ArbNation Join free

Starting a chainsaw: what OSHA, HSE and HSA publish on drop, ground and brake-on starts

OSHA and California both prohibit drop starting a chain saw. OSHA requires the brake engaged and the start 10 feet (3 m) from fuelling. HSE and the HSA print a 4 m distance and describe ground and thigh starts.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The named regulators are described here as published. It is not training and does not teach the work. Each saw's own manual sets the start method for that saw.

United States: OSHA logging standard

29 CFR 1910.266 is OSHA's logging operations standard. Paragraph (e)(2) covers chain saws and sets these start and fuelling items:

  • The saw is operated and adjusted in accordance with the manufacturer's instructions.
  • The saw is fuelled at least 10 feet (3 m) from any open flame or other source of ignition.
  • The saw is started at least 10 feet (3 m) from the fuelling area.
  • The saw is started on the ground or where otherwise firmly supported. Drop starting a chain saw is prohibited.
  • The saw is started with the chain brake engaged.

Paragraph (d)(9)(iii) of the same standard adds that each machine, vehicle and portable powered tool is shut off during fuelling. The standard also calls for a chain brake on each saw put into initial service after the standard took effect, and for a continuous pressure throttle control that stops the chain when pressure on the throttle is released.

California: tree work article

California's Title 8 section 3425, in the article on tree work, maintenance or removal, covers portable power hand tools. Subsection (a)(2) reads that a power saw is started on the ground or where it is otherwise firmly held or supported to prevent unintended movement of the saw. Chain saws are not drop started. Power saws are not started from a raised position unless the area below is clear of personnel. The subsection was amended in a filing operative October 1, 2020.

Other subsections of the same section bear on a start. A power saw engine is not started and operated unless all employees other than the operator are clear of the saw. Saws carry a clutch adjusted so the chain drive does not engage at idling speed. The section does not use the words chain brake in subsection (a)(2).

Great Britain and Ireland: HSE and HSA leaflets

The HSE leaflet AFAG308 covers top-handled chainsaws for off-ground arboricultural work. It puts the move from the fuelling point at a safe distance, normally at least 4 m, before the saw is started. Its cold start has the saw on the ground with the chain brake applied, and the half throttle mechanism released as soon as the saw has started. A thigh start can be used where conditions prevent a ground start, with a warning about excess heat on a saw with a side exhaust outlet. A restart in the tree has the chain clear of climbing equipment, clothing and parts of the tree, and the brake applied.

The Health and Safety Authority leaflet IFSG 301 on petrol driven chainsaws was published in October 2018 and modified for Irish use from Forest Industry Safety Accord guidance. It uses the same 4 m figure. It lists the starting items as paragraphs 28 to 34: the right hand on the rear handle and the left thumb under the front handle, a safe distance from other people, and the chain clear of obstructions. A start from cold is made with the saw on the ground, and from hot the same way or by a thigh or knee start. Where conditions prevent a ground start from cold, a thigh or knee start may be used.

The HSA leaflet separately has the brake applied when the saw is carried on site or idle for more than 15 seconds.

The four texts side by side

Start and fuelling statements by publisher
PublisherWhere the start is madeBrake and fuelling distance
OSHA logging standardOn the ground or where otherwise firmly supported; drop starting prohibitedBrake engaged; start at least 10 feet (3 m) from fuelling
California tree work articleOn the ground or where otherwise firmly held or supported; no drop startsNeither stated in this subsection
HSE leafletOn the ground; thigh start where conditions prevent it; drop start not mentionedBrake applied for the cold start and the restart; normally at least 4 m from fuelling
HSA leafletOn the ground from cold; thigh or knee start where conditions prevent it; drop start not mentionedBrake applied when walking on site or idle for more than 15 seconds; normally at least 4 m from fuelling

Where the figures differ

OSHA prints 10 feet (3 m) and the two European leaflets print 4 m. The OSHA figure is a requirement in a standard. The HSE and HSA figures are guidance, and both leaflets say "normally". HSE adds that following its guidance is not compulsory unless stated.

Maker manuals

OSHA ties the whole start to the manufacturer's instructions. For what makers' support pages list when a petrol saw will not start, see the causes two makers' service pages list. The fuelling side is in fuelling a saw.

Sources