Respirators for tree work: OSHA 1910.134, NIOSH classes, HSE HSG53 and WorkSafeBC
NIOSH approves nine filter classes, from N95 to P100, under 42 CFR 84. OSHA 1910.134 requires a written program, and HSE guide HSG53 lists wood dust and sprayed pesticides among the airborne hazards.
Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. None of the five documents is written only for tree work. They name substances such as wood dust and sprayed liquids, not chipping, grinding or milling by name.
The filter classes under 42 CFR 84
Title 42 of the Code of Federal Regulations, part 84, is the NIOSH approval rule for respirators. Section 84.170 sorts non-powered air-purifying particulate respirators into three series by oil resistance and sets a minimum filter efficiency for each level.
| Series | Oil aerosols |
|---|---|
| N-series | Restricted to workplaces free of oil aerosols |
| R-series | Intended to remove any particulate, including oil-based liquid particulates |
| P-series | Intended to remove any particulate, including oil-based liquid particulates |
The efficiency levels are 95 percent for N95, R95 and P95, 99 percent for N99, R99 and P99, and 99.97 percent for N100, R100 and P100. The NIOSH filtering facepiece page counts nine classes in all and explains that 99.97 percent filters are labelled 100. It describes the R-series as somewhat resistant to oil and the P-series as strongly resistant.
An approved filtering facepiece shows the word NIOSH, its class such as N95, and a testing and certification approval number in the form TC 84A-XXXX. NIOSH keeps a Certified Equipment List for checking a number. Surgical N95 masks, which have a splash-resistant outer layer, are described as not necessary outside healthcare.
OSHA 1910.134
The OSHA respiratory protection standard puts engineering controls first. When they are not feasible, or while they are being put in place, appropriate respirators shall be used (paragraph (a)(1)). The employer selects a NIOSH-certified respirator based on the hazard and user factors, and the respirator is used in compliance with its certification (paragraph (d)(1)).
Where respirators are necessary or required, paragraph (c)(1) requires a written program with worksite-specific procedures. It covers selection, medical evaluation, fit testing, use, cleaning, storage and maintenance. A medical evaluation comes before the fit test or required use (paragraph (e)).
Tight-fitting facepieces must pass a qualitative or quantitative fit test before first use, when a different facepiece is used, and at least annually (paragraph (f)). Where use is voluntary, paragraph (c)(2) has the employer give the user the information in appendix D. The employer must also see that the voluntary user is medically able to use it and that the respirator is cleaned, stored and maintained. A written program need not cover employees whose only voluntary use is of filtering facepieces (dust masks).
Great Britain: HSG53
HSE's guide Respiratory protective equipment at work, HSG53 (fourth edition, 2013), covers why RPE is used, what the law says and how to select it. Its table of hazardous substances lists wood dust and engine exhaust particles under solid particles. Sprayed liquids, with pesticides as an example, fall under liquid particles. Engine exhaust gases are listed as gas.
For disposable half masks, HSG53 gives the classes FFP1, FFP2 and FFP3, with protection factors of 4, 10 and 20. It calls them effective against solid or liquid particles, requiring a fit test, and meeting BS EN 149. Continuous wear time is listed as under one hour. Masks marked NR (not reusable) are disposed of after a single shift of 8 hours. The guide's fit test paragraphs name facial hair as a factor in the seal.
British Columbia
WorkSafeBC says employers must provide appropriate respirators wherever workers are exposed to hazardous substances in the air: gases, vapours, dusts, fibres, mists, fumes and bioaerosols. Different hazards need different respirators, and some need the right filter or cartridge. Amendments to Part 8 of the OHS Regulation on face seal take effect November 6, 2026.
Sources
- OSHA, 29 CFR 1910.134, Respiratory protection, read October 15, 2026
- Health and Safety Executive, Respiratory protective equipment at work, HSG53, fourth edition, 2013, catalogue page, read October 15, 2026
- Health and Safety Executive, Respiratory protective equipment at work: A practical guide, HSG53 text, read October 15, 2026
- Electronic Code of Federal Regulations, 42 CFR Part 84, Approval of Respiratory Protective Devices, read October 15, 2026
- CDC NIOSH, Filtering Facepiece Respirators, read October 15, 2026
- WorkSafeBC, Respiratory protection, read October 15, 2026