Saw use aloft: what the codes say by country
Four official sources speak to a chainsaw in a tree. New Zealand and New South Wales set two points of attachment for cutting, New Zealand bans drop starts, and the UK sources stress training and rescue cover.
Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. It is not training and does not teach the work.
Saw rules aloft, by source
| Source | On saws aloft |
|---|---|
| HSE, Aerial work, United Kingdom | Training and attachment. Chainsaws should never be used off the ground unless the operator has been adequately trained in safe working techniques. At least 2 people are present during all aerial work, and one of the ground team is available, competent and equipped to do an aerial rescue without delay. Starting and holding. The source prints nothing on this. |
| ICoP, United Kingdom, 3.7 and 3.9 | Training and attachment. Operators who wish to use a chainsaw for work at height should have appropriate training and a relevant certificate of competence or national qualification, unless they are in training and adequately supervised. When tools are used in the tree, particularly cutting tools, all measures are taken to remove or at least cut the chance of striking the systems that connect the operator to the anchors. Starting and holding. Tools are secured in the tree or to the operator's harness before they come off the hauling line. Saw choice weighs the hazard, the work and the operator's skill, with a pruning saw, pole saw, top-handled saw and larger rear-handled saw named as examples. |
| WorkSafe NZ code, 3.1.3, 3.1.4 and 3.1.6, New Zealand | Training and attachment. No person uses a chainsaw for tree work without fully demonstrated competence and practical knowledge in chainsaw operation and tree climbing. The climber takes a secure position at or above the level of the cut and is attached by two anchor points when making cuts aloft. A visual hazard assessment of the tree, including the rooted area, comes before climbing. Starting and holding. Drop starting is prohibited. Aloft, the extended arm technique is used, the saw is held firmly or otherwise kept from moving, and the chain brake is engaged. Saws are secured when used in trees unless there is danger of the saw being trapped and taken with the severed section. A tear-away lanyard or tool strop is called recommended practice. Top-handled saws are not used on the ground. A climbing saw is run with two hands at all times or as the maker's instructions say, and no saw is operated above shoulder height. |
| SafeWork NSW code, 10.8, New South Wales | Training and attachment. Only trained and competent workers use chainsaws in trees. Workers keep two independent means of attachment to suitable anchor points when operating cutting equipment, wherever practicable from independent anchor points. They do not start or operate a saw unless in a safe and stable working position. Starting and holding. The saw is started close to the working position with the chain clear of the operator, obstacles and equipment. In a tree, drop starting may sometimes be necessary under specific conditions, with the saw warmed up on the ground first and the brake applied. Two hands, never above shoulder height, chain brake applied between cuts, and the saw attached, for example by a tool lanyard, when working above ground. The lanyard is long enough for the saw to hang below the climber's feet and carries a weak link. |
| OSHA enforcement memo, June 24, 2021, United States | Training and attachment. The memo prints nothing on this. Starting and holding. For line-clearance tree trimming, 29 CFR 1910.269, paragraph (r)(5), has a gasoline-engine saw started on the ground or where it is otherwise firmly supported. Section 1910.266, paragraph (e)(2)(vi), prohibits drop starting. Section 1910.266, paragraph (e)(2)(i), requires a means to prevent or minimize kickback. |
Where the sources differ
Drop starting is the clearest split. WorkSafe New Zealand lists it as prohibited and gives the extended arm technique for starting aloft. The SafeWork NSW code allows that in a tree the practice may sometimes be necessary under specific conditions. OSHA's memo cites a prohibition. Both New Zealand and NSW keep the saw below shoulder height.
On attachment, the New Zealand and NSW codes agree on two points when cutting. The NSW code adds that these should come from independent anchors wherever practicable. HSE's aerial work page and the ICoP name no number of attachments for saw work. HSE's separate climbing page sets two anchor points for the tree system where possible, each strong enough to support the climber, a subject covered in the guide to tie-in and second attachment rules.
What the sources do not print
The City and Guilds and Lantra award pages for chainsaw work from a rope and harness did not open, and the clause text of ANSI Z133 is not public, so neither is in the table. The awards are covered in the guide to the UK award for chainsaw from rope and harness.
Credits: HSE wording is adapted from pages licensed under the Open Government Licence v3.0. SafeWork NSW text is adapted from the Tree works code of practice (March 2026), copyright State of New South Wales (SafeWork NSW), licensed under Creative Commons Attribution 4.0; changes were made, because the text is summarised and reworded. WorkSafe New Zealand material is summarised from its Approved Code of Practice for Safety and Health in Arboriculture, with the source acknowledged.
Sources
- HSE, Aerial work, tree work safety topics, read October 15, 2026
- Arboricultural Association, Industry Code of Practice for Arboriculture: Tree Work at Height (ICoP), second edition, May 2020, read October 15, 2026
- WorkSafe New Zealand, Approved Code of Practice for Safety and Health in Arboriculture, read October 15, 2026
- SafeWork NSW, Tree works code of practice, March 2026, read October 15, 2026
- OSHA, Inspection Guidance for Tree Care and Tree Removal Operations, enforcement memorandum, June 24, 2021, read October 15, 2026
- HSE, Tree climbing, tree work safety topics, read October 15, 2026