Starting a pollard: when and how young trees are first pollarded
The Woodland Trust puts the first cut on a young maiden tree at 5 to 15 years old, in winter. The RHS starts once the tree reaches the height wanted, and Natural England describes staged cuts one to five years apart.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
The RHS, the Woodland Trust and Natural England each publish first-cut guidance for pollards. It is not training and does not teach the work. A pollard is a tree whose upper branches are cut back on a regular cycle so dense growth forms at the top.
Age and height at the first cut
The Woodland Trust gives the first cut on a maiden tree as a winter job. It follows once the tree has grown above the height wanted for the pollard. Young is best, usually 5 to 15 years old. Larger trees can also be topped and established as pollards, and success depends on age, species and the level of shading.
The RHS agrees on the trigger. Pollarding is normally started once a tree or shrub reaches a certain height, and annual pollarding then holds the plant at that height. The RHS frames the first cut around a framework. On a shrub that may be one stem cut to a metre. On a tree it is more usual to leave a trunk carrying three or five branches, each cut back to a chosen length.
Species and timing
The RHS lists ash, common lime, elm, elder, gum, London plane, mulberry, oak, some Acer species (A. negundo and its cultivars), and tulip tree among the plants pollarded. It rates the work as moderate in difficulty and usually needing a professional because of heights and chainsaws. The Woodland Trust names willow, ash, beech, hornbeam, lime and holly as traditional fodder pollards, and says most native trees can be pollarded.
For timing the RHS prefers late winter or early spring, except for maples, which bleed sap in spring. Summer can work but new growth may be poor. Autumn is the least favourable time because decay fungi may enter the cuts.
Natural England, writing on veteran trees, gives a calendar. January to March is best, and November and December are slightly less good. It marks spring, when leaves are just opening, and autumn, when they are falling, as times to avoid. Its species table rates willow, plane and lime top marks for creating a young pollard.
Cut height, cut level and staged cuts
The Woodland Trust ties cut height to browsing animals. Where grazing is present, the cut sits out of reach: 1.2 m for roe deer and sheep, 1.5 m for fallow deer, 1.8 m for red deer and goats, and 2 m or more for large cattle. It describes a clean cut, sloped to shed rain and without tearing bark from wood. Limbs are cut close to the base to form the pollard head. Later cuts go just above the previous level.
Natural England describes cutting a tree in two or more stages, several years apart. Oak, white willow and black poplar have been done this way. The first stage removes the upper branches and keeps a high proportion of branches lower down. After one to five years, depending on species and growth, a second cut brings the crown lower and keeps some of the new growth from the first. The text calls this less likely to work with beech, because new growth rarely appears well below the point of cutting.
The RHS and the Woodland Trust both name ash and hornbeam as species that can do better with some branches kept. The RHS adds oak. After the first cut the RHS describes an annual cycle, with each cut just above the previous one.
Sources
- Royal Horticultural Society, Pollarding: Pruning for Size Control, RHS Advice, read October 16, 2026
- Woodland Trust, Types of woodland management (coppicing, pollarding, formative pruning, thinning), read October 16, 2026
- Natural England, Veteran Trees: A guide to good management, chapter 4, Management of Veteran Trees, read October 16, 2026