Utility arborist and line clearance tree trimmer: the qualified-worker rules and the ISA credential
OSHA 1910.269 separates qualified line-clearance tree trimmers from trimmers who are not qualified employees, with different training for each. ISA runs a Certified Arborist Utility Specialist credential for people already in utility work.
Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The text below describes what the named codes and training bodies publish. It is not training and does not teach the work. The code is the US Occupational Safety and Health Administration's 29 CFR 1910.269, electric power generation, transmission, and distribution.
Where line-clearance tree trimming sits in 1910.269
Paragraph (a)(1)(i)(E) covers line-clearance tree trimming done to clear space around electric power generation, transmission or distribution lines or equipment, on behalf of an organization that operates or controls the operating procedures for those lines. The standard defines the work as pruning, trimming, repairing, maintaining, removing or clearing trees, or cutting brush, within 3.05 metres (10 feet) of electric supply lines and equipment at voltages to ground of 50 kilovolts or less. Above 50 kilovolts it adds 0.10 metres (4 inches) for every 10 kilovolts over 50.
Two groups of workers appear in that paragraph, and the rules differ for each:
- Qualified employees: the entire section applies, except paragraph (r)(1).
- Line-clearance tree trimmers who are not qualified employees: paragraphs (a)(2), (a)(3), (b), (c), (g), (k), (p) and (r) apply.
The two definitions
| Term | Definition in 1910.269 |
|---|---|
| Qualified employee | An employee knowledgeable in the construction and operation of the electric power generation, transmission and distribution equipment involved, along with the associated hazards. The employee must have the training required by paragraph (a)(2)(ii). |
| Line-clearance tree trimmer | An employee who, through related training or on-the-job experience or both, is familiar with the special techniques and hazards involved in line-clearance tree trimming. |
A note to the second definition says a line-clearance tree trimmer is not a qualified employee unless he or she has the paragraph (a)(2)(ii) training. Under the electrical safety-related work practices standard in subpart S, the same trimmer counts as a qualified employee. An employee on a trimming crew who is in on-the-job training, has shown an ability to do the duties safely and works under the direct supervision of a line-clearance tree trimmer is treated as one for those duties.
Qualified-employee training
Paragraph (a)(2)(ii) says each qualified employee shall be trained and competent in five things:
- Telling exposed live parts from other parts of electric equipment.
- Determining the nominal voltage of exposed live parts.
- The minimum approach distances for the voltages involved, and keeping them.
- The special precautionary techniques, protective equipment, insulating and shielding materials, and insulated tools for working on or near exposed energized parts.
- Recognising electrical hazards and controlling or avoiding them.
Paragraph (a)(2)(iii) gives a line-clearance tree trimmer who is not a qualified employee the first three of those. Training may be classroom or on-the-job, and the employer must check compliance through regular supervision and inspections at least once a year. OSHA treats a task done less often than once a year as needing retraining before the work practices are used.
Paragraph (r), line-clearance tree trimming
Paragraph (r) adds rules for this work and its equipment. Under (r)(1), which does not apply to qualified employees, the voltage of the lines is determined before an employee climbs, enters or works around a tree. A second line-clearance tree trimmer within normal voice communication is required in three cases. One is approaching within 3.05 metres (10 feet) of a conductor or apparatus energized above 750 volts. The others are removing branches closer than the table distances to such lines, and roping branches from such conductors.
Work is barred in adverse weather. The standard's note presumes thunderstorms in the immediate vicinity, high winds, snow storms and ice storms to make the work too hazardous. Workers doing the job after a storm must be trained in its special hazards. Paragraph (r) also sets rules for brush chippers.
The ISA credential and the job as O*NET describes it
The International Society of Arboriculture runs the Certified Arborist Utility Specialist credential. Applicants must already be an ISA Certified Arborist. They also need one of three kinds of experience:
- 2,000 hours of direct experience in electric utility vegetation management over the past two years.
- 36 cumulative months of full-time work as an electric utility arborist, forester or vegetation manager in the last 10 years.
- 36 cumulative months of full-time project work as a contract employee or consultant in electric utility vegetation management in the last 10 years.
The exam covers electric utility pruning, program management, integrated vegetation management, electrical knowledge, customer relations and storm response.
O*NET files tree trimmers and pruners under 37-3013.00 and lists supervising tree trimming crews and training lower-level staff among their tasks. It does not list utility arborist as a job title.
Sources
- US Department of Labor, OSHA, 29 CFR 1910.269 Electric power generation, transmission, and distribution, text including (a)(1), (a)(2) and the definitions, read October 15, 2026
- International Society of Arboriculture, ISA Certified Arborist Utility Specialist, read October 15, 2026
- O*NET OnLine, Summary Report for 37-3013.00, Tree Trimmers and Pruners, read October 15, 2026