ArbNation Join free

BS 5837 in outline: scope, edition and the documents it asks for

BS 5837:2012 is the British standard for trees in relation to design, demolition and construction, published 30 April 2012. BSI lists it as current and under review, and a revision draft went to public consultation in 2024.

Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.

BS 5837 is the document UK councils cite in their tree validation requirements. The clauses are not reproduced here. What follows is the publisher's description, the way councils quote the standard, and the Arboricultural Association's account of its history and its draft revision.

Scope and edition

BSI gives the full title as Trees in relation to design, demolition and construction. Recommendations. The edition is BS 5837:2012, published 30 April 2012 and prepared by Technical Committee B/213, Trees and tree work. The BSI Knowledge listing marks it Current, Under Review. BS 5837:2012 supersedes BS 5837:2005, which is withdrawn.

BSI describes the standard as recommendations on tree care, aimed at a harmonious and sustainable relationship between new construction or existing structures and the trees around them. It names arboriculturists, architects, builders, landscape architects, land managers, contractors and statutory undertakers as users. Leeds City Council and BSI both state that it applies whether or not planning permission is required.

BSI lists three principal changes from 2005: it reflects practice in planning for the management, protection and planting of trees near structures; it updates guidance on building regulations; and it recognises the part trees play in climate change adaptation.

Documents councils ask for

Councils turn the standard into validation requirements. Leeds asks for a tree survey, a tree constraints plan and an arboricultural impact assessment, all in line with the 2012 edition. It includes trees with an estimated stem diameter of 75 mm or more, on the site or overhanging it, and trees beyond the boundary within 12 times their stem diameter. Slough also requires a survey of trees over 75 mm in diameter, with an AIA, an AMS and a tree protection plan. Bassetlaw points to the standard for the survey, protection plan and method statement.

The standard's own Table B.1, reproduced by Leeds, sets the documents by stage:

Table B.1 as Leeds City Council prints it
StageMinimum detail
Pre-applicationTree survey, with a draft tree retention and removal plan as additional information
Planning applicationTree survey if there were no pre-application talks, a finalised retention and removal plan, retained trees and root protection areas on the layout, landscape design and an arboricultural impact assessment. Additional information: finished levels, a tree protection plan and method statement heads of terms
Reserved matters and planning conditionsUtility alignment, a dimensioned tree protection plan, a detailed method statement, a schedule of works to retained trees and detailed landscape design. Additional information: a site monitoring schedule, a management plan and remedial works

History and the revision

The Arboricultural Association (AA) account comes from a workshop hosted by the chair of the revision panel. It traces the standard back to 1980 as a code of practice. It became a guide in 1991 and has been Recommendations since 2005. The 2005 edition brought in the root protection area with a 12 times multiplier, tree constraints plans, arboricultural implications assessments and method statements. The 2012 edition changed the title to cover design, demolition and construction, changed categories from R, A, B, C to U, A, B, C and brought in the arboricultural impact assessment.

The AA says the standard is in practice a code of practice even though its title says Recommendations, and that standards sit below the law. A draft for public consultation was published on 16 August 2024 and consultation ran to 16 October 2024. At that point the panel expected a revised standard in April 2025. The BSI listing still shows the 2012 edition as current.

Changes proposed in the draft, as the workshop reports them, include:

  • measuring stem diameter at 1.3 m instead of 1.5 m above ground
  • a Category V for veteran trees and ancient woodland, and a Category X in place of U
  • a minimum root protection area radius of 2 m
  • larger multipliers for veteran and mature Category A trees

For the root protection rule as councils print it, see the guide to root protection areas in UK practice. The method statement has its own guide.

Sources