ArbNation Join free

How much crown to remove at one time: the figures extension services and forest services print

Maryland's Forest Service prints 25 percent of the foliage in a growing season. Kansas State prints 20 percent of the canopy per pruning, Penn State calls a flat 25 percent too broad, and Missouri names 20 percent of the branches at planting.

Checked against the sources at the bottom of this page on October 9, 2026. Rules, fees and pay change: the source has the last word.

This page does not say how much to remove from any tree. The guide to pruning standards by country covers ANSI A300, BS 3998 and AS 4373, the standards behind these figures.

The figures by source

SourceFigureWhat it applies to
Maryland Department of Natural Resources Forest Service, Tree Expert exam study guide on pruningNot more than 25 percentThe foliage of a branch or limb cut back to a lateral, in a single growing season. The guide adds that the Forest Service recommends not more than 25 percent of the foliage on a mature tree within a growing season.
Kansas State University and Kansas Forest Service, publication MF3551 (Tim McDonnell, March 2021)No more than 20 percentA properly thinned tree's canopy removed during any single pruning, usually for most species and circumstances.
Penn State Extension, Pruning Landscape Trees (updated November 5, 2021)No flat figureThe total amount of live branches or foliage removed should be based on tree vigor. Up to 25 percent per year was the older guidance and is too broad for all trees. Healthy young trees withstand wounding better than mature ones.
University of Missouri Extension, Pruning and Care of Shade Trees (G6866, reviewed March 2026)20 percentBranches removed when planting a tree dug from a nursery. Removing more than about that share may reduce the tree's ability to produce food through photosynthesis and slow establishment.

Size ratios

Several of the sources give a size ratio instead of a share of the crown. In Maryland's guide, the lateral a branch is cut back to should be at least one third the diameter of the removed portion so it can take over as the lead. The ISA Trees Are Good page on pruning describes reduction as cutting leaders and branch ends back to secondary branches large enough to take over the terminal role, at least one third the diameter of the cut stem. This keeps form and structure better than topping. The Arboricultural Association guide to tree pruning gives BS 3998:2010, under which the diameter of the final cut should not exceed one third of that of the parent branch or stem, to keep the wound as small as possible.

When more is taken

Missouri's sheet puts it this way: excessive pruning may weaken a tree by removing too much leaf area and the food reserves stored in the stem. The apparent invigorating effect of pruning is only growth forced into fewer buds. Kansas State describes lion tailing as excessive thinning or removal of the interior branches, which leaves most of the foliage on the branch ends. The consequences are less photosynthesis, a surge of new growth that can raise water stress, possible sunscald on the tops of branches or the trunk, and branches with weight at the ends that fail in wind or ice. The practice is largely driven by public demand, and homeowners tend to feel more material removed means more value. Maryland's guide adds that lion's tailing reduces branch taper, sunburns bark and weakens branch structure, and that topping and lion's tailing are unacceptable practices.

Crown thinning

Maryland's guide describes crown thinning as selective removal of live branches to reduce crown density. The branches left are spread evenly along each branch and through the crown. The percentage of foliage and the location and size of the parts removed are to be specified.

Sources