ArbNation Join free

Ring-porous and diffuse-porous wood: what the difference means

In ring-porous wood the large vessels cluster in the early part of each growth ring, as in oak and ash. In diffuse-porous wood the vessels stay similar in size across the ring, as in maple and birch.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The USDA Forest Products Laboratory Wood Handbook (2021), the University of Missouri Extension and an FAO working paper on planted forests use the same two terms for hardwood. Softwoods have no vessels, so neither term applies to them.

Ring types in porous hardwoods

The Wood Handbook says porous woods, the hardwoods, have vessels, and that on a cross-section the vessels show as large openings called pores. Vessel diameter runs from under 30 micrometres to over 300, most often 50 to 200. The handbook sorts the growth rings of porous woods into two main types and one in between.

Porous hardwood ring types, USDA Wood Handbook
TypeVessels across the ringExamples named
Diffuse-porousSimilar in size from early to late wood, or a gradual change with no clear edge between the twoMaple, birch, aspen and cottonwood, yellow-poplar
Semi-ring-porousFalls between the other twoBlack walnut, persimmon
Ring-porousAbrupt change, with vessel diameters dropping sharply, often by an order of magnitude or moreHackberry, white ash, shagbark hickory, northern red oak

In ring-porous wood the result is a band of large earlywood vessels around the inner part of the growth increment, then denser, more fibrous latewood.

The Missouri Extension wording

MU Extension, in a 2017 piece by Hank Stelzer, uses springwood and summerwood for early and late wood. It says an abrupt change from large thin-walled springwood cells to smaller thick-walled summerwood cells defines the wood as ring porous, with oak as the example. If the large pores are spread evenly through both springwood and summerwood, the wood is diffuse porous, with maple as the example, even where the annual rings can be seen.

Climate and geography

The FAO paper links ring-porous wood to seasonal climates with long cold periods that halt growth. It also finds a few ring-porous hardwoods in the tropics, in monsoon conditions with a short growing season. Diffuse-porous hardwoods dominate the tropics and are also common in the temperate zone. The Wood Handbook adds that most tropical hardwoods are diffuse-porous, and names teak and the Spanish-cedars as best-known exceptions, ring-porous and semi-ring-porous. It also says that in genera spanning temperate and tropical zones, the temperate species are often ring-porous and the tropical ones diffuse-porous: oaks, ashes and hackberries native to the tropics are diffuse-porous, while their temperate relatives are ring-porous.

FAO gives the same effect for planted trees. Ring-porous woods like oak that adapt to tropical conditions can become diffuse-porous, and it names oaks in Mexico and southern Japan.

Strength and growth rate

For ring-porous hardwoods, FAO says strength usually rises with wider rings. The weak large-pore earlywood zone stays about the same width, so added growth is stronger latewood. It notes that US makers of baseball bats and tool handles set upper limits on rings per inch in ash and hickory. For diffuse-porous woods it finds strength less tied to growth rate.

FAO also treats internal growth stress. It names high-density diffuse-porous hardwoods growing fast as the most prone to large unrelieved stress. Ring-porous woods, because the earlywood is so weak, can relieve some stress in the living tree, though they are not immune to stress defects.

Finishing and sapwood

The Wood Handbook's finishing chapter contrasts fine-textured diffuse-porous aspen, easy to finish, with red oak, whose very large clustered vessels can leave an uneven finish. FAO adds that sapwood width in ring-porous hardwoods is somewhat more sensitive to growth rate.

Sources