ArbNation Join free

Woodland Carbon Code: registry, project types and verification

The Woodland Carbon Code is the UK quality standard for new woodland carbon projects. Projects run 40 to 100 years, go through verification at year 5 and then at least every 10 years, and sit on the UK Land Carbon Registry.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. The Woodland Carbon Code is a voluntary scheme for new woodlands in the UK. Its code, registry and scheme pages are published by the Woodland Carbon Code and by Scottish Forestry, which manages the code on behalf of the Forestry Commission, the Welsh Government and the Northern Ireland Forest Service.

Scope of the code

Scottish Forestry calls the code the quality assurance standard for woodland carbon projects in the UK. It sets requirements for voluntary woodland creation projects that remove carbon dioxide from the atmosphere. Projects bring a revenue stream to landowners and farmers, and a way for companies to compensate for emissions.

The code counts greenhouse gases absorbed or emitted by new woodlands created by planting, natural regeneration or direct seeding. That includes management styles from minimum intervention to regular clearfelling. It also counts emissions from creating the woodland and emissions the project causes outside the woodland boundary. It does not cover existing woodlands, carbon stored in forest products, or carbon saved by using wood products or fuels in place of higher-carbon ones.

As of 31 March 2025, projects in Scotland validated to the code had created 33,385 hectares of woodland. They are predicted to sequester 10.8 million tonnes of CO2 over their lifetime.

Versions and layout of the code

Version 3.0 launched on 1 August 2025. Projects already in development could keep submitting for validation or verification under version 2.2 until 30 June 2026. The code has an introduction, a section on using the code, five numbered sections and a glossary.

Sections of the Woodland Carbon Code, version 3.0
SectionSubject
1Eligibility
2Project governance
3Carbon sequestration
4Environmental quality
5Social responsibility

Each section of the code carries a requirement, a means of validation or verification, and guidance. Requirements are stated as "shall" and are mandatory. The means of validation or verification are examples of objective evidence that a developer may present. Guidance stated as "should" is a recommendation, and guidance stated as "may" is an option the standard permits.

Project types and timing

Section 1 of the code sets the dates and project types. From 1 October 2022, every project, single or part of a group, shall be registered before work begins onsite. A single project shall be validated within three years of registration. A validation statement is issued only once planting is complete.

Project types in section 1 of the code
TypeWhat the code sets
Any projectA project duration of at least 40 years and not more than 100 years. The duration cannot be extended after validation. Projects shall pass a legal test and a financial test for additionality
Small projectMore than 1 hectare and up to 10 hectares net planted or regenerating area. A shorter process applies at validation and verification, using the small project tab of the carbon calculator
Group of projectsA group spans no more than five consecutive planting seasons. It holds up to 15 standard projects and up to 100 hectares net of small projects. Group validation shall happen within three years of the first registration in the group

Verification

Section 2 of the code sets the review schedule. Projects shall be reviewed at year 5 and then at least every 10 years after the project start date, or the group start date for groups. The first verification falls due five years after the start date. Later ones fall due 15 years after the start date and at least every 10 years up to the project end date.

At year 5 every project follows the year 5 survey protocol. From year 15, full monitoring and third-party verification follow the year 15 survey protocol, and small projects can carry out basic monitoring from year 15. A project that receives a red rating at its year 5 verification gets an additional verification at year 10.

Carbon units and the buffer

Pending Issuance Units are a promise to deliver a Woodland Carbon Unit in future, and they are not guaranteed. At each verification, the Pending Issuance Units for that vintage are cancelled and the number of Woodland Carbon Units confirmed by verification is issued.

From version 2.0 of the code, each project contributes 20 percent of its net carbon sequestration to a shared buffer. The buffer is a single account in the UK Land Carbon Registry, managed by Scottish Forestry. Buffer units are not tradable, and they cover losses of issued units from a project.

The UK Land Carbon Registry

The UK Land Carbon Registry stores data about Woodland Carbon Code and Peatland Code projects, and about the ownership and use of carbon units. S&P Global manages it. It has four services.

  • A project register that lists individual projects and groups of projects.
  • A carbon unit register where projects issue units and assign or transfer them to buyers. Buyers use, retire and report units once they have been through verification.
  • A request for information platform where developers or brokers offer unretired units and buyers show interest.
  • A public database showing the status of all Woodland Carbon Code and Peatland Code activity.

The registry site also has pages on opening an account, registry fees and the rules of use. Its public view lists projects on a map and in table form.

Sources