Truck and trailer rules for tree crews in Queensland
Queensland applies the Heavy Vehicle National Law to any vehicle or combination with a GVM or ATM over 4.5 tonnes. Mass, size and load breaches carry maximum penalties of AU$3000 to AU$20000.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The Queensland Legislation site carries the Heavy Vehicle National Law (Queensland). It is the national law as applied, with modifications, in Queensland by the Heavy Vehicle National Law Act 2012. The National Heavy Vehicle Regulator (NHVR) publishes guidance on mass and loading.
Which vehicles are covered
Section 6 of the Law makes a vehicle a heavy vehicle if its gross vehicle mass (GVM) or aggregate trailer mass (ATM) is more than 4.5 tonnes. A combination that includes such a vehicle is also a heavy vehicle. Rolling stock is excluded.
Chapter 4 covers mass, dimension and loading. Its stated purposes are to cut the public safety risk from excessively loaded or excessively large vehicles and to limit harm to road infrastructure and public amenity. The national regulations set the numbers. Section 95 lets them cover tare mass, mass on tyres, axles and axle groups, axle spacing and general mass limits.
Mass limits
The NHVR page on General Mass Limits calls them the basic limits for all heavy vehicles. They cover single axles, axle groups and axle spacings, as the Heavy Vehicle (Mass, Dimension and Loading) Regulation defines them. They apply unless the vehicle runs under an exception, an exemption by notice or permit, or a Performance Based Standards approval. A vehicle at these limits may use the whole road network, subject to local signs.
The loaded mass must never exceed the maker's rating. That means the GVM for a rigid vehicle, the gross combination mass for a combination or the ATM for a trailer. A maker's rating on a tow coupling, tyre, wheel or axle must not be exceeded either. Amendments to the Law and Regulations began on 1 August 2026.
Penalty bands
Sections 96, 102 and 111 cover mass, dimension and loading breaches. A person who drives, or lets another person drive, a heavy vehicle on a road with a breach commits an offence unless there is a reasonable excuse. The maximum penalty rises with the risk band.
| Requirement | Minor, substantial, severe |
|---|---|
| Mass, section 96 | AU$4000, AU$6000, AU$10000 |
| Dimension, section 102 | AU$4000, AU$6000, AU$10000 |
| Loading, section 111 | AU$3000, AU$5000, AU$10000 |
The three figures in each row are the risk bands. For mass and dimension, the Law sets them by how far the breach goes past the limit. For mass, the middle band starts at the higher of two figures, 105% of the maximum permitted mass and 0.5t, and the severe band at 120%. Past 120%, the mass penalty adds a maximum AU$500 for each extra 1%, up to AU$20000. The dimension penalty of AU$4000 also applies to a vehicle with no goods or passengers aboard. The severe band starts 600 mm over the length limit, 80 mm over the width limit, 300 mm over the height limit and 80 mm over the load projection limit. The middle band starts at 350 mm, 40 mm, 150 mm and 40 mm. A loading breach is minor when it involves no loss or shifting of the load and a loss or shifting would not have been likely to involve an appreciable safety risk, or an appreciable risk to road infrastructure or public amenity.
Loading
On loading, the NHVR requirements page says a heavy vehicle must be loaded safely. Placement must not make it unsafe or unstable, and the load must not be likely to fall or be dislodged. An appropriate restraint system is required. It lists falling objects, swerving, spillage, loads entering the cab under braking, and rollover as the harms.
The Law does not say how to restrain a given load. It describes the outcome a restraint system must reach. The Law sets no minimum standard for straps and chains, though the NHVR calls equipment meeting Australian Standards advisable. It points to its Load Restraint Guide and gives no engineering advice on specific restraint systems. A qualified person, in its words, is a registered professional engineer. The Northern Territory and Western Australia have their own loading pages.
Gaps
These documents give no Queensland licence classes and no trailer brake rule.
Sources
- Queensland Legislation, Heavy Vehicle National Law (Queensland), in force version of the Heavy Vehicle National Law Act 2012 schedule, read October 19, 2026
- National Heavy Vehicle Regulator, General Mass Limits (GML), read October 19, 2026
- National Heavy Vehicle Regulator, Loading requirements, read October 19, 2026