ArbNation Join free

Hearing protectors with radio, Bluetooth or comms: EN 352-6, -7 and -8 and the noise rules

BS EN 352 splits hearing protectors with audio or level-dependent functions into parts: part 6 for safety-related audio, part 7 for level-dependent earplugs, part 8 for entertainment audio. HSE's L108 caps entertainment audio at 82 dB(A) at the ear.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The sources are BSI's catalogue entries for BS EN 352 parts 6, 7 and 8, HSE's guide L108 (Controlling noise at work, third edition, 2021) and OSHA's occupational noise rule, 29 CFR 1910.95. Makers are not named.

EN 352 parts for audio and electronics

BSI lists the European standard on hearing protectors as a multi-part series, EN 352. Parts 6, 7 and 8 deal with audio input and level-dependent functions. L108 adds that the series supplements the Personal Protective Equipment (Enforcement) Regulations 2018 and sets features such as size, weight and durability.

Part and typeWhat BSI's entry records
BS EN 352-6:2020, earmuffs with safety-related audio inputApplies to earmuffs with a safety-related audio input. The signal can come by electrical input or by other communication such as Bluetooth. It sets requirements for construction, design, performance, marking and user information. BSI says these earmuffs are meant to give speech information and warning signals while attenuating outside sound. Published 30 November 2020, listed as current and under review. It supersedes EN 352-6:2002
BS EN 352-7:2020, level-dependent earplugsApplies to level-dependent earplugs, which restore external sound while attenuating high levels. Its criterion levels are set to limit the sound pressure level effective at the ear to 85 dB(A). Published 30 November 2020, listed as current and under review. It supersedes EN 352-7:2002 and adds new requirements on criterion levels
BS EN 352-8:2020, entertainment audio earmuffsApplies to earmuffs with an entertainment audio facility, wired or wireless. The 2020 edition added products with Bluetooth and new requirements for electrical audio input. BSI lists this 2020 edition as withdrawn on 9 April 2024

BSI files all three under committee PH/7 and the classification for head protective equipment. Part 7 covers earplugs.

Safety audio and entertainment audio in L108

L108 treats protectors with an external audio input as one group. They are built to reduce ambient noise while relaying alarms, speech or entertainment such as radio or music, through wired or wireless systems. The wearer is exposed to both the attenuated ambient noise and the audio signal.

L108 names two main types, one for entertainment and one for safety or work-related communication. For entertainment earmuffs, the relayed signal is limited to 82 dB(A) at the ear for all input levels up to the maker's stated maximum. For earmuffs that carry safety-related communication, such as speech and warning signals, the audio input is not limited, because the information received might matter for safety.

L108 adds that the maker should state the input signal level that corresponds to 82 dB(A) at the ear, called the criterion voltage. It gives a formula for the longest time the audio facility can be used before the upper exposure action value is reached: 8 hours multiplied by the square of the criterion voltage over the highest RMS voltage input.

Two further L108 points apply to two-way systems. A microphone for two-way communication should be switched off when not in use, to avoid reproducing workplace noise at the ear. And the risk of system failure needs to be considered when earmuffs relay safety-related communication.

Level-dependent protectors and warning sounds

L108 describes level-dependent protectors, also called sound restoration protectors, as built to protect against hazardous noise while allowing good communication when it is quieter. They usually relay outside sound to the ear electronically when the outside level is low. L108 says they suit intermittent noise best.

On warning signals, L108 refers to BS EN ISO 7731 for selecting auditory danger signals and says a simple listening test on site can be the most effective check. In its words, hearing an alarm while listening for it is not enough, and the alarm must attract attention over background noise. L108 also says speech intelligibility can improve with level-dependent protectors or with protectors that have communication facilities.

Helmet-mounted muffs and noise limits

L108 lists helmet-mounted earmuffs as individual cups fitted to a hard hat or visor, usually on adjustable arms. It says the noise-protection information should be obtained for the specific combination of earmuff and helmet, and that the seals should not sit against the side of the helmet for long periods.

The UK Control of Noise at Work Regulations 2005, reprinted in L108, set a lower exposure action value of 80 dB (A-weighted) daily or weekly and 135 dB (C-weighted) peak. The upper values are 85 dB and 137 dB. The exposure limit values are 87 dB and 140 dB. Hearing protection is taken into account for the limit values, not for the action values.

L108 says the performance data supplied with protectors that meet EN 352 comes from the test in BS EN 13819-2. Non-passive protectors, which include level-dependent types and those with communication facilities, are tested with extra procedures. L108 says BS EN 458 sets the selection method for them.

The United States rule and the NRR

OSHA 29 CFR 1910.95(j) requires the employer to evaluate hearing protector attenuation for the noise environment. Protectors must reduce exposure to an 8-hour time-weighted average of 90 decibels, or 85 decibels or below for an employee with a standard threshold shift.

Appendix B to 1910.95 explains that the Noise Reduction Rating, developed by the Environmental Protection Agency, must show on the protector package. For an A-weighted reading the appendix subtracts 7 dB from the NRR first. L108 states that employers in Great Britain should obtain SNR data from the supplier and not use the North American NRR.

Neither 1910.95 nor its appendices mention radio, Bluetooth or communication earmuffs, and neither names ANSI S3.19.

Sources