ArbNation Join free

Wood stove and heater emission rules by country: US EPA, UK Ecodesign and Australian states

The US sets wood stoves at 2.0 g/hr of particulate from May 15, 2020. The UK sets closed wood heaters at 40 mg/m3 from 2022. Western Australia prints its own limits; Canada, the EU and New Zealand have no opened source.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. Wood stove emission rules differ by country in the unit they use, the test they name and the body that certifies a model. A grams-per-hour figure, a milligrams-per-cubic-metre figure and a grams-per-kilogram figure cannot be compared with each other. Each is shown in its own unit.

At a glance

CountryLimit and test methodDate and certifier
United States2.0 g/hr, or 2.5 g/hr by the cord wood option; methods in 40 CFR 60.534May 15, 2020; EPA-approved labs and third-party certifiers
CanadaNot sourcedNot sourced
United Kingdom40 mg/m3 PM for closed wood heaters, 50 mg/m3 for open fires; Annex III methodsJanuary 1, 2022; manufacturer conformity assessment, HETAS approval scheme
European UnionNot sourcedNot sourced
New South WalesLimits in AS/NZS 4013:2014 and 4012:2014; no figure on the page openedDate not printed; accredited lab, certificate per model
Western Australia1.5 g/kg and 60% efficiency, no catalytic combustor; same two standardsAugust 8, 2019; compliance plate on the heater
New ZealandNot sourcedNot sourced

An entry marked "not sourced" means no official page for that country opened in full.

United States: EPA new source performance standards

The EPA page on residential wood heaters says the standards strengthen the limits for new wood stoves and set federal air standards for other new wood heaters, including outdoor and indoor wood-fired boilers, also called hydronic heaters. It adds limits for adjustable-rate stoves, pellet stoves, forced-air furnaces and a type of stove with a single burn rate. The rule does not reach heaters already in homes. Heaters that burn only oil, gas or coal are outside it, and so are outdoor fireplaces, fire pits, pizza ovens and chimineas. EPA left new indoor fireplaces out and covers them in a voluntary program.

The rule history on the EPA page gives final standards on April 2, 2020, a revised rule on March 16, 2015, and the first standards on February 26, 1988.

Wood stoves, 40 CFR 60.532

Section 60.532 sets the particulate limit by the date a heater is made, imported or sold at retail.

  • From May 15, 2015: a weighted average of 4.5 g/hr (0.010 lb/hr). A heater made before that date could be imported or sold at retail up to December 31, 2015.
  • From May 15, 2020: a weighted average of 2.0 g/hr (0.0044 lb/hr).
  • From May 15, 2020, by the cord wood alternative: a weighted average of 2.5 g/hr (0.0055 lb/hr), shown with a cord wood test method the EPA Administrator approves.

Compliance is decided by the test methods and procedures in section 60.534. A heater with a catalytic combustor must carry a temperature sensor that reads the gas stream within 2.54 cm (1 inch) of the combustor surface. Section 60.532 also lists fuels that must not be burned in an affected wood heater, among them garbage, pressure-treated wood, pallets and unseasoned wood, and it ties operation to the owner's manual.

Central heaters, 40 CFR 60.5474

Hydronic heaters and forced-air furnaces fall under a separate section with its own dates and units.

ApplianceDateParticulate limit as printed
Residential hydronic heaterMay 15, 2015Weighted average 0.32 lb/mmBtu (0.137 g/MJ) heat output, maximum 18.0 g/hr per burn rate
Residential hydronic heaterMay 15, 20200.10 lb/mmBtu (0.043 g/MJ) per burn rate; 0.15 lb/mmBtu (0.064 g/MJ) by the cord wood option
Small or large forced-air furnaceMay 15, 20200.15 lb/mmBtu (0.064 g/MJ) per burn rate

The EPA page lists approved test labs and third-party certifiers under its additional resources. Fuel rules for burning are in which wood must not be burned.

United Kingdom: Ecodesign for solid fuel local space heaters

Article 3 of Commission Regulation (EU) 2015/1185 as it applies in the UK says solid fuel local space heaters shall meet the requirements in Annex II from January 1, 2022. Compliance is measured and calculated by the methods in Annex III. The HETAS page confirms that the rule extends from that date to all solid fuel heating appliances, including roomheater stoves and roomheater stoves with boilers. Independent biomass boilers were already covered from January 1, 2020.

ApplianceEfficiency, minimumPM, mg/m3OGC, CO, NOx, mg/m3
Open fire, wood30%50120, 2,000, 200
Closed appliance, wood65%40120, 1,500, 200
Closed appliance, pellet79%2060, 300, 200
Cooker, wood65%40120, 1,500, 200

All values are at 13% oxygen. OGC is organic gaseous compounds, CO carbon monoxide, NOx nitrogen oxides.

The legislation text and the HETAS table agree on these figures for wood. For cookers the legislation prints the same 40 mg/m3 as closed wood heaters, and the HETAS table prints a dash. The legislation also prints particulate limits by a second and third test method for closed wood heaters: 5 g/kg of dry matter by one method, and 2.4 g/kg for biomass by another. Open fronted heaters carry 6 g/kg by the second method. Manufacturers must keep technical documentation for conformity assessment under Article 4 and supply installers and users with a set of product data.

HETAS runs a separate Cleaner Choice approval scheme. It says stoves certified under it emit less particulate than the most stringent legislation that applies within Smoke Control Areas, and it lists approved products on a search page. Rules for selling the fuel are in firewood sale rules in England.

Australia: AS/NZS 4012 and 4013 in New South Wales and Western Australia

New South Wales handles domestic solid fuel heaters in Part 2 of the Protection of the Environment Operations (Clean Air) Regulation 2021. The NSW EPA page says the rule targets slow combustion heaters. It requires every such heater sold wholesale or retail in the state, locally made or imported, to meet the emission and efficiency limits in AS/NZS 4013:2014 and AS/NZS 4012:2014. Each model needs a certificate of compliance showing it was tested to those standards, issued on test results from an accredited laboratory in Australia or New Zealand. Each heater must be marked accordingly. The regulation also bars tampering with a heater and bars marking a heater as compliant when no certificate is in force. The EPA page opened does not print a grams-per-kilogram figure.

The Western Australia Burnwise leaflet says the Environmental Protection (Solid Fuel and Firewood) Regulations 2018 prohibit the sale of new or second hand wood heaters that do not comply with the same two standards. It prints the figures on the compliance plate that must be met.

Heater typeBefore August 7, 2019From August 8, 2019
No catalytic combustor2.5 g/kg or less; efficiency 55% or more1.5 g/kg or less; efficiency 60% or more
With catalytic combustor1.4 g/kg or less; efficiency 55% or more0.8 g/kg or less; efficiency 60% or more

The leaflet exempts cooking appliances that have at least one hot plate and an oven of 28 L or more, and appliances meant only for water heating. It says selling a heater that has been altered or modified is also illegal. A current list of compliant models is kept on the website of the Australian Home Heating Association.

Canada, the European Union and New Zealand

No official page for these three printed a limit, test method, date or certifier. The cells stay empty until an official page prints them.

Sources