ArbNation Join free

Soil texture classes: sand, silt, clay and what extension says each means for drainage

Texture is the share of sand, silt and clay in a soil. Extension services define the size limits, count twelve classes and describe the feel and ribbon tests used to place a soil on the USDA texture triangle.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

Oregon State, Colorado State, the University of Nebraska-Lincoln, the University of Georgia and a USDA Natural Resources Conservation Service (NRCS) soil scientist writing for University of California Cooperative Extension all define soil texture. None of them is written for tree sites, and the root-specific effects below come only from what they say about drainage, air and water.

Particle sizes

Texture is the relative proportion of sand, silt and clay, the three soil separates. Gravel and stones are not part of it. The NRCS soil scientist and Colorado State print the same limits.

Soil separates by particle diameter
SeparateDiameterFeel
Sand0.05 to 2 mmGritty, wet or dry. The smallest particles visible to the naked eye
Silt0.002 to 0.05 mmSmooth and floury when dry, greasy when wet
ClayUnder 0.002 mmHard when dry, sticky and plastic when wet
Coarse fragmentsOver 2 mmGravel, cobbles and stones, outside the texture count

Colorado State splits sand into very fine, fine, medium, coarse and very coarse. Nebraska's lesson compares a sand grain to a basketball, silt to a golf ball and clay to the head of a pin. The NRCS writer's comparison runs from a BB for clay to a chair for sand. Both are scale pictures, not measurements.

The twelve classes

The Nebraska lesson counts 12 texture classes and groups them into three. Coarse-textured soils are dominated by sand, fine-textured soils by clay and medium-textured soils by silt. The classes are read off the USDA texture triangle, which gives each combination of sand, silt and clay a name. Colorado State's example is a soil with 30 percent clay, 50 percent sand and 20 percent silt, which is a sandy clay loam. Nebraska's example is 24 percent clay, 37 percent silt and 39 percent sand, which is a loam.

The NRCS writer gives class limits. Sandy loam holds 45 to 85 percent sand and up to 20 percent clay. Sandy clay loam holds 45 to 80 percent sand, 20 to 35 percent clay and up to 28 percent silt. Silt loam has under 27 percent clay with more than half of its particles silt-sized. Silt on its own is a rare class that is hard to find in nature. Loam is an even mix with a mellow feel.

Clay has more pull than its share suggests. Colorado State says a soil with only 20 percent clay behaves as a sticky, gummy clayey soil, and that a soil needs 45 to over 60 percent medium to coarse sand to behave as a sandy one. A soil with 20 percent clay and 80 percent sand behaves as clayey.

Feel and ribbon tests

The extension pages describe a moist handful kneaded to a putty, then squeezed into a ribbon over a finger. The ribbon lengths and the University of Georgia chart line up.

Ribbon length and texture, as drawn in the Georgia chart and Colorado State key
RibbonClasses
No ribbonSand, or loamy sand if the ball holds weakly
Weak, under 1 inchSandy loam, loam or silt loam, by how gritty or smooth it feels
Moderate, 1 to 2 inchesSandy clay loam, clay loam or silty clay loam
Strong, over 2 inchesSandy clay, clay or silty clay

Oregon State's soil instructor suggests digging below the organic matter to the mineral layer, about 6 to 8 inches down. A ribbon means clay, and each inch of ribbon is roughly 10 percent clay, so a 4-inch ribbon is about 40 percent. Wet soil that feels gritty is sandy, and the rest is silt. Colorado State also describes a jar test, where sand settles in 1 minute, silt in 2 hours and clay in 1 to 3 days, and the layer depths give percentages for the triangle. In the lab, Nebraska says, a mechanical analysis times how particles fall through water.

Drainage, air and nutrient storage

Oregon State's soil instructor states that texture determines drainage, aeration, water-holding capacity, erosion potential and nutrient storage. Loam holds enough water for plants and drains well enough for roots to breathe. Clay drains slowly and is hard to work, but it is where the soil stores nutrients, because sand and silt do not. Many clay-heavy soils in Oregon's Willamette Valley improve with yearly organic matter, and the instructor expects better drainage in about five years. He also warns that a rototiller can destroy the pores that help water infiltrate and drain.

None of the five pages measures root growth. Research on compaction and rooting is in soil decompaction studies, and lab reports are in soil test report formats.

Sources