Windthrown trees, root plates and bucking under tension: the regulator wording
IFSG 306, the Irish version of FISA 306, calls windblow clearance very hazardous. OSHA defines spring pole and root wad, and WorkSafe New Zealand requires more than one person on site for windthrow.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
The wording below is what the named codes and training bodies publish. It is not training and does not teach the work.
Four documents deal with windthrown trees. FISA 306 is a leaflet of the Forest Industry Safety Accord in the United Kingdom, titled Chainsaw clearance of windblow. IFSG 306 is the Irish version, published by the Health and Safety Authority in October 2018, modified for Irish use with FISA's permission. OSHA's logging standard and WorkSafe New Zealand's arboriculture code complete the set.
Scope and terms
FISA 306 applies to manual harvesting of areas where most adjacent trees are windblown or broken, and to sporadic windblow inside or outside standing crops. Both leaflets say mechanised systems should be considered as a safer alternative. IFSG 306 opens with a warning: this operation is very hazardous and every situation needs careful assessment.
| Term | Wording | Source |
|---|---|---|
| Windthrown trees | Trees that have been blown down, have become unstable or have been significantly damaged by wind action | WorkSafe New Zealand |
| Root wad | The ball of a tree root and dirt pulled from the ground when a tree is uprooted | OSHA 1910.266 |
| Spring pole | A tree, segment, limb or sapling under stress or tension from the pressure or weight of another object | OSHA 1910.266 |
What the regulators set down
OSHA's rule on wind-thrown trees is in paragraph (h)(3). Before bucking or limbing wind-thrown trees, precautions are taken to stop the root wad, butt or logs striking an employee. Its examples are chocking the tree or moving it to a stable position. On a slope where logs may roll or slide, limbing and bucking are done on the uphill side. When a spring pole or other tree under stress is cut, no employee other than the feller is closer than two tree lengths when the stress is released.
WorkSafe New Zealand, in section 3.4.7 of its 2012 code, says windthrown trees add hazards that need more than one person on the site at all times. Where a tree rests on its upturned roots, the cut is made so the feller and other workers are not in danger from movement of the root mat or the log.
The two leaflets on root plates and tension
IFSG 306 sets out evidence of good practice and says deviation should follow a full risk assessment by competent persons. It numbers its points. The ones that bear on root plates and tension are below.
| Subject | What the leaflet records |
|---|---|
| People | Never work in windblow alone. Operators hold competency for the task. With machinery there is an agreed system of work and communication. No one is closer than twice the tree length when standing, leaning or broken stems are felled. |
| Standing under | No walking or working under unstable windblown trees or root plates. Walking along windblown stems or branches is to be avoided. |
| Preparing | Safe access and egress, and escape routes selected and cleared. Small trees pinned by windblown trees are checked, with their tension relieved before larger ones are dealt with. Dead wood, insecure branches and broken tops are watched for, in the fallen and the standing trees. |
| Root plates | A root plate that overhangs the work position is anchored back before the stem is severed. Severing cuts at the butt are as close to the root plate as practicable. The leaflet also says every effort is made to replace the root plate once the stem is severed. |
| Tension | On bent stems the leaflet has the operator identify where tension and compression wood lie, and warns that enormous power may be released by cutting into tension wood of even relatively small material. The first severing cut goes into the compression wood. Where the stem may spring upwards, the final cut goes into the tension wood at least 25 mm from the first, in the part of the stem least likely to move. |
| Side tension | With side tension present, the leaflet puts the operator on the compression side, and advises restraining the stem with a winch when side tension is considerable. Each cut is watched for pinching or twisting. |
| Broken trees | Where a broken top touches the ground, the top is cut away at that contact. The upright section is felled in a direction at right angles to any broken part still attached, and the leaflet warns against working under the broken top. |
| Saw handling | A secure, balanced stance, and no saw use above shoulder height. A reducing cut is described for stems wider than the guide bar. |
The Irish leaflet is modified from the UK one. The FISA page for leaflet 306, dated January 28, 2020, carries the same title and scope sentence.
Where the documents differ
OSHA and WorkSafe New Zealand state outcomes: no one struck by the root wad or log, no one in danger from root mat movement. The leaflets go further and list cuts, distances and anchoring in numbered points. OSHA's standard applies to logging operations. Its two-tree-length distance applies to a spring pole, while the leaflet applies twice the tree length to felling or taking down standing, leaning or broken stems.
Sources
- Forest Industry Safety Accord (UK), FISA 306 Chainsaw clearance of windblow, safety guide page, posted January 28, 2020, read October 16, 2026
- Health and Safety Authority (Ireland), Irish Forestry Safety Guide 306, Chainsaw Clearance of Windblow, October 2018, hosted by Teagasc, read October 16, 2026
- OSHA, 29 CFR 1910.266 Logging operations, definitions and paragraph (h), read October 16, 2026
- WorkSafe New Zealand, Approved Code of Practice for Safety and Health in Arboriculture, November 2012, section 3.4.7, read October 16, 2026