ArbNation Join free

Wire-core and rope lanyards: what the codes print on electrical use and cutting

SafeWork NSW says wire or wire core lanyards should not be used in an electrical environment. WorkSafe New Zealand bars wire ropes and strops within four metres of a power line. The UK ICoP prints no wire rule for lanyards.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

The named codes and the federal standard are described here as published. It is not training and does not teach the work.

Electrical use

CodeWording
SafeWork NSW, Tree works code of practice, March 2026, section 4.5Among the points for adjustable lanyards: wire or wire core lanyards should not be used in an electrical environment.
WorkSafe New Zealand, approved code of practice, November 2012, section 2.2.11Arborists shall not use wire ropes or strops within four metres of any power line. All power lines are treated as live.
WorkSafe New Zealand, section 2.2.11The code says the Approved Code of Practice for Tree Work Around Power Lines (2012) will bar strops or flip lines containing metal within the vegetation management zone, or on any tree extending into it.

The New Zealand code also bars metal ladders and metal-handled pruners or tools where trees extend into the competent worker zone.

Cuts and wear

SafeWork NSW section 4.5 adds further points to the same list. Webbing should be retired if there are any visible cuts. Faulty, defective or visibly worn or cut rope lanyards are not used and are permanently removed from service. A lanyard should incorporate a maximum length stop as an integral part.

The UK Industry Code of Practice for Arboriculture: Tree Work at Height (Edition 2, May 2020) deals with cutting tools in clause 3.9.1. It says that when tools are used in the tree, particularly cutting tools, all measures must be taken to eliminate or at the very least minimise the possibility of striking the systems connecting the operator to the anchors.

The SafeWork NSW glossary defines a tool lanyard or tool strop as rope or webbing that attaches the climber's tools to the harness. It should incorporate a tear-away.

Material and strength

SourceWording
ICoP, clause 3.10.6.10A lanyard in a personal fall protection system has a minimum breaking strength of at least 15 kN. It is compatible with its connectors and adjusts efficiently and reliably under load. The clause names no material.
OSHA 29 CFR 1910.140, definitionsA lanyard is a flexible line of rope, wire rope or strap, usually with a connector at each end.
OSHA 1910.140(c)(4)Lanyards and vertical lifelines have a minimum breaking strength of 5,000 pounds (22.2 kN).
OSHA 1910.140(c)(20)Ropes, belts, lanyards, lifelines and harnesses used for personal fall protection are protected from being cut, abraded, melted or otherwise damaged.

The ICoP figure of 15 kN and the OSHA figure of 22.2 kN come from different documents with different scope. They are not reconciled here.

Where the codes differ

The US federal text lists wire rope as a lanyard material and prints no electrical rule for lanyards. Its only electrical test applies to lineman's body belt and pole strap systems. The NSW and New Zealand codes treat wire and metal as a hazard near live conductors. The UK code treats the cutting tool as the hazard and prints no wire rule for lanyards.

Each code's lanyard types are tabled in lanyards and flip lines by type. Approach distances sit in power lines.

Sources