Wood decay and natural durability classes: EN 350 and the USDA Wood Handbook
EN 350 is the European standard that classes the natural durability of solid wood against fungi, beetles, termites and marine organisms. The USDA Wood Handbook groups species by heartwood decay resistance in four classes.
Checked against the sources at the bottom of this page on October 21, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. It covers dead wood and timber, not the decay risk of a living tree. The scope of the standard comes from the NSAI catalogue entries, and the decay facts come from the USDA Forest Service Wood Handbook chapter on biodeterioration. Decay in standing trees is in the guide comparing decay types.
EN 350 in the NSAI catalogue
The National Standards Authority of Ireland lists two parts of EN 350, both published May 19, 1994 by the European Committee for Standardization (CEN) under committee CEN/TC 38. Both were superseded on August 1, 2016 by EN 350:2016. The catalogue gives title, scope and contents only. The standard text is sold and is not quoted on this page.
| Part | Title in the catalogue | Scope in the catalogue |
|---|---|---|
| EN 350-1:1994 | Durability of wood and wood-based products, natural durability of solid wood, Part 1: Guide to the principles of testing and classification of the natural durability of wood | Guidance on methods for finding the natural durability of untreated solid wood against wood-destroying fungi, insects (beetles and termites) and marine organisms. It also covers classing wood species from the results |
| EN 350-2:1994 | Durability of wood and wood-based products, natural durability of solid wood, Part 2: Guide to natural durability and treatability of selected wood species of importance in Europe | Lists the natural durability of selected species used for construction in Europe, against fungi, dry wood beetles, termites and marine organisms. It also gives treatability, origin, density and sapwood width |
The contents list of Part 1 has sections on the principle of classification, sampling of the wood to be tested, and test methods and classification. Part 2 has tables on treatability classes, softwood and hardwood species, commercial groupings, and species classed durable or moderately durable against marine organisms. The NSAI pages do not print the class definitions.
Decay in the Wood Handbook
The Wood Handbook, chapter 14, Biodeterioration of Wood, was written by Carol A. Clausen of the Forest Products Laboratory and issued as General Technical Report FPL-GTR-190 in 2010. It says the organisms that degrade wood are principally fungi, insects, bacteria and marine borers. Termites are the major insect enemy of wood, though on a national scale a less serious threat than fungi.
The chapter recognises two major kinds of decay fungi. With brown rot, only the cellulose is extensively removed, and the wood browns, shrinks, cracks across the grain and can be crushed to powder. With white rot, both lignin and cellulose usually go, the wood appears whiter, and it keeps its outward dimensions until severely degraded. Soft rot is a third kind, caused by fungi related to the molds, and it is usually shallow. Brown rot is common on softwoods and white rot on hardwoods, but each occasionally colonizes both.
Decay needs moisture, air and mild temperature. The chapter says serious decay occurs only above the fiber saturation point, which averages 30 percent moisture content. Fully air-dried wood usually does not exceed 20 percent. It adds that wood can be too wet for decay as well: water-soaked wood may lack the air the typical fungi need. Decay is relatively slow below 10 °C (50 °F) and above 35 °C (95 °F), and essentially stops at 2 °C (35 °F) or 38 °C (100 °F).
Heartwood decay resistance groups
The chapter says the heartwood of common native species has differing degrees of natural decay resistance, and untreated sapwood of essentially all species has low resistance. Precise ratings are not possible because species vary and service conditions differ. Table 14-1 therefore gives broad groupings from service records, laboratory tests and expertise. A few of its domestic entries show the spread.
| Group in Table 14-1 | Examples among domestic species |
|---|---|
| Very resistant | Black locust, red mulberry, Osage-orange, Pacific yew |
| Resistant | Catalpa, eastern redcedar, western redcedar, chestnut, white oaks, black walnut, old growth redwood |
| Moderately resistant | Douglas-fir, western larch, old growth longleaf pine, young growth redwood, tamarack |
| Slightly or nonresistant | Ashes, aspens, beech, birches, elms, maples, spruces, true firs, willows, yellow-poplar |
The table notes that resistance may be less for members in ground contact or in warm, humid climates. It also notes wide variability within most species and limited durability data for some of those listed. The chapter adds that the variation among trees or samples of one species is much greater for the more resistant species than for the slightly or nonresistant ones. The chapter links resistance to preservative qualities of the wood extractives, the attacking fungus and the conditions of exposure.
The Forest Service Treesearch record for the chapter lists it as formally refereed, pages 14.1 to 14.16 of the Centennial edition.
Sources
- NSAI, EN 350-1:1994 catalogue entry (superseded by EN 350:2016), read October 21, 2026
- NSAI, EN 350-2:1994 catalogue entry (superseded by EN 350:2016), read October 21, 2026
- USDA Forest Service, Treesearch record for Biodeterioration of wood (Wood Handbook chapter 14, 2010), read October 21, 2026
- USDA Forest Service Forest Products Laboratory, Wood Handbook chapter 14 Biodeterioration of Wood, FPL-GTR-190, 2010, read October 21, 2026