ArbNation Join free

Spurs and spikes by country: the rule table

Climbing spurs are limited to removals by SafeWork NSW, and to cases where tree health matters little by the UK ICoP. New Zealand sets no job limit, WorkSafeBC lists spurs for forestry climbers, and OSHA's fact sheet lists them as employer-provided gear.

Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. It is not training and does not teach the work.

The rules by topic

TopicWhat each source prints
Where spikes are usedICoP, United Kingdom, 3.8.7. The code calls spiking invasive and says it "can significantly damage the tree". Use is considered carefully and kept to cases where tree health is of negligible consequence, for example when the tree or section is being removed, or during aerial rescue where the casualty's safety takes priority.
SafeWork NSW, 4.8. Only if the tree is being removed, and not when pruning.
WorkSafe NZ, 3.2.7. No limit by job type is printed.
WorkSafeBC, 26.7.1, forestry operations. Unless the Board accepts other equipment, a climber uses a safety belt, a climbing rope or strap, and climbing spurs. Sections 26.12.0.2 to 26.12.0.6, for tree-climbing outside forestry operations, do not mention spurs.
OSHA fact sheet 3752. No limit printed. Employers must provide protective equipment free, and the sheet lists hard hat, climbing spurs and harness.
Paired with a fall systemICoP. Spiking is not a stand-alone technique and must be used with a personal fall protection system.
SafeWork NSW. Used with a fall prevention system of a work positioning harness and adjustable lanyards.
WorkSafeBC. A second climbing rope or strap is used where the climber must disconnect to pass an obstacle. It is also used where the rope or strap could be severed, unless it is made of material that cannot be severed.
Fitting and sharpeningSafeWork NSW. Fitted, sharpened, stored and maintained to the maker's specifications, made for tree climbing and adjusted to the climber's leg length.
WorkSafe NZ. Sourced from acknowledged suppliers and used to the maker's specifications. Spurs should be kept properly sharpened as the maker recommends.
Checks before useWorkSafe NZ. Climbers check all components for fractures or hairline cracks in the metal portions, misshapen, bent or loose spikes, cut or worn straps, pulled rivets, and damaged or worn buckles, rings and pins. Excessively worn or damaged components are replaced, or the whole spur is removed from service.
WorkSafeBC. A climber inspects climbing equipment before each use.
On the ground, with ropes and in storageSafeWork NSW. Not worn while moving around on the ground, as they can easily puncture legs and feet. Webbing stays on the outside of the climber's legs and clear of the spikes, spikes stay clear of loose ropes, and they are covered with guards or stored separately to protect other climbing equipment.

Where the sources split

The UK and NSW texts both tie spikes to removal. The ICoP also allows aerial rescue and phrases the test as tree health, where NSW states the job. WorkSafe NZ prints no such limit. Its glossary defines spikes, also called spurs or climbing irons, as a climbing accessory attached to the lower leg to gain access to the tree, used with a safety strop. WorkSafeBC names spurs as part of a forestry climber's kit, a different setting from the tree-care work in the other codes.

Gaps

The OSHA enforcement memo of June 24, 2021 and OSHA's tree care standards page carry no wording on spurs. Alberta's Part 39 on tree care operations and the clause text of ANSI Z133 were not opened, so neither appears in the table.

Credits: SafeWork NSW text is adapted from the Tree works code of practice (March 2026), copyright State of New South Wales (SafeWork NSW), licensed under Creative Commons Attribution 4.0; changes were made, because the text is summarised and reworded. WorkSafe New Zealand material is summarised from its Approved Code of Practice for Safety and Health in Arboriculture, with the source acknowledged.

Sources