ArbNation Join free

Trailer brakes and breakaway systems: US federal Part 393 and Australian Design Rule 38/03

US federal rules exempt a trailer of 3,000 pounds or less from brakes under a 40 percent axle test. Australia's ADR 38/03 sets brakes on all wheels above 2 tonnes and a 15 minute breakaway hold.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. Part 393 of the US federal motor carrier rules and ADR 38/03 in Australia answer different questions. Part 393 applies to commercial motor vehicles in use. The Australian standard governs how trailers are designed and built.

The two texts side by side

Trailer brake and breakaway provisions
ItemUnited States, 49 CFR 393.42 and 393.43Australia, ADR 38/03
Brakes on trailer wheelsBrakes on all wheels of every commercial motor vehicleBrakes on all wheels once the gross trailer mass is over 2 tonnes; service brakes on all wheels above 4.5 tonnes ATM
Light trailer exemptionGross weight of 1,361 kg (3,000 lb) or less, if axle weights of the towed vehicle are 40 percent or less of the towing vehicle'sOver-run brakes allowed up to 2 tonnes gross trailer mass
BreakawayBrakes apply automatically and immediately on breakaway and stay applied at least 15 minutesEmergency brake system applies automatically on disconnection and holds at least 15 minutes, above 2 tonnes
Towing vehicleService brakes able to stop the towing vehicle after a trailer breakawayOutside this standard, which covers trailers

United States: brakes on all wheels

Section 393.42 of Title 49 requires every commercial motor vehicle to have brakes acting on all wheels. The rule lists exceptions. A semitrailer or pole trailer with a gross weight of 1,361 kilograms (3,000 pounds) or less, laden or unladen, needs no brakes if its axle weight is not over 40 percent of the sum of the towing vehicle's axle weights. A full trailer or four-wheel pole trailer of the same gross weight is exempt if the sum of its axle weights is not over 40 percent of the sum for the towing vehicle.

Other exceptions cover trucks and truck tractors with three or more axles built before July 25, 1980, which need no front brakes. Vehicles in driveaway-towaway operations are excepted too. So is the steering axle of a three-axle dolly steered by a co-driver. Housemoving dollies and similar specialized trailers run at no more than 32 km/h (20 mph) are also excepted. Portable conveyors built before 2010 for the aggregate industry have their own conditions, including a 45 mph limit on two-lane roads. The section was last amended on February 19, 2026 (91 FR 7890).

United States: breakaway and emergency braking

Section 393.43(a) requires a towing vehicle that pulls a braked trailer to have a way for its service brakes to stop it if the trailer breaks away. For air-braked units, the tractor protection valve or similar device must operate automatically when air pressure on the towing vehicle is between 138 kPa and 310 kPa (20 psi and 45 psi).

Paragraph (d) covers trailers. Every trailer required to have brakes must have brakes that apply automatically and immediately on breakaway from the towing vehicle. For trailers with three or more axles, not every brake must apply. For all others, all required brakes must apply, and they must stay applied for at least 15 minutes. Paragraphs (b) and (c) cover air-braked and vacuum-braked trucks and tractors. Paragraph (f) exempts commercial motor vehicles being moved in driveaway-towaway operations from (b), (c) and (d).

Australia: ADR 38/03 Trailer Brake Systems

The Vehicle Standard (Australian Design Rule 38/03, Trailer Brake Systems) 2007 was registered on July 17, 2007 and commenced on July 18, 2007. The current compilation took effect on September 17, 2014. It was made under the Motor Vehicle Standards Act 1989 and, from July 1, 2021, continues in force as a national road vehicle standard under the Road Vehicle Standards Act 2018. It applies to the design and construction of trailers, on all new models from January 1, 2009 and on all vehicles from July 1, 2009. Trailers built to ADR 38/04 or a later version need not comply with it.

For trailers up to 4.5 tonnes ATM, clause 4 applies. Every trailer needs a service brake system, and unless it uses over-run braking, the force must be adjustable from the towing vehicle's control signal. Above a gross trailer mass of 2 tonnes, brakes must work on all wheels, and the trailer needs an emergency brake system that applies automatically if the trailer accidentally disconnects. Brakes so applied must stay applied for at least 15 minutes. Up to 2 tonnes, over-run action can operate both the service and secondary systems.

For trailers over 4.5 tonnes ATM, clause 5 requires service brakes on all wheels and a parking brake. It also requires that the brake system restrain the trailer automatically in a break-away, with performance not less than the emergency brake system in part 7. Part 7 sets that performance as a retardation coefficient of not less than 0.18, sustained for at least 15 minutes.

Sources