ArbNation Join free

Tool lanyards, saw lanyards and tear-away tethers: what the NSW and NZ codes say about dropped objects

SafeWork NSW wants a weak link in a saw lanyard. The New Zealand code recommends a tear-away lanyard or tool strop for a saw aloft. Three codes and their wording on tethered tools are set side by side.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

The named codes and training bodies are described here as published. It is not training and does not teach the work. The codes are the SafeWork NSW Tree works code of practice (March 2026) and the WorkSafe New Zealand Approved Code of Practice for Safety and Health in Arboriculture (November 2012). A third document is the New Zealand Arboricultural Association safety guide, Edition 3.1 of 2022.

Terms in the codes

DocumentTermDefinition
NSW codeTool lanyard or tool stropRope or webbing that attaches the climber's tools to the harness. It should incorporate a tear-away
NZ code of practiceTool stropA short line used to secure tools while aloft
NZ Arboricultural Association guideTool stropA short line used to secure tools while aloft

The New South Wales code

The SafeWork NSW code covers chainsaws in trees in section 10.8. Its list of controls includes attaching the chainsaw, for example by a tool lanyard, when working above ground.

A short passage on selecting tool lanyards follows. The lanyard should be long enough to allow full reach, with the chainsaw hanging below the climber's feet when not in use. Connection hardware that forms part of the lanyard should be marked with a load rating and be auto-locking with three consecutive actions to open it. The lanyard should incorporate a weak link that lets it separate from the harness in the event of extreme loading.

For a chainsaw used from a work platform such as a bucket, the code says it should be attached to the operator, bucket or platform by a tool lanyard. Section 10.9 on pole saws says that when trimming from an EWP the saw should be attached at all times, for example by a tool lanyard or tool strop. It also says not to operate a pole saw at heights without a lanyard in place to prevent the saw falling to the ground.

Falling objects are also covered in section 3.5, which cites sections 54 and 55 of the WHS Regulation on managing and minimising the risk of falling objects. Zones are covered in the guide to drop zones and exclusion zones.

The New Zealand code of practice

The 2012 Approved Code of Practice, in section 3.1.2 on chainsaw safety, says that using a tear-away chainsaw lanyard or tool strop attachment is recommended practice when aloft. Section 3.1.6 says chainsaws shall be secured when used in trees or on a work platform. The exception is a danger of the chainsaw being trapped and taken with the severed section.

The New Zealand Arboricultural Association guide

The Arboricultural Association guide sets rules in numbered clauses. Clause 11.3 says all tools shall be removed from a tree or secured in such a way that they cannot fall. Clause 27.2 repeats the chainsaw rule: chainsaws shall be secured when used in trees or in a work platform. Where the saw could be trapped and taken with the severed section, the risk shall be suitably managed to avoid all harm. Clause 43.2 asks for hand saws to have a guard or scabbard with some means of attachment to the worker's belt for working aloft, and adds that a tool strop may be used.

Where the wording differs

The NSW code uses "should" for the weak link and the tear-away. The NZ code of practice calls the tear-away attachment recommended practice, while the Arboricultural Association guide uses "shall" for securing tools and chainsaws. Only the NSW code describes the weak link and the load rating of the hardware.

Sources