Stake and tie duration: how long, what ties, and when to remove
Peterborough, New York City and the University of Arizona all put stake and tie removal at one year or sooner. Arizona names 6 to 12 months and lists the tie materials.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
Staking rules for new trees come from two city specifications and one university extension publication. It is not training and does not teach the work.
How long stakes stay on
The City of Peterborough, Ontario, sets one year. Its December 2024 tree planting specification requires the stakes and ties to come out one year after installation, and the contractor disposes of them. New York City Parks keeps stakes through the first year of a two-year guarantee. The 2016 street tree standards then require removal at the end of that first year unless the Forester directs otherwise. Any hole a stake leaves is filled with topsoil of the backfill grade.
The University of Arizona Cooperative Extension publication AZ1022 gives a shorter window. Stake removal falls 6 to 12 months after planting, to prevent girdling, and the publication adds that stakes come off as soon as possible, which is usually within a year. Arizona also limits staking to trees that cannot stand without support or face wind or frost heaving.
Stakes and ties in three specifications
| Source | Stakes and tie | Removal |
|---|---|---|
| Peterborough (2024) | Two wooden stakes, 50 mm square, at least 90 cm above ground, outside the root ball. Tie in a figure-8 loop with a double knot at the stake, fastened at 70 to 80 cm | One year |
| New York City (2016) | Two white cedar stakes, 8 feet long, driven 30 inches deep outside the root ball. Flat woven polypropylene strap, three quarters of an inch wide | End of year one |
| Arizona (AZ1022) | Two stakes outside the root ball, wood about 2 inches across, six inches into undisturbed soil. Smooth, broad ties, one set | 6 to 12 months |
What the ties are made of
Arizona names the suitable tie materials: elastic webbing or tape, cloth, rubber and polyethylene. Wire covered with garden hose or polyethylene tape where it touches the trunk is also used. The tie material is smooth and broad so it does not damage the trunk. Horticultural tape suits small trees, and tie wire or webbing suits larger trees with thick bark.
Arizona sets the tie height by feel. The grower holds the trunk a few inches above the ground and finds the lowest point where the trunk will not bend over. The tie goes about six inches above that point. The wire ends are fastened between the stake and the tree, with enough slack that the trunk and hose move as a unit. That gentle movement helps develop caliper and taper.
Damage from leaving stakes and ties
Arizona warns that ties need periodic inspection and loosening as the tree grows, to avoid girdling the trunk, and that stakes are cut off below the canopy to prevent wounds to branches. The nursery stake comes off at planting time. Peterborough's specification requires removal of all ties, nursery tape and flagging tape from the tree, leaving only the plant species label. New York City's standards add that no tree trunks are wrapped and that nursery tags are removed.
Peterborough ties its figure-8 loop with a double knot at the stake, which the specification describes as a way to prevent girdling.
Sources
- City of Peterborough, Ontario, Tree Planting: Installation and Establishment, Specifications CP 801.01 to 801.04 and CP 801.02, December 2024, read October 16, 2026
- New York City Department of Parks and Recreation, Street Tree Planting Standards for New York City, 2016, read October 16, 2026
- University of Arizona Cooperative Extension, AZ1022, Planting trees and shrubs, revised 11/12, read October 16, 2026