ArbNation Join free

OSHA State Plans: the tree-care rules California, Michigan and Oregon write themselves

OSHA counts 22 State Plans that cover private employers. California, Michigan and Oregon each print a rule set for tree work: Article 12 of Title 8, MIOSHA Part 53 and Oregon Division 2/R.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. OSHA describes a State Plan as a workplace safety program that a state or territory runs with OSHA approval. OSHA monitors the plans, and each must be at least as effective as OSHA in protecting workers. Which states run a plan is listed in the guide to OSHA State Plans and tree work, and more states are in the tree work rules by state guide.

Plans with a tree-care rule of their own

Tree-specific rules in three State Plans
State PlanRuleScope as printed
California8 CCR Article 12, sections 3420 to 3428Work performed and equipment used in tree and ornamental palm maintenance and removal
MichiganMIOSHA General Industry Part 53, tree trimming and removalFour groups of rules: general provisions, work practices, tools and equipment, hand and portable tools
OregonOAR 437-002-0301, Division 2/RRequirements for the tree and shrub service industry covering trimming, pruning, bracing, removal and surgery

OSHA's State Plans page also features Virginia's efforts to increase worker safety related to tree trimming.

California, Title 8 Article 12

The Department of Industrial Relations prints section 3420 as the scope and definitions of Article 12, in the General Industry Safety Orders. Date palm fall protection is sent to sections 3458 and 3458.1. Line clearance tree trimming near high voltage energized conductors is sent to Article 38 of the High-Voltage Electrical Safety Orders. The definitions include a qualified tree worker, a drop zone, a work-positioning lanyard, a tree climbing system and the felling notch types. Proximity means within 10 feet of energized overhead conductors rated 50 kV or less.

Section 3421 requires an Injury and Illness Prevention Program and puts each work location under the direction of a qualified tree worker. Training covers job hazards, equipment, poisonous plants and harmful animals, and electrical hazards, and the employer documents it. A job briefing by a qualified tree worker comes before each work assignment. Rescue procedures and aerial rescue training are required, and so are first aid and CPR training, with two trained persons at field work involving two or more employees.

Michigan, Part 53

The Cornell Legal Information Institute prints Part 53 of the Michigan Administrative Code under the Department of Labor and Economic Opportunity as Tree Trimming and Removal. Its sections run R 408.15301 to R 408.15321 for general provisions, R 408.15331 to R 408.15338 for work practices, R 408.15341 to R 408.15348 for tools and equipment and R 408.15351 to R 408.15363 for hand and portable tools.

Oregon, Division 2/R

Oregon OSHA's tree and shrub services page places the requirements for the industry in Division 2/R, OAR 437-002-0301. They do not apply to agricultural crops or crop services, or to tree trimming within 10 feet of any high voltage (600 volt) power lines or equipment. Oregon OSHA also lists two guides on landscaping contractors and tree and shrub services, dated September and December 2022.

Federal OSHA beside the plans

OSHA's tree care industry page says tree care hazards are addressed in specific OSHA standards for recordkeeping and general industry. It describes tree care companies as offering pruning, removal, plant health care, cabling and bracing, transplanting, consulting, fertilization and lightning protection.

Sources