Wood volume and weight conversion table: stere, cord, Hoppus and board feet
A cord is 128 cubic feet of ranked and well stowed wood in the Connecticut regulation, 3.625 cubic metres in FAO's roundwood table, and 3.6 in Measurement Canada's divisor. FAO prints stere, Hoppus and board-foot equivalents.
Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. The unit definitions come from the Food and Agriculture Organization of the United Nations (FAO), Measurement Canada, the Connecticut Department of Consumer Protection and Teagasc, the Irish agriculture and food authority.
Volume units
| Unit | Printed equivalent | Source |
|---|---|---|
| Cubic foot | 0.02832 cubic metre | FAO, Table 1 |
| Stere, roundwood, stacked volume | 1 cubic metre, or 35.315 cubic feet | FAO, Table 3 |
| Stere, fuelwood, solid volume without bark | 0.65 cubic metre, or 23 cubic feet | FAO, Table 2 |
| Stere, pulpwood, solid volume without bark | 0.72 cubic metre, or 25.4 cubic feet | FAO, Table 2 |
| Cord, ranked and well stowed | 128 cubic feet | Connecticut DCP, from NIST Handbook 130 section 2.4.1.2 |
| Cord, roundwood, stacked volume | 3.625 cubic metres, or 128 cubic feet | FAO, Table 3 |
| Cord, fuelwood, solid volume without bark | 2.12 cubic metres, or 74.9 cubic feet | FAO, Table 2 |
| Cord, pulpwood, solid volume without bark | 2.55 cubic metres, or 90 cubic feet | FAO, Table 2 |
| 1,000 stacked cubic feet of fuelwood | 18.41 cubic metres, or 650 cubic feet, solid volume | FAO, Table 2 |
| Cubic metres to cords | Divide cubic metres by 3.6 to get cords | Measurement Canada |
| Hoppus cubic foot | 0.03605 cubic metre, or 1.273 cubic feet | FAO, Table 3 |
| Fathom, roundwood, stacked volume | 6.1164 cubic metres, or 216 cubic feet | FAO, Table 3 |
| 1,000 board feet (MBF), sawlogs and veneer logs | 4.53 cubic metres, or 160 cubic feet, solid volume without bark | FAO, Table 2 |
| 1,000 board feet (MBF), sawnwood | 83.33 cubic feet | FAO, Table 3 |
| Loose cubic metre | No equivalent printed in these sources | None |
Cords in Measurement Canada and Connecticut
Measurement Canada's infographic on measuring bulk firewood multiplies length, height and width of a rectangular stack. In centimetres it divides the result by 1,000,000 to get cubic metres, and then by 3.6 to get cords. In inches it divides by 1,728 to get cubic feet, and then by 128 to get cords. Its worked example is a stack of 96 by 48 by 12 inches, which comes to 32 cubic feet, or a quarter cord.
Connecticut's Department of Consumer Protection reprints the NIST Handbook 130 regulation on fireplace and stove wood. It defines "ranked and well stowed" as pieces placed in a line or row, touching and parallel to each other, and stacked in a compact manner. Wood is advertised, offered and sold only by the cord, fractions of a cord or the cubic metre. The regulation bars the terms "face cord", "rack", "pile", "truckload" and similar terms.
Packaged natural wood under 0.45 cubic metres (one-eighth cord or 16 cubic feet) shows its quantity in litres, cubic inches or cubic feet. A delivery ticket or sales invoice must be presented to the purchaser whenever non-packaged wood is sold. The department's Weights & Measures Division takes complaints about short cords of wood at (860) 713-6160.
Weights per cubic metre
FAO's Table 4 gives weight and volume pairs, with G for general, C for coniferous and NC for non-coniferous wood.
| Product | Kilograms per cubic metre | Cubic metres per metric tonne |
|---|---|---|
| Fuelwood | G 725, C 625, NC 750 | G 1.38, C 1.60, NC 1.33 |
| Pulpwood | G 675, C 650, NC 750 | G 1.48, C 1.54, NC 1.33 |
| Other industrial roundwood | G 750, C 700, NC 800 | G 1.33, C 1.43, NC 1.25 |
| Sawnwood | C 550, NC 700 | C 1.82, NC 1.48 |
| Plywood | 650 | 1.54 |
| Particle board | 650 | 1.64 |
FAO's Table 5 gives fuelwood energy: 9.4 gigajoules for 1 cubic metre of solid wood at 20 to 30 percent moisture content, 7.2 for solid green wood, and 5.0 for piled wood. COFORD's note on units for wood energy puts the bulk density of Sitka spruce chips at 206 kilograms per loose cubic metre at 30 percent moisture content. It is 320 at 55 percent, assuming a basic density of 380 kilograms per solid cubic metre.
Penn State Extension works out green weight as the mass of one cubic metre of dry wood times one plus the moisture content. The dry mass is basic specific gravity times 1,000 kilograms. Its oak and hickory example is 590 kilograms times 1.71, which comes to 1,009 kilograms per cubic metre, or 63 pounds per cubic foot. The Forest Products Laboratory's Wood handbook prints density in pounds per cubic foot by specific gravity and moisture content in its Table 4-6b. At specific gravity 0.50 it lists 31.2 at 0 percent, 34.9 at 12 percent and 62.4 at 100 percent. The USFS research note NRS-38 lists specific gravity for 156 North American tree species, on green volume and at 12 percent moisture content.
Stack volume in the Teagasc article
Teagasc multiplies stack width, stack length and average stack height to get gross volume, which includes the open spaces between logs. A conversion factor then turns gross volume into net volume, the volume of timber only. The article offers a sample grid of 0.7 by 0.7 metres or a standard factor. It prints the standard factor as 7 and calls it the most commonly used in the forest industry.
Sources
- FAO, F. Padovani, The Measurement of Forest Products, Tables 1 to 5 (workshop on forest product statistics), read October 15, 2026
- Measurement Canada, Measuring bulk firewood (infographic, modified November 30, 2020), read October 15, 2026
- Connecticut Department of Consumer Protection, Firewood and Stove Wood Regulations (from NIST Handbook 130, 2016), read October 15, 2026
- Teagasc, Timber Stack Measurement (August 8, 2025), read October 15, 2026
- Penn State Extension, Calculating the Green Weight of Wood Species (updated December 8, 2025), read October 16, 2026
- US Forest Service Northern Research Station, Specific gravity and other properties of wood and bark for 156 tree species found in North America (Res. Note NRS-38), Miles and Smith, 2009, read October 16, 2026
- COFORD, Units, conversion factors and formulae for wood for energy (COFORD Connects, Harvesting/Transportation No. 21, 2010), read October 19, 2026
- US Forest Service Forest Products Laboratory, Wood handbook: Wood as an engineering material (FPL-GTR-282, 2021), chapter 4, read October 19, 2026