ArbNation Join free

Tallest trees and champion tree measurements: how American Forests, the Tree Register and NZ Notable Trees measure

The registers do not agree on where girth is taken: 1.5 m in Britain and Ireland, 1.4 m in Australia and New Zealand, 4.5 ft in the United States. Height methods range from a dropped tape to a laser.

Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.

Champion status in each register rests on a few numbers taken from the tree: girth, height and, in some registers, crown spread. The registers fix the rules for those numbers so that trees can be compared.

Girth and its measuring height

NZ Notable Trees points out that authorities set the "breast height" for girth differently. It lists the United States at 4.5 ft (137 cm), the UK Tree Register and British standards at 1.5 m, the IUFRO international standard at 1.3 m, and Australia and New Zealand at 1.4 m.

Girth rules as each register prints them
RegisterGirth taken at
Tree Register (Britain and Ireland)1.5 m (5 ft) above ground, to the nearest centimetre
National Register of Big Trees (Australia)1.4 m above the estimated base point, where the tree germinated
NZ Notable Trees (New Zealand)1.4 m from ground level, in centimetres

All three treat a fork or swelling the same way: the smallest reading below the standard height, with the height of that reading recorded. The Australian register excludes dead branches and epicormic sprouts from that reading. On sloping ground the Tree Register takes the highest side of the slope. The Australian and New Zealand registers take the point where the centre line of the trunk meets the ground, mid-slope.

The Tree Register and NZ Notable Trees both describe a level tape and the smallest reading. The Australian register adds that litter piled at the base would give a wrong figure, and that heavily leaning trees are measured perpendicular to the axis of the trunk. It reduces the circumference of buttressed trees such as figs to 60 percent, which it calls subjective. The Tree Register has tree-form categories A to E and U. In its example a paperbark maple measured at 0.8 m is Category B and so not directly comparable with trees measured at 1.5 m. The New Zealand register does not calculate champion points for multi-stemmed trees.

Height methods

The Tree Register lists the height methods found in its records in approximate descending order of accuracy:

  • Climbing to the top and dropping a tape. The Register does not endorse this except where a tree needs climbing for a safety inspection or safety work, and withholds the exact location of many of its tallest trees to discourage recreational climbs.
  • A laser range-finder using the sine method. A Nikon Forestry Pro type device reaches about 25 cm, and dearer devices within 10 cm. The Register recommends laser readings, to the nearest 0.2 m, for champion trees.
  • The external baseline method, which was the most precise before lasers but needed complex calculations.
  • LiDAR, Google Earth and drones. A drone's altimeter is likely accurate to about a metre.
  • The tangent method with a clinometer or hypsometer, which can grossly overestimate height.

NZ Notable Trees also flags the tangent method. It says errors from misjudging the true top, and from a top that is not over the base, can reach 20 percent. It asks for the height of a national champion to be confirmed by an expert such as an arborist or forester. The Australian register puts a clinometer at about half a metre of accuracy and offers a ruler and a stick method for people without one.

Crown spread, points and challenges

New Zealand takes four basic measurements: girth in centimetres, vertical height and the widest and narrowest crown spread, the last three to the nearest 0.1 m. The Australian register takes two crown spreads at right angles and uses their average. It scores trees on points, calls a tree within 5 percent of the leading score a Co-Champion, and says a champion stays champion until challenged. It states that all nominations and measurements are taken on trust and that every champion must have a single stem, or one pith.

American Forests

American Forests launched the National Champion Tree Program in its magazine in 1940. It published the first list, with over 200 trees, in 1945, and its 2024 article puts the register at 561 species. An 86-page Measuring Guidelines Handbook came out in 2014 as a step toward consistent champion measurements. The Australian register links to that handbook, and NZ Notable Trees names American Forests' tree measuring guidelines as a resource. The program moved to the University of Tennessee, Knoxville in 2024.

Sources