ArbNation Join free

Chainsaw lanyards and saw tethers: what the codes say about tying off a saw aloft

California sets a 15-pound line for supporting a saw in a tree by a separate line or tool lanyard. HSE's top-handled saw leaflet allows a rated or tear-away lanyard and names the case where it is not attached.

Checked against the sources at the bottom of this page on October 19, 2026. Rules, fees and pay change: the source has the last word.

The named codes and training bodies are described here as published. It is not training and does not teach the work. The wording comes from two California safety orders in Title 8 of the Code of Regulations and an HSE leaflet on top-handled chainsaws.

The wording at a glance

DocumentProvisionWording
California, 8 CCR 3425(a)(3)Support for a saw in a treeA power saw weighing more than 15 pounds (service weight) used in trees is supported by a separate line or tool lanyard
California, 8 CCR 3425(a)(10)Second point of attachmentA second point of attachment, such as a work-positioning lanyard or double-crotched rope, when operating a chain saw in a tree
California, 8 CCR 3427(a)(2)Securing the worker aloftA tree workers' saddle and at least two means of being secured, such as a climbing line and a work positioning lanyard
HSE, AFAG308Attaching the sawThe saw may be attached to the climber's harness by a suitably rated or tear-away lanyard
HSE, AFAG308Machine conditionA means for attaching a suitably rated or tear-away lanyard to the rear of the saw

California section 3425 on power saws

Title 8 section 3425, Portable Power Hand Tools, has a power saw paragraph at (a). Subparagraph (3) puts saws over fifteen pounds (service weight) used in trees on a separate line or tool lanyard.

Two exceptions follow in the same sentence. One is work from an aerial-lift device. The other is topping or removing operations where no supporting limb is available.

Subparagraph (10) covers the worker. Tree workers use a second point of attachment, such as a work-positioning lanyard or double-crotched rope, when operating a chain saw in a tree. The exception applies where the employer demonstrates that a greater hazard is posed by using a second point of attachment in that particular situation.

Subparagraph (6) bars a power saw from running while an employee carries it up into a tree. Subparagraph (a)(3) came in with an amendment filed July 30, 2020, operative October 1, 2020.

California section 3427 on the worker

Section 3427, Safe Work Procedures, is the companion rule. Under paragraph (a)(2), employees working aloft wear a tree workers' saddle and have at least two means of being secured, with a climbing line and a work positioning lanyard given as the example.

Paragraph (a)(3)(A) adds that employees are tied in or secured while ascending the tree and remain so until the work is completed and they have returned to the ground.

Paragraph (e)(2) deals with tools for structural support and lightning protection systems. They are carried in a bag or on a belt made for holding such tools, or attached to a tool lanyard.

HSE on top-handled saws

HSE's leaflet AFAG308, Top-handled chainsaws, was first published in December 2008 and revised in April 2013. Its list of conditions for using a saw includes a means for attaching a suitably rated or tear-away lanyard to the rear of the saw.

In the section on using the saw, the leaflet states that the chainsaw may be attached to the climber's harness by a suitably rated or tear-away lanyard. The same sentence adds a limit: it is not attached to the climber where there is a risk of the chainsaw being trapped or taken with a severed section.

The leaflet is for trained and competent climbers on off-ground work, and it sits alongside the maker's handbook and a risk assessment.

Where the wording differs

California ties the line or lanyard to a weight, fifteen pounds, and lists two exceptions. HSE names no weight and describes the lanyard as rated or tear-away. Only HSE names the trapped saw as the reason for not attaching it.

The New Zealand codes are covered on the page on tool lanyards and tear-away tethers.

Sources