California Cal/OSHA tree trimming: Title 8 sections 3420 to 3427 and the heat standard
California's tree work rules sit in Article 12 of the General Industry Safety Orders, sections 3420 to 3428. Section 3395 on outdoor heat applies alongside them.
Checked against the sources at the bottom of this page on October 16, 2026. Rules, fees and pay change: the source has the last word.
This page reports what the official source says. It is not legal advice: ask the office named here. California Code of Regulations Title 8, Article 12, covers tree work, maintenance and removal. The Department of Industrial Relations publishes the text. It is not training and does not teach the work.
Scope and definitions: section 3420
Section 3420 (a) says the standard applies to work performed and equipment used in tree and ornamental palm maintenance and removal. Two notes sit under it. Fall protection in date palm operations and ladders attached to date palms are covered in sections 3458 and 3458.1. Line clearance tree trimming near high voltage energized conductors falls under Article 38 of the High-Voltage Electrical Safety Orders.
The section defines a qualified tree worker as an employee who, through related training and on-the-job experience, has shown familiarity with the techniques and hazards of tree maintenance, removal and the equipment used. It also defines a drop zone as the area under employees aloft where dropped or lowered objects could strike someone. Proximity means within 10 feet of energized overhead conductors rated 50 kilovolts phase to phase or less, with 4/10 inch added for each kilovolt above 50. The definitions cover three notches: conventional, Humboldt and open-faced.
General requirements: section 3421
| Subsection | What section 3421 requires |
|---|---|
| (a), (b) | An Injury and Illness Prevention Program under section 3203. Each work location is under the direction of a qualified tree worker |
| (c), (d), (e) | Training on job hazards, equipment and protective equipment, poisonous plants and harmful animals, and electrical hazards. The employer documents it. Refresher training follows a rule violation, an accident or near miss, or a new unfamiliar assignment |
| (f) | A job briefing by a qualified tree worker before each work assignment |
| (h) | Equipment and safety devices inspected before daily use by a qualified tree worker |
| (l) | Rescue procedures and emergency response training, with aerial rescue training for employees whose jobs may require it |
| (m) | First aid and CPR training. At a work location with two or more employees, at least two trained persons are available. New employees are trained within 90 days of hiring |
Subsection (i) adds potable water under section 3363, and subsection (j) adds traffic control under the Construction Safety Orders where traffic may endanger employees.
Ropes and climbing equipment: section 3422
Under section 3422, all load bearing components of a climbing system have a minimum tensile strength of 5,000 pounds. Climbing lines are made from synthetic fiber with a minimum rated tensile strength of 5,000 pounds (22.24 kN) and a minimum diameter of 1/2 inch (12.7 mm). Maximum working elongation is seven percent at a load of 500 pounds. A line not less than 7/16 inch (11 mm) in diameter is allowed if it meets the same strength and elongation figures, the maker identifies it as suitable for tree climbing, and the employee is trained in its use.
The section bars splicing a climbing line to repair it. Ropes, climbing equipment, tackle blocks and pulleys are inspected for damage, cuts, abrasions and deterioration before each use that involves re-rigging or moving the climbing system. Defective equipment is removed from service at once. Climbing lines are never left in trees unattended when no qualified tree worker is at the job site.
Safe work procedures: section 3427
Section 3427 (a) requires a qualified tree worker to inspect the tree, including the root collar, before climbing, and identifies electrical conductors in the work area. Employees working aloft wear a tree worker's saddle and have at least two means of being secured. They stay tied in or secured from the start of the ascent until they are back on the ground. A qualified tree worker may be hoisted by crane only when a tree cannot be safely accessed by climbing or aerial devices. The saddle is secured to a crane hook closed with a positive locking device. The section lists ten criteria, including a 5,000 pound minimum breaking strength for all climbing equipment, lines and rigging.
Section 3427 (b) covers pruning, trimming and removal. A verbal or visual communication method is set at the job briefing. A drop zone is set before pruning or removal starts. Employees not involved stay out of it until a qualified tree worker says it is safe. When an employee is more than 12 feet up, a second employee is present to give immediate assistance.
Section 3427 (c) covers felling. It requires a planned escape route for all workers. It requires a notch and back cut to form a hinge on trees over 5 inches in diameter, with a notch depth not over one third of the diameter. An audible warning is given just before the tree or trunk falls.
Heat standard: section 3395
Section 3395, the Maria Isabel Vasquez Jimenez heat illness standard, applies to all outdoor places of employment. Landscaping is one of the industries subject to every provision. The section defines landscaping to include landscape care and maintenance and installing trees, shrubs, plants, lawns or gardens. Shade is required when the temperature exceeds 80 degrees Fahrenheit. High-heat procedures apply at or above 95 degrees Fahrenheit. Where water is not plumbed, enough is on hand at the start of the shift for one quart per employee per hour. The full table is in heat rules in California.
Sources
- California Department of Industrial Relations, 8 CCR section 3420 Scope and Definition, read October 16, 2026
- California Department of Industrial Relations, 8 CCR section 3421 General, read October 16, 2026
- California Department of Industrial Relations, 8 CCR section 3422 Ropes and Tree Worker Climbing Equipment, read October 16, 2026
- California Department of Industrial Relations, 8 CCR section 3427 Safe Work Procedures, read October 16, 2026
- California Department of Industrial Relations, 8 CCR section 3395 Heat Illness Prevention in Outdoor Places of Employment, read October 16, 2026