ArbNation Join free

Seattle approved street tree list: species, size classes and restrictions

The Seattle Department of Transportation list has 145 species and cultivars in seven size classes. Each row prints mature height, spread, an Under Wires column and a minimum strip width.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The Seattle Department of Transportation publishes its Approved Street Tree List as an eight-page PDF, laid out in landscape. The file carries no printed date. Its properties show creation on August 8, 2011 and a last edit on April 9, 2012, and the file name says 2011. The city's Streets Illustrated manual calls it the Recommended Street Tree List. Seattle's list sits beside street tree lists from other cities.

The size classes

The list sorts trees into seven classes. Every row has a scientific name, a common name, mature height, mature spread, an Under Wires answer of Yes or No, a minimum strip width, flower colour, fall colour and a comment. The PDF prints the numbers without a unit, and the strip widths run from 4 to 8.

Rows in each class of the 2011 list, counted from the PDF
ClassRowsHeightSpreadYes under wires
Large Columnar840 to 6010 to 300
Large3140 to 6025 to 500
Medium / Large1930 to 5025 to 400
Medium Columnar1030 to 4510 to 202
Medium3825 to 5020 to 4015
Small Columnar520 to 308 to 205
Small3415 to 3515 to 3031

That makes 145 rows, 53 of them marked Yes under wires. Every Large and Medium / Large row is marked No. Of the 145 rows, 77 carry a strip width of 5, 49 carry 6, 13 carry 8 and 6 carry 4.

Sample rows

Twelve rows from the list, with its figures and strip widths. Height and spread use the list's own numbers.

Tree and classHeight by spreadUnder wiresStrip
Ginkgo biloba 'Princeton Sentry', large columnar40 by 15No6
Quercus robur 'fastigiata', large columnar40 by 15No6
Acer saccharum 'Legacy', large50 by 35No5
Liriodendron tulipifera, large60 by 30No8
Quercus bicolor, large60 by 45No8
Malus 'Tschonoskii', medium columnar30 by 15Yes5
Carpinus caroliniana, medium25 by 20Yes5
Koelreuteria paniculata, medium30 by 30Yes5
Acer palmatum, small20 by 25Yes5
Cercis canadensis, small25 by 30Yes5
Cornus kousa 'Chinensis', small20 by 20Yes4
Prunus cerasifera 'Thundercloud', small30 by 20No5

Only a few Small rows are marked No under wires. The list gives Parrotia persica, Prunus cerasifera 'Thundercloud' and Sorbus alnifolia as examples.

Streets Illustrated on tree selection

Streets Illustrated section 3.7 on street trees starts selection from the width of the planting right-of-way, set against a street-type standard of 6 feet. It sorts sites into four cases: wider or narrower than the standard, each with or without overhead powerlines. The section sets 5 feet 6 inches of clearance between the back of the sidewalk and the inside edge of the curb. It places a tree 3 feet 6 inches from the curb face, measured to the centre of the tree.

The section gives no spacing figures and points to the SDOT list for spacing. It adds that each project is reviewed site by site. Tree pits need at least 24 square feet of open area, and the section cites 1,200 cubic feet of soil per tree as the urban industry standard.

The inventory map

The SDOT Tree Inventory Map page describes a separate record. About 130,000 trees line Seattle's streets, and the map shows roughly 40,000 city-maintained trees. Entries show scientific and common name, inventory ID, diameter, address, the party that maintains it, and the planting or inventory date. The initial inventory was completed in 1992, and SDOT's data on the trees it maintains was updated in 2007 and 2008, with plantings added since. More than 25,000 street trees have been planted since 1992. SDOT calls the data "for general information purposes only".

Sources