ArbNation Join free

Working alone rules compared: written procedure, check-in interval and communication, by jurisdiction

British Columbia requires a written check-in procedure with a time interval and an end-of-shift check. Alberta leaves the interval to the hazard. The UK sets no interval and lists pre-agreed contact as one option.

Checked against the sources at the bottom of this page on October 15, 2026. Rules, fees and pay change: the source has the last word.

This page reports what the official source says. It is not legal advice: ask the office named here. None of the three documents below is written for tree work alone. The Alberta guide names tree cutting as an example of high hazard work. For the plain-language version, see the guide to working alone rules.

Three jurisdictions side by side

PlaceProcedure, interval and contact
British Columbia, OHS Regulation 4.20 to 4.23Written well-being check procedure, reviewed at least annually. The interval is set in the procedure, with a check at the end of the shift, and high risk work gets shorter intervals. Visual or two-way voice contact is preferred. A one-way device that sends for help is acceptable.
Alberta, OHS Code Part 28 (2009 guide)Hazard assessment report in writing. Contact at intervals appropriate to the nature of the hazard. Radio, phone or other electronic means, or visits and check-ins.
United Kingdom, HSE INDG73Risk assessment, with no written procedure named. No interval is set, and pre-agreed intervals of regular contact are one listed option. Phones, radios, email, alarm devices and supervisor visits.

British Columbia

The Occupational Health and Safety Regulation defines working alone or in isolation in section 4.20.1: working in circumstances where assistance would not be readily available to the worker. Before assigning a worker, the employer identifies the hazards and eliminates them, or minimizes the risk to the lowest level practicable with engineering controls, administrative controls or both (section 4.20.2).

Section 4.21 requires a written procedure for checking the worker's well-being. It must state the time interval between checks and what happens if the worker cannot be reached, including emergency rescue. A person is designated to make contact at the set intervals and record the results. A check at the end of the work shift is added to the regular ones.

The procedure is developed with the joint committee or the worker health and safety representative. The time intervals are developed with the worker assigned to work alone. A note to the section says high risk activities require shorter intervals. It calls visual or two-way voice contact the preferred method and accepts a one-way system that sends a call for help if the worker does not reset the device after a set interval.

The worker and the person assigned to check must be trained in the procedure (section 4.22). Section 4.23 requires a review at least annually, or sooner after a change that could harm the worker's well-being or a report that the procedure is not working. WorkSafeBC's working alone page repeats that lone workers must be able to get assistance if injured or in an emergency, and offers a 2012 handbook for small business.

Alberta

The Part 28 explanation guide to the Occupational Health and Safety Code 2009 applies when a worker is by themselves and assistance is not readily available in an emergency or injury. Awareness, willingness and timeliness are the three factors for judging whether assistance is readily available. Two or more workers of the same employer working together are not working alone.

The employer assesses the hazards and takes measures to eliminate or reduce them. The guide lists tree cutting among high hazard work. Section 8 of the OHS Regulation requires the hazard assessment report to be in writing and available to affected workers. A new assessment is needed when the circumstances change.

Section 394 calls for an effective communication system with two parts: a radio, phone or other electronic means, and regular contact by the employer or a designate at intervals appropriate to the nature of the hazard. Where electronic communication is not practicable, the employer visits the worker, or has the worker make contact at those intervals.

The companion publication WA002, revised August 2009, adds that the interval should follow the level of risk. At a site with minimal hazards, contact at arrival and departure can be enough. Where hazards are greater, the interval follows the likelihood of serious health consequences. It describes an acceptable system as one where the worker sends an OK signal at predetermined intervals.

United Kingdom

HSE leaflet INDG73, Protecting lone workers (March 2020, revision 4), is guidance and sets no check-in interval. It bases the level of supervision on the risk assessment: the higher the risk, the greater the supervision. Lone workers may need to be accompanied at first when they are new to a job, in training, doing a job with specific risks, or dealing with new situations.

The leaflet says an employer must put clear procedures in place for monitoring. These may include supervisors periodically visiting, pre-agreed intervals of regular contact by phone, radio or email, alarm devices operated manually or automatically, and a system to confirm the worker has returned to base or home. Technical solutions and emergency procedures are to be tested regularly.

Sources