ArbNation Join free

Measuring trunk diameter (DBH): rules for slopes, forks and multi-stem trees

Diameter at breast height is taken 4.5 feet up the trunk, with set rules for slopes, lean, forks and multiple stems. New York DEC and the Forest Service's Urban FIA field guide print them.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The New York State Department of Environmental Conservation (DEC) says tree diameter is usually measured at 4.5 feet above ground level, called diameter at breast height or DBH. A diameter tape (d-tape) from arborist or forestry suppliers reads it directly. Its guidance for Urban and Community Forestry grant projects draws on the simplest and most widely accepted methods from the US Forest Service, the International Society of Arboriculture and FEMA.

Slopes, lean, taper and bumps

New York DEC puts the measuring point for each odd trunk shape in a short rule. The Urban FIA National Field Guide agrees on slopes: 4.5 feet above the ground line on the uphill side of the tree.

Trunk situationNew York DEC rule
SlopeDiameter at 4.5 ft from the ground on the upper side of the slope
Lean4.5 ft up the stem, in the direction of the lean
Abnormal taperThe smallest point, with the height of the measurement recorded
Branches or bumps at DBHBelow the branch or bump, with the height recorded. The Forest Service measures immediately above where the bumps or branches stop affecting the stem

Version 9.5 of the Urban FIA field guide, dated September 2025, rounds each reading down to the last 0.1 inch. A reading of 3.68 inches is recorded as 3.6 inches.

Forks and multiple stems

New York DEC measures a tree that forks below or near DBH at the narrowest part of the main stem below the fork, and records both heights. A trunk that splits above 6 inches from the ground has three acceptable methods. They are the square root of the sum of the squared stem diameters (5, 6 and 8 inches give 11 inches), the average of the stems, or the sum of the stems. DEC calls the sum the least preferred, because the larger total has caused confusion in benefits calculations. Trees that fork at or within 6 inches of grade are treated as multiple trees, consistent with the Forest Service and FEMA.

The Urban FIA guide sets a stricter test for what counts as a fork. The stem must be at least one third the diameter of the main stem. It must branch out at an angle of 45 degrees or less, and must have or be able to assume a tree-like form and function rather than a branch-like one. Stems under 1 inch in diameter are not forks.

  • Forks below 1.0 foot are separate trees, each measured at 4.5 feet.
  • Forks between 1.0 and 4.5 feet are also separate trees, with each fork measured 3.5 feet above the pith intersection.
  • A tree forked at or above 4.5 feet counts as one tree.
  • Three or more forks from about the same point, or prolific branching, trigger the Measure Low Approach. The diameter is taken at the highest, most repeatable location between the 1-foot stump and the first pith separation.

Research on multi-stem street trees

A 2020 paper in Urban Forestry and Urban Greening, indexed by the USDA Forest Service Treesearch, examined street trees that fork between 30 and 137 cm. The authors surveyed 25 urban forestry practitioners in twelve northeastern US cities and measured 569 trees of Malus, Prunus and Zelkova in Philadelphia. They found no substantial difference between methods in how well diameter predicted total height and average crown width.

Practitioners reported that current measuring at 137 cm is burdensome. For trees that fork in that range, the authors recommend a single diameter at a lower height, either just below the fork or at 30 cm. They link 30 cm to tracking radial growth over time, and a measurement below the fork to practitioners who do not need fine resolution.

British Standard 5837

BSI lists BS 5837:2012, Trees in relation to design, demolition and construction. Recommendations, published 30 April 2012 and marked current, under review. It supersedes BS 5837:2005. BSI's catalogue page gives the title, edition and scope, and prints no measuring clause. The guide to the BS 5837 tree survey covers its role in the UK.

Sources