHA 1910.23: general industry

Paragraph 1910.23(b) lists general requirements for all ladders, and each one is the employer's duty. Ladders are inspected before initial use in each work shift and more often as needed to find visible defects. A ladder with structural or other defects is tagged "Dangerous: Do Not Use" and removed from service until repaired or replaced. Employees face the ladder, use at least one hand to grasp it, and carry nothing that could cost them balance.

Paragraph 1910.23(c) covers portable ladders. They are not loaded beyond the maximum intended load, which per the note in the rule includes the employee and all tools, equipment and materials carried. They are used on stable and level surfaces unless secured or stabilised. Side rails extend at least 3 feet (0.9 m) above an upper landing surface, and ladders are not placed on boxes, barrels or other unstable bases to gain height.

WorkSafeBC Part 13

Part 13 of the British Columbia regulation, Ladders, Scaffolds and Temporary Work Platforms, has its ladder rules in Division 2. Section 13.3, outside that division, has ladders inspected before use on each shift and after any modification. Section 13.5 calls for a portable ladder on a firm and level surface and long enough for the work. A non-self-supporting ladder leans at an approximate angle of 75 degrees from horizontal. If it gives access to an upper landing, it projects approximately 1 m (3 ft) above that landing and is sufficiently secured for access and egress.

Section 13.6 says that if work cannot be done from a ladder without hazard to a worker, a work platform must be provided. A worker does not carry heavy or bulky objects, or other objects that make ascent or descent unsafe, up or down a ladder. Section 13.4 has manufactured ladders marked for the grade of material and the use for which they are built.

HSE

HSE's page Safe use of ladders and stepladders (updated June 5, 2024) opens with this: ladders and stepladders are not banned under health and safety law, and the law calls for a sensible, proportionate approach to managing risk. HSE calls ladders a sensible and practical option for low-risk, short-duration tasks, although they should not automatically be the first choice. The page points to the leaflets Safe use of ladders and stepladders: A brief guide (LA455) and Working at height safely: A brief guide (INDG401).

Pole saw work near power lines is covered in the guide to pole saws, ladders and power lines.

Sources